Concept

Condenser (heat transfer)

Related publications (31)

Beam radiation penetration in particle b e ds for heat transfer modeling of a centrifugal solar particle receiver

This article describes a study of beam radiation striking particle beds of randomly packed, spherical par-ticles. The current study is focused on concentrating solar power receivers which use solid particles as a heat transfer medium, but results are appli ...

PERGAMON-ELSEVIER SCIENCE LTD2023

Progress in Unraveling Atmospheric New Particle Formation and Growth Across the Arctic

Julia Schmale, Andrea Baccarini

New particle formation (NPF) and growth can be an important source of cloud condensation nuclei for the Arctic atmosphere, where cloud formation is sensitive to their availability. Low-level clouds influence the Arctic energy budget, and likely contribute ...

2021

Simulation and experimental validation of pulsating heat pipes

John Richard Thome, Jackson Braz Marcinichen, Philippe Aubin, Filippo Cataldo

The one-dimensional transient numerical code of JJ Cooling Innovation has been significantly improved to simulate the thermal/hydraulic performance of pulsating heat pipes (PHPs). Using a mechanistic approach, the liquid slug and vapor plug flows and their ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Compact Thermosyphon Cooling System For High Heat Flux Servers: Validation Of Thermosyphon Simulation Code Considering New Test Data

John Richard Thome, Jackson Braz Marcinichen, Filippo Cataldo, Raffaele Luca Amalfi

Passive, gravity-driven thermosyphons represent a stepchange in technology towards the goal of greatly reducing PUE (Power Usage Effectiveness) of datacenters by replacing energy hungry fans of air-cooling approach with a highly-reliable solution able to d ...

AMER SOC MECHANICAL ENGINEERS2021

Small-scale organic Rankine cycle turbo-generator for waste heat recovery on truck engine

Kévin Rosset

Truck engine waste heat recovery (WHR) systems have been investigated for many years. Among them, organic Rankine cycle (ORC) systems show the highest potential, but still lack efficient small-scale expansion devices, in practice. Proposed expanders are of ...

EPFL2020

Scale limitations of gas bearing supported turbocompressors for vapor compression cycles

Jürg Alexander Schiffmann

An analysis of single-stage centrifugal compressors supported on dynamic, gas lubricated bearings for driving vapor compression cycles suggests that the maximum feasible compressor power is limited, primarily by the bearing load capacity, in the range from ...

2020

Embedded Microchannel Cooling for High Power-Density GaN-on-Si Power Integrated Circuits

Elison de Nazareth Matioli, Remco Franciscus Peter van Erp, Luca Nela, Georgios Kampitsis, Reza Soleiman Zadeh Ardebili

In this work, we demonstrate a new thermal management approach for direct cooling of GaN-on-Si power integrated circuits (ICs), in which the Si substrate functions as a microfluidic heat sink, turning Si into a cost-effective, high thermal performance subs ...

IEEE2020

Thermochromic solar absorber coatings with elevated transition temperature

Anna Krammer

Due to their simple design and operation, solar thermal collectors for domestic hot water gener-ation and space heating are one of the most common solar energy harvesting systems in use today. Dur-ing cold periods all the absorbed energy is useful. During ...

EPFL2020

Shape optimization of segmental porous baffles for enhanced thermo-hydraulic performance of shell-and-tube heat exchanger

Hossein Pourrahmani

This study presents the development and evaluation of a novel shell-and-tube heat exchanger (STHX) design with segmental porous baffles. Computational fluid dynamics (CFD) in combination with machine learning tools are utilized to investigate the thermo-hy ...

PERGAMON-ELSEVIER SCIENCE LTD2020

Experimental Characterization of Different Condenser Technologies in a Passive Two-Phase Cooling System for Thermal Management of Electronics

John Richard Thome, Jackson Braz Marcinichen, Chiara Falsetti, Raffaele Luca Amalfi

Passive two-phase, micro-channel cooling for thermal management of electronics represents an efficient and viable solution to augment conventional air-cooling systems with the potential for higher power dissipation densities, increased reliability, reduced ...

IEEE2019

Numerical Simulations of Pulsating Heat Pipes, Part 1: Modeling

John Richard Thome, Jackson Braz Marcinichen, Philippe Aubin, Filippo Cataldo, Brian Paul D'Entremont, Raffaele Luca Amalfi

The pulsating nature of a closed loop pulsating heat pipe (CLPHP) makes the prediction of its thermal-hydraulic performance extremely challenging. Unfortunately, the design of CLPHPs is still quite an empirical process, requiring testing of many prototypes ...

IEEE2019

Enhancing Two-Phase Cooling Efficiency through Thermal- Aware Workload Mapping for Power-Hungry Servers

David Atienza Alonso, Marina Zapater Sancho, Arman Iranfar, Ali Pahlevan

The power density and, consequently, power hungriness of server processors is growing by the day. Traditional air cooling systems fail to cope with such high heat densities, whereas single-phase liquid-cooling still requires high mass flowrate, high pumpin ...

IEEE and ACM Press2019

Design and optimization of a high-temperature latent heat storage unit

Sophia Haussener, Ehsan Rezaei, Alberto Ortona, Maurizio Barbato

High-temperature latent heat thermal energy storage systems offer compact storage solutions, benefiting from the large latent heat of phase change materials. Common challenges in their design process are the low thermal conductivity of the phase change mat ...

2019

Experimental Performance of Completely Passive Single and Recirculating Loop Thermosyphon Cooling Systems using Low GWP R1234ze and R1234yf

John Richard Thome

This paper proposes a novel concept for a loop thermosyphon cooling system, designed for the transistor module of a transformer. The thermosyphon uses a free convection cooled condenser, making the system completely passive, i.e. no energy consumption is n ...

IEEE2019

Identification of optimal operating strategy of direct air-cooling condenser for Rankine cycle based power plants

François Maréchal, Ligang Wang, Xiang Li

Direct air-cooling condenser has attracted significant attention in the last decade due to the employment of Rankine-cycle based power plants from renewable (e.g., concentrated solar) or traditional (e.g., coal) heat sources in water-scarce areas. The opti ...

2018

A data-driven model for the air-cooling condenser of large-scale coal-fired power plants based on data reconciliation and support vector regression

François Maréchal, Ivan Daniel Kantor, Ligang Wang, Jean-Loup Sylvain Robineau, Xiang Li

The performance of a direct air-cooling condenser under operation is rather complicated, as it is interactively affected by the operating conditions (e.g., the mode of air fans) and ambient conditions (e.g., temperature and wind speed). To understand the c ...

2018

Two-Phase Flow Simulations within Plate Heat Exchangers

John Richard Thome, Raffaele Luca Amalfi

Plate heat exchangers are widely adopted in many industrial applications, such as ventilation, air conditioning, heat transfer processes, heat pumps and cooling of hydrodynamic circuits in engines. They provide higher heat transfer performance, compactness ...

IEEE2018

Experimental characterisation of the thermohydraulic performance of a micro-pin fin evaporator: Heat transfer, flow visualization and modelling

Chiara Falsetti

The global tendency towards miniaturization driven by the microelectronics industry is pushing system density and packaging towards unprecedented values of thermal design power, with a dramatic reduction of the surface area of the devices. Vertical integra ...

EPFL2018

Small, High-Speed, Oil-Free Radial Turbo-compressors for Cooling Applications: Refrigerant Selection

Jürg Alexander Schiffmann

Emerging energy-efficient, oil-free radial centrifugal compressors seem promising for small to mid-capacity air conditioning and refrigeration applications. Compressor design must balance trade-offs among impeller diameter, bearing type, and refrigerant se ...

2018

Two-Phase Mini-Thermosyphon For Cooling Of Datacenters: Experiments, Modeling And Simulations

John Richard Thome, Jackson Braz Marcinichen, Nicolas Lamaison, Raffaele Luca Amalfi, Chin Lee Ong

Nowadays, datacenters heat density dissipation follows an exponential increasing trend that is reaching the heat removal limits of the traditional air-cooling technology. Two-phase cooling implemented within a gravity-driven system represents a scalable an ...

Amer Soc Mechanical Engineers2017