Home

Concept

Nucleate boiling

Applied sciences
Mechanical engineering
Thermal engineering
Heat transfer

About
Privacy
Disclaimer

Graph Chatbot

Related publications (27)

Extension of GeN-Foam to departure from nucleate boiling prediction and validation against the OECD/NRC PSBT benchmark

Alessandro Scolaro, Carlo Fiorina, Yuhang Niu, Hao Qin

The prediction of departure from nucleate boiling (DNB) has always been a crucial aspect of thermal-hydraulic codes for the analysis of Light Water Reactors. In this paper, GeN-Foam, a multi-physics code developed based on OpenFOAM, has been enhanced to in ...

Elsevier Science Sa2023

Extension of GeN-Foam to modeling of boiling water and validation against the OECD/NRC PSBT benchmark

Carlo Fiorina, Stefan Radman, Ran Zhang, Hao Qin

The OpenFOAM-based GeN-Foam solver has recently been extended to allow simulating water boiling based on a porous-medium approach. This paper describes such extension and preliminarily validates it based on the OECD/NRC PSBT benchmark. Three benchmark exer ...

ELSEVIER SCIENCE SA2023

Flow Boiling of Carbon Dioxide at Different Channel Orientations for the Thermal Management of Future Detector Technologies at the High-Luminosity Large Hadron Collider at CERN

David Schmid

The global warming potential (GWP) of working fluids in thermodynamic cycles and their environmental impact have been gaining considerable attention within the recent years. The global objectives on climate protection are becoming increasingly ambitious, w ...

EPFL2022

Simulation and experimental validation of pulsating heat pipes

John Richard Thome, Jackson Braz Marcinichen, Philippe Aubin, Filippo Cataldo

The one-dimensional transient numerical code of JJ Cooling Innovation has been significantly improved to simulate the thermal/hydraulic performance of pulsating heat pipes (PHPs). Using a mechanistic approach, the liquid slug and vapor plug flows and their ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Fundamental study on microlayer dynamics in nucleate boiling

Lubomír Bures

Dynamics of nucleate boiling are strongly affected by the formation and behaviour of the microlayer, a layer of liquid underneath growing bubbles. As a result of its minute thickness, very high heat fluxes occur within the microlayer and its evaporation co ...

EPFL2021

Flow boiling heat transfer and two-phase flow phenomena of CO2 in macro-and micro-channel evaporators: Fundamentals, applications and engineering design

John Richard Thome

The paper presents a comprehensive review of fundamentals and engineering applications of CO2 flow boiling heat transfer, flow patterns and two-phase pressure drops in macro- and micro-channel evaporators. First, distinctions of macro- and micro-channels a ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Gravity-Independent Oscillate Boiling

Mohamed Farhat, Outi Supponen

Heat transfer in nucleate boiling relies on the detachment and rise of the boiling bubble, in which gravity plays the dominant role. Previous studies showed that in the absence of gravity, the bubble fails to rise, causing the dryout of the heater and sign ...

SPRINGER2019

Fundamental Issues, Technology Development, and Challenges of Boiling Heat Transfer, Critical Heat Flux, and Two-Phase Flow Phenomena with Nanofluids

John Richard Thome

This paper presents a comprehensive and critical review of studies on nucleate pool boiling heat transfer, flow boiling heat transfer, critical heat flux (CHF), and two-phase flow phenomena with nanofluids. First, general analysis of the available studies ...

TAYLOR & FRANCIS INC2019

Numerical Simulations of Pulsating Heat Pipes, Part 1: Modeling

John Richard Thome, Jackson Braz Marcinichen, Philippe Aubin, Filippo Cataldo, Brian Paul D'Entremont, Raffaele Luca Amalfi

The pulsating nature of a closed loop pulsating heat pipe (CLPHP) makes the prediction of its thermal-hydraulic performance extremely challenging. Unfortunately, the design of CLPHPs is still quite an empirical process, requiring testing of many prototypes ...

IEEE2019

Optimum ratio of hydrophobic to hydrophilic areas of biphilic surfaces in thermal fluid systems involving boiling

Luis Guillermo Villanueva Torrijo, Tom Larsen, Ahmad Reza Motezakker

Pool boiling has a high heat removal capability and is considered as one of the most effective cooling methods due to utilization of latent heat of vaporization. Surface wettability plays a key role in boiling heat transfer since it controls the contact li ...

2019

Improving surface heat flux estimation for a large lake through model optimization and two-point calibration: The case of Lake Geneva

David Andrew Barry, Ulrich Lemmin, Damien Bouffard, Andrea Cimatoribus, Abolfazl Irani Rahaghi

Net Surface Heat Flux (SurHF) was estimated from 2008 to 2014 for Lake Geneva (Switzerland/France), using long‐term temperature depth profiles at two locations, hourly maps of reanalysis meteorological data from a numerical weather model and lake surface w ...

Association for the Sciences of Limnology and Oceanography (ASLO)2018

Hydration mediated interfacial transitions on mixed hydrophobic/hydrophilic nanodroplet interfaces

Sylvie Roke, Halil Ibrahim Okur, Nikolay Smolentsev, Rüdiger Scheu, Filip Kovacik

Interfacial phase transitions are of fundamental importance for climate, industry, and biological processes. In this work, we observe a hydration mediated surface transition in supercooled oil nanodroplets in aqueous solutions using second harmonic and sum ...

2018

Insulation effect on thermal stability of Coated Conductors wires in liquid nitrogen

Bertrand Dutoit, Bertrand Dutoit

Superconducting wires are not perfectly homogeneous in term of critical current as well as stabilization. In resistive fault current limiter applications this could lead to hot spots if the fault current is only slightly above the nominal current of the de ...

Iop Publishing Ltd2017

Flow Boiling Heat Transfer and Pressure Drops of R1234ze(E) in a Silicon Micro-pin Fin Evaporator

John Richard Thome, Mirco Magnini, Chiara Falsetti

The development of newer and more efficient cooling techniques to sustain the increasing power density of high-performance computing systems is becoming one of the major challenges in the development of microelectronics. In this framework, two-phase coolin ...

Asme2017

An updated three-zone heat transfer model for slug flow boiling in microchannels

John Richard Thome, Mirco Magnini

This work proposes a novel physics-based model for the fluid mechanics and heat transfer associated with slug flow boiling in horizontal circular microchannels to update the widely used three-zone model of Thome et al. (2004). The heat transfer model has a ...

Pergamon-Elsevier Science Ltd2017

Critical heat flux: Performance of R1234yf, R1234ze and R134a in an aluminum multi-minichannel heat sink at high saturation temperatures

John Richard Thome

In this paper, new saturated critical heat flux (CHF) values at medium-to-high saturation temperatures are presented for an aluminum multi-minichannel test section. Among the possible working fluids, R134a and the low GWP refrigerants R1234yf and R1234ze h ...

Elsevier France-Editions Scientifiques Medicales Elsevier2016

Flow boiling and frictional pressure gradients in plate heat exchangers. Part 2: Comparison of literature methods to database and new prediction methods

John Richard Thome, Raffaele Luca Amalfi, Farzad Vakili Farahani

In the second part of this study a sensitivity analysis on the prediction methods is performed to consider the effect of plate geometry on thermal hydraulic performance and an extensive comparison of all the two-phase pressure drop and flow boiling heat tr ...

Elsevier Sci Ltd2016

Local measurements and a new flow pattern based model for subcooled and saturated flow boiling heat transfer in multi-microchannel evaporators

John Richard Thome, Houxue Huang

A comprehensive experimental campaign has been conducted to measure the local heat transfer coefficients during flow boiling of refrigerants in multi-microchannel evaporators. Two additional refrigerants (R245fa and R236fa) were tested in two silicon evapo ...

Pergamon-Elsevier Science Ltd2016

Experimental investigation on flow boiling pressure drop and heat transfer of R1233zd(E) in a multi-microchannel evaporator

John Richard Thome, Navid Borhani, Houxue Huang

An experimental study on flow boiling pressure drop and heat transfer of a new environmentally friendly refrigerant R1233zd(E), in a parallel multi-microchannel evaporator was carried out. The silicon microchannels evaporator was 10 mm long and 10 mm wide, ...

Pergamon-Elsevier Science Ltd2016

Unified Modeling Suite for Two-Phase Flow, Convective Boiling, and Condensation in Macro- and Microchannels

John Richard Thome, Andrea Cioncolini

This paper focuses on the unified modeling suite for annular flow that the authors have developed and continue to develop. The annular flow suite currently includes models to predict the void fraction, the entrained liquid fraction, and the wall shear stre ...

Taylor & Francis Inc2016

Page 1 of 2