Publications related to Boiling water reactor

Neutron-Gamma Noise Measurements in a Zero-Power Reactor Using Organic Scintillators

Andreas Pautz, Vincent Pierre Lamirand, Oskari Ville Pakari

Noise measurements in light water reactor systems aid in generating validation data for integral point kinetic parameter predictions and generating monitoring parameters for reactor safety and safeguards. The CROCUS zero-power reactor has been used to supp ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Experimental study and interpretative modelling of the Power Exhaust in Configurations with Multiple X-Points in TCV

Sophie Danielle Angelica Gorno

Nuclear fusion presents a promising clean energy source to mitigate future energy crises, with magnetic confinement fusion well-positioned to provide a baseload scenario to power future reactors. The unmitigated power exhaust of such reactors threatens its ...

EPFL2024

Intra-pin Reaction Rate Measurements in the CROCUS Experimental Reactor

Andreas Pautz, Vincent Pierre Lamirand, Mathieu Hursin, Oskari Ville Pakari, Thomas Jean-François Ligonnet, Tom Mager

In response to the need for validating high-fidelity deterministic neutronics solvers capable of providing pin-resolved neutron flux distributions, intra-pin reaction rates measurements were performed in the CROCUS experimental reactor. A specially designe ...

2024

Gamma noise to non-invasively monitor nuclear research reactors

Andreas Pautz, Vincent Pierre Lamirand, Oskari Ville Pakari, Pavel Frajtag, Tom Mager

Autonomous nuclear reactor monitoring is a key aspect of the International Atomic Energy Agency’s strategy to ensure nonproliferation treaty compliance. From the rise of small modular reactor technology, decentralized nuclear reactor fleets may strain the ...

Nature Research2024

Atomic level insight into irradiation effects in nuclear fuel materials

Shaileyee Bhattacharya

Microstructural evolution during in-pile irradiation, radiation damage effects and fission products behavior in UO2 nuclear fuel are key issues in understanding and for the modeling of the performance as well as safety characteristics of nuclear fuels in t ...

EPFL2024

Extension of GeN-Foam to departure from nucleate boiling prediction and validation against the OECD/NRC PSBT benchmark

Alessandro Scolaro, Carlo Fiorina, Yuhang Niu, Hao Qin

The prediction of departure from nucleate boiling (DNB) has always been a crucial aspect of thermal-hydraulic codes for the analysis of Light Water Reactors. In this paper, GeN-Foam, a multi-physics code developed based on OpenFOAM, has been enhanced to in ...

Elsevier Science Sa2023

Monte Carlo analysis of BWR geometries using a cycle check-up methodology

Mathieu Hursin, Hakim Ferroukhi, Dimitri Rochman, Abdelhamid Dokhane, Alexander Vasiliev

Recent fuel anomalies at a Swiss power plant have motivated the development at PSI of the "Cycle Check-Up" (CHUP) methodology which consists in performing Monte Carlo transport calculations using nuclide compositions and thermal-hydraulic boundary conditio ...

Pergamon-Elsevier Science Ltd2023

Design and operational guidelines of solar-driven catalytic conversion of CO2 and H2 to fuels

Sophia Haussener, Sha Li

Sunlight-powered catalytic conversion of CO2 and (green) H2 into fuels and chemicals via Sabatier and reverse water gas shift (RWGS) processes offers a promising solution to reduce greenhouse gas emissions and increase renewable energy utilization. The suc ...

ELSEVIER SCI LTD2023

Design of an Instrumented Fuel Rod for Intra-pin Neutron Flux Measurements in the CROCUS Experimental Reactor

Andreas Pautz, Vincent Pierre Lamirand, Mathieu Hursin, Thomas Jean-François Ligonnet, Won Dong Shin, Tom Mager

In response to the need for validating high-fidelity deterministic neutronics solvers capable of pin-resolved neutron flux distributions, an instrumented fuel rod was designed for the experimental reactor CROCUS, operated by EPFL’s Laboratory for Reactor P ...

2023

The effects of a spur dike location in a 90° sharp channel bend on flow field: Focus on anisotropy degree and anisotropy nature

Anton Schleiss

In this research, the flow features around a spur dike located in a 90˚ sharp channel bend have been studied experimentally in detail. Results showed that the effects of the spur dike on upstream sections increased by increasing α (spur dike location from ...

2023

3D Characterisation of Turbulent Plasma Filaments Using Gas Puff Imaging in the Tokamak à Configuration Variable

Nicola Offeddu

A key challenge for the development of fusion reactors based on magnetic confinement, such as tokamaks and stellarators, is the control of the turbulent processes. The most prominent feature of turbulence in the Scrape-Off Layer (SOL), the volume between t ...

EPFL2023

Full-discharge simulation and optimization with the RAPTOR code, from present tokamaks to ITER and DEMO

Simon Van Mulders

Tokamak devices aim to magnetically confine a hydrogen plasma at sufficiently high pressure to achieve net energy production from nuclear fusion of light isotopes. Predictive modeling and optimization is crucial for reliable operation of tokamak reactors, ...

EPFL2023

Validation of spent nuclear fuel decay heat calculations using Polaris, ORIGEN and CASMO5

Andreas Pautz, Dimitri Rochman, Stefano Caruso

Decay heat calculations of spent nuclear fuel (SNF) using Polaris and ORIGEN codes in the SCALE code sys-tem, and CASMO5 code, are validated using measurements from the Clab and GE-Morris facilities. Multiple hypothesis testing, relying on permutations and ...

PERGAMON-ELSEVIER SCIENCE LTD2022

Delayed Hydride Cracking in Irradiated and Unirradiated Zircaloy-2 Cladding

Aaron William Colldeweih

Zirconium alloys used in the nuclear industry are exposed to extreme conditions undergoing high levels of irradiation damage and corrosion. Zircaloy-2 is used as nuclear fuel cladding in boiling water reactors and for the encapsulation of the spallation ta ...

EPFL2022

Quantitative Design of a New e-Methanol Production Process

Alfred Rufer

In the context of the need to significantly reduce greenhouse gas emissions from personal transportation, a new process for the production of e-methanol is presented. It is a CO2 hydrogenation process, powered mainly by renewable energy sources such as pho ...

MDPI2022

Investigation and Validation of Unstructured Mesh Methodologies for Modeling Experimental Reactors

Andreas Pautz, Mathieu Hursin, Carlo Fiorina, Tom Mager

This paper summarizes a methodology developed at Ecole Polytechnique Federale de Lausanne for the neutronic modeling of the CROCUS experimental reactor and proposes solutions to the challenges one may face while modeling a research reactor with a complex g ...

MDPI2022

Construction of Fe3O4 bridged Pt/g-C3N4 heterostructure with enhanced solar to fuel conversion

Michael Graetzel, Shaik Mohammed Zakeeruddin

In this study, we report the effects of co-catalysts of Pt nanoparticles and Fe3O4 clusters on photocatalytic behaviors of g-C3N4 (CN) and the use of the resulting photocatalyst for CO2 photoreduction to solar fuels in a flow reactor operated at room-tempe ...

ELSEVIER2022

Thermodynamic modelling of hydrogen production in sorbent-enhanced biochar-direct chemical looping process

Hydrogen (H-2) has been widely considered the clean energy carrier of choice for emerging renewable energy generation technologies. However, H-2 is a secondary fuel mainly derived from natural gas. Over the past decades, research on developing H-2 producti ...

2022

Revisiting the Impact of Morphology and Oxidation State of Cu on CO2 Reduction Using Electrochemical Flow Cell

Michael Graetzel, Shaik Mohammed Zakeeruddin, Jing Gao, Dan Ren

Electroreduction of carbon dioxide (CO2) in a flow electrolyzer represents a promising carbon-neutral technology with efficient production of valuable chemicals. In this work, the catalytic performance of polycrystalline copper (Cu), Cu2O-derived copper (O ...

AMER CHEMICAL SOC2022

Flexibilisation of Biogas-Based Power-to-Gas Processes: A Techno-Economic and Experimental Assessment

Andreas Gantenbein

Biogas-based power-to-X technology allows storing renewable electricity, while producing CO2-neutral products. This work investigates the conversion and upgrading of digestion-derived gas mixtures with focus on increasing the operational flexibility of the ...

EPFL2022