Home

Electrical networks

Natural sciences
Physics
Electromagnetism
Electrical networks

About
Privacy
Disclaimer

Graph Chatbot

Related publications (31)

Emulating Multimemristive Behavior of Silicon Nanowire-Based Biosensors by Using CMOS-Based Implementations

Sandro Carrara, Junrui Chen, Kapil Bhardwaj

The research presented in this article draws inspiration from previous efforts aimed at replicating the functions of various solid-state memristors using a variety of materials. The memristor circuit emulator serves as a cost-effective tool for circuit des ...

Ieee-Inst Electrical Electronics Engineers Inc2024

A Two-Wired High Input Impedance and High CMRR Active Electrode Insensitive to Component Mismatch

Alexandre Schmid, Mehdi Saberi

This article proposes a new two-wired amplifying active electrode (AE), presenting a high input impedance and a high common-mode rejection ratio (CMRR). In the proposed structure, the input impedance and the CMRR of the system are considerably increased by ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Performance Comparison of Cables With Partial Transposition

Pierluigi Bruzzone, Kamil Sedlák, Chiara Frittitta, Federica Demattè

The need of full transposition of the current carrying elements (strands) in large cables is frequently retained as top design criterion for conductors operating in pulsed mode. However, when the transposition error, i.e., the inductance difference among t ...

IEEE Institute of Electrical and Electronics Engineers2024

On the use of Cramér-Rao Lower Bound for least-variance circuit parameters identification of Li-ion cells

Mario Paolone, Vladimir Sovljanski

Electrochemical Impedance Spectroscopy (EIS) and Equivalent Circuit Models (ECMs) are widely used to characterize the impedance and estimate parameters of electrochemical systems such as batteries. We use a generic ECM with ten parameters grouped to model ...

2024

Modeling and optimization of PCB coils for inductive power transfer systems

Xiaotong Du

The auxiliary power supply for medium voltage converters requires high insulation capability between the source and the load. Inductive power transfer technology, with an air gap between the primary and secondary coil, offers such high insulation capabilit ...

EPFL2024

Pseudo-Three-Dimensional Analytical Model of Linear Induction Motors for High-Speed Applications

André Hodder, Mario Paolone, Lucien André Félicien Pierrejean, Simone Rametti

Literature on linear induction motors (LIMs) has proposed several approaches to model the behavior of such devices for different applications. In terms of accuracy and fidelity, field analysis-based models are the most relevant. Closed-form or numerical so ...

2024

Pyroresistive response of percolating conductive polymer composites

Claudio Grimaldi

The pyroresistive response of conductive polymer composites (CPCs) has attracted much interest because of its potential applications in many electronic devices requiring a significant responsiveness to changes in external physical parameters such as temper ...

Amer Physical Soc2024

An Ultralow-Power Triaxial MEMS Accelerometer With High-Voltage Biasing and Electrostatic Mismatch Compensation

Yimai Peng, Li Xu, Kyojin Choo

This article presents a triaxial micro electromechani-cal system (MEMS) capacitive accelerometer using a high-voltage biasing technique to achieve high resolution with ultralow power. The accelerometer system generates a differential pair of high voltages ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Unified Harmonic Power-Flow and Stability Analysis of Power Grids with Converter-Interfaced Distributed Energy Resources

Johanna Kristin Maria Becker

Modern power distribution systems are experiencing a large-scale integration of Converter-Interfaced Distributed Energy Resources (CIDERs). Their presence complicates the analysis and mitigation of harmonics, whose creation and propagation may be amplified ...

EPFL2024

Antiferromagnetic droplet soliton driven by spin current

Mohammad Hamdi

We demonstrate that a spin current flowing through a nanocontact into a uniaxial antiferromagnet with first- and second-order anisotropy can excite a self-localized dynamic magnetic soliton, known as a spin-wave droplet in ferromagnets. The droplet nucleat ...

AIP American Institute of Physics2024

Ripple Voltage and Loss Reduction of Single-Phase ISOP SST by Eliminating the Second Harmonic Current in LLC Converters

Drazen Dujic, Tianyu Wei, Andrea Cervone

In two-stage solid-state transformers with input-series output-parallel structure, the LLC converter operating at a fixed switching frequency is a common choice for the isolated DC/DC conversion stage because it can provide a high efficiency and a fixed vo ...

2024

Power Aware Placement of On-Chip Voltage Regulators

Rassul Bairamkulov

In traditional power delivery networks, the on-chip supply voltage is provided by board-level converters. Due to the significant distance between the converter and the load, variations in the load current are not effectively managed, producing a significan ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Sensitivity Analysis of the Lumped Thermal Model of the EU 170 GHz Gyrotron Magnetron Injection Gun

Jean-Philippe Hogge, Francisco Sanchez

The ITER Electron Cyclotron Resonance Heating and Current Drive (ECRH&CD) system relies on 1 MW 170 GHz Gyrotrons to provide the mm-wave power needed for plasma heating, current drive, and magneto-hydrodynamic control. The design and modeling of the contro ...

Ieee-Inst Electrical Electronics Engineers Inc2024

DC Power Distribution Networks with Direct Current Transformers

Renan Pillon Barcelos

The shift towards DC power distribution networks, enabled by power electronics technologies, is changing the nature of electrical power systems. Nowadays, DC power distribution networks can effectively support the high penetration of distributed energy res ...

EPFL2024

Impact of beam-coupling impedance on the Schottky spectrum of bunched beam

Tatiana Pieloni, Nicolas Frank Mounet, Christophe Emmanuel R. Lannoy

The Schottky monitors of the Large Hadron Collider (LHC) can be used for non-invasive beam diagnostics to estimate various bunch characteristics, such as tune, chromaticity, bunch profile or synchrotron frequency distribution. However, collective effects, ...

Iop Publishing Ltd2024

Static and Dynamic Voltage Balancing for an IGCT-Based Resonant DC Transformer

Drazen Dujic, Nikolina Djekanovic, Renan Pillon Barcelos

This paper focuses on the operational characteristics of a medium voltage resonant DC transformer based on a split capacitor IGCT 3L-NPC leg. The study delves into both the dynamic and static balancing aspects of the 3L-NPC when operating in a two-level, 5 ...

2024

Light Emission and Conductance Fluctuations in Electrically Driven and Plasmonically Enhanced Molecular Junctions

Christophe Marcel Georges Galland, Sakthi Priya Amirtharaj, Wen Chen, Konstantin Malchow

Electrically connected and plasmonically enhanced molecular junctions combine the optical functionalities of high field confinement and enhancement (cavity function), and of high radiative efficiency (antenna function) with the electrical functionalities o ...

Amer Chemical Soc2024

Benign termination of runaway electron beams on ASDEX Upgrade and TCV

Basil Duval, Stefano Coda, Joan Decker, Umar Sheikh, Jean Arthur Cazabonne, Claudia Colandrea, Luke Simons, Gergely Papp, Bernhard Sieglin

This paper discusses the development of a benign termination scenario for runaway electron (RE) beams on ASDEX Upgrade and TCV. A systematic study revealed that a low electron density (n e) companion plasma was required to achieve a large MHD instability, ...

Iop Publishing Ltd2024

All-Dielectric Nanophotonic via Glass Fluid Instabilities

Pierre-Luc Eloi Piveteau

In this thesis work, we propose to exploit an innovative micro/nano-fabrication process, based on controlled fluid instabilities of a thin viscous film of chalcogenide glass. Amorphous selenium and arsenic triselenide were used in this thesis work, and com ...

EPFL2024

Ultrahigh-quality-factor micro- and nanomechanical resonators using dissipation dilution

Tobias Kippenberg, Nils Johan Engelsen, Alberto Beccari

Mechanical resonators are widely used in sensors, transducers and optomechanical systems, where mechanical dissipation sets the ultimate limit to performance. Over the past 15 years, the quality factors in strained mechanical resonators have increased by f ...

Nature Portfolio2024

Page 1 of 2