Home

Propulsion

Applied sciences
Mechanical engineering
Aerospace engineering
Propulsion

About
Privacy
Disclaimer

Graph Chatbot

Related publications (29)

Smart Acoustic Lining for UHBR Technologies Engine Part 1: Design of an Electroacoustic Liner and Experimental Characterization Under Flow in Rectangular Cross-Section Ducts

The new generation of Ultra-High-By-Pass-Ratio (UHBR) turbofan engine while considerably reducing fuel consumption, threatens higher noise levels at low frequencies because of its larger diameter, lower number of blades and rotational speed. This is accomp ...

American Institute of Aeronautics and Astronautics2024

The Advection Boundary Law in presence of mean-flow and spinning modes

In the attempt to reduce fuel consumption, a new generation of Ultra-High-By-Pass-Ratio (UHBR) turbofans have been introduced in the aeronautic industry which are structurally noisier especially at lower frequencies, because of their larger diameter, lower ...

SPIE2024

Domain adaptation via alignment of operation profile for Remaining Useful Lifetime prediction

Ismail Nejjar, Olga Fink, Mengjie Zhao

Effective Prognostics and Health Management (PHM) relies on accurate prediction of the Remaining Useful Life (RUL). Data-driven RUL prediction techniques rely heavily on the representativeness of the available time-to-failure trajectories. Therefore, these ...

2024

Robust tunable acoustic impedance control on electroacoustic resonators for aircraft noise reduction

Maxime Volery

Air traffic noise emissions are responsible for a significant part of the overall environmental noise, especially in the vicinity of airports. Exposure to environmental noise is known to negatively impact health and to be associated with cardiovascular dis ...

EPFL2023

Uncertainty quantification in machine learning for engineering design and health prognostics: A tutorial

Olga Fink, Luca Biggio

On top of machine learning (ML) models, uncertainty quantification (UQ) functions as an essential layer of safety assurance that could lead to more principled decision making by enabling sound risk assessment and management. The safety and reliability impr ...

2023

Indication of 310-Helix Structure in Gas-Phase Neutral Pentaalanine

Vasyl Yatsyna

We investigate the gas-phase structure of the neutral pentaalanine peptide. The IR spectrum in the 340-1820 cm-1 frequency range is obtained by employing supersonic jet cooling, infrared multiphoton dissociation, and vacuum-ultraviolet action spectroscopy. ...

AMER CHEMICAL SOC2023

An Integrated Approach to Designing Robust Turbocompressors on Gas Bearings Through Surrogate Modeling and Constrained Multi-Objective Optimization

Jürg Alexander Schiffmann, Cyril Picard, Soheyl Massoudi

Designing turbocompressors is a complex and challenging task, as it involves balancing conflicting objectives such as efficiency, stability, and robustness against manufacturing deviations. This paper proposes an integrated design methodology for turbocomp ...

ASME Amer Soc Mechanical Engineers2023

Search for medium effects using jets from bottom quarks in PbPb collisions at √sNN = 5.02 TeV

Rakesh Chawla, Andrea Rizzi, Matthias Finger, Federica Legger, Matteo Galli, Sun Hee Kim, Jian Zhao, João Miguel das Neves Duarte, Tagir Aushev, Hua Zhang, Alexis Kalogeropoulos, Yixing Chen, Tian Cheng, Ioannis Papadopoulos, Gabriele Grosso, Valérie Scheurer, Meng Xiao, Qian Wang, Michele Bianco, Varun Sharma, Joao Varela, Sourav Sen, Ashish Sharma, Seungkyu Ha, David Vannerom, Csaba Hajdu, Sanjeev Kumar, Sebastiana Gianì, Kun Shi, Abhisek Datta, Miao Hu, Siyuan Wang, Muhammad Waqas, Anton Petrov, Jian Wang, Yi Zhang, Lei Zhang, Muhammad Ansar Iqbal, Yong Yang, Xin Sun, Muhammad Ahmad, Donghyun Kim, , , , , , , , , , , , , , , , , , , , , , , , , , , , ,

The influence of splitter blades and meridional profiles on the performance of small-scale turbopumps for ORC applications; analysis, neural network modeling and optimization

Jürg Alexander Schiffmann, Sajjad Zakeralhoseini

This work presents the influence of splitters on the performance of small-scale turbopumps for organic Rankine cycle applications numerically. Different design parameters, such as impeller diameter at the outlet, number of blades, blade angle at the traili ...

2023

Real-time model calibration with deep reinforcement learning

Olga Fink

The real-time, and accurate inference of model parameters is of great importance in many scientific and engineering disciplines that use computational models (such as a digital twin) for the analysis and prediction of complex physical processes. However, f ...

2022

Locomotion of Sensor‐Integrated Soft Robotic Devices Inside Sub‐Millimeter Arteries with Impaired Flow Conditions

Lucio Feo Pancaldi-Giubbini, Lorenzo Francesco John Noseda, Diego Ghezzi, Mahmut Selman Sakar, Adele Fanelli, Amit Yedidia Dolev

One of the grand challenges in interventional cardiology and neuroradiology is to minimize the operation time and risk of damage during catheterization. These two factors drastically increase if the target location resides in small and tortuous vessels. Fl ...

Wiley2022

Plunging Circular Jets: Experimental Characterization of Dynamic Pressures Near the Stagnation Zone

Giovanni De Cesare, Pedro Filipe De Almeida Manso, Gregoire Aurelien Marie Jamet

Spillways are a requirement for dams’ safety, mainly preventing overtopping during floods. A common spillway solution involves plunging jets, which dissipate a considerable flow energy in the plunge pool. Energy dissipation has to occur in a controlled man ...

2022

Ion temperature spectroscopic measurements in high rotation discharges by means of X-ray diagnostic at JET

Henri Weisen

Measurement of the X-ray spectra of the He-like Ni ions (Ni26+) and their dielectronic satellites (Ni25+, Ni24+, and Ni23+) plays a crucial role in determination of electronic and ion temperature of plasma in the JET device. Because n >= 3 satellites of Ni ...

2022

A novel control strategy with an anode variable geometry ejector for a SOFC-GT hybrid system

Jinzhi Lu, Jinwei Chen

A novel control strategy was developed with an anode variable geometry ejector for a solid oxide fuel cell-gas turbine (SOFC-GT) system. The anode inlet temperature was controlled by combining two modes to achieve a greater controllable range: anode variab ...

PERGAMON-ELSEVIER SCIENCE LTD2022

Degradation study on molecules released from laser-based jet injector

Christophe Moser, Jan Krizek, Barbora Lavickova

Development of needle-free methods to administer injectable therapeutics has been researched for a few decades. We focused our attention on a laser-based jet injection technique where the liquid-jet actuation mechanism is based on optical cavitation. This ...

2021

Experimental investigation of sequential narrow impingement channels for turbine cooling

Peter Ott, Michele Gaffuri

Sequentially stacked impingement channels allow for a more effective use of the cooling fluid and can limit the heat transfer reduction due to the crossflow when the number of jets increases. In this paper, sequential impingement channels are experimentall ...

2021

Ion cyclotron resonance heating with shifted separatrix

Jonathan Graves, Hamish William Patten

Ion cyclotron resonance heating, which we refer to as ICRH-SS, with the quasilinear (QL) separatrix (i.e., the separatrix in the space of QL routes of ion acceleration) located in the region of passing particles is studied. The aim of ICRH-SS is to minimiz ...

IOP Publishing Ltd2021

Real-time optimization of load sharing for gas compressors in the presence of uncertainty

Dominique Bonvin, Alejandro Gabriel Marchetti, Timm Faulwasser, Predrag Milosavljevic

This paper investigates the problem of load-sharing optimization of gas compressors in the presence of uncertainty. The objective is to operate a set of compressor units in an energy-efficient way, while at the same time meeting a varying load demand. The ...

ELSEVIER SCI LTD2020

Scale limitations of gas bearing supported turbocompressors for vapor compression cycles

Jürg Alexander Schiffmann

An analysis of single-stage centrifugal compressors supported on dynamic, gas lubricated bearings for driving vapor compression cycles suggests that the maximum feasible compressor power is limited, primarily by the bearing load capacity, in the range from ...

2020

Theoretical and Experimental Investigation of a 34 Watt Radial-Inflow Steam Turbine with Partial-Admission

Jürg Alexander Schiffmann, Jan Van Herle, Patrick Hubert Wagner

A micro steam turbine with a tip diameter of 15 mm was designed and experimentally characterized. At the nominal mass flow rate and total-to-total pressure ratio of 2.3 kg/h and 2, respectively, the turbine yields a power of 34 W and a total-to-static isen ...

2021

Page 1 of 2

The first study of the shapes of jets arising from bottom (b) quarks in heavy ion collisions is presented. Jet shapes are studied using charged hadron constituents as a function of their radial distance from the jet axis. Lead-lead (PbPb) collision data at ...

Elsevier2023