Publications related to Synthetic rubber

Biobased Composites from Eugenol- and Coumarin-Derived Methacrylic Latex and Hemp Nanocellulose: Cross-Linking via [2+2] Photocycloaddition and Barrier Properties

A novel-biobased latex was synthesized by redox-initiated emulsion copolymerization of ethoxy dihydroeugenyl methacrylate with 5 wt % of a photosensitive methacrylate containing a coumarin group. A stable copolymer latex having 16 wt % solids content and a ...

Amer Chemical Soc2024

Additive Manufacturing of Bioinspired Mineral-Based Composites

Ran Zhao

Biominerals are used by natural organisms for example as structural supports and optical sensors. They are produced from a limited number of elements and under ambient conditions. Nevertheless, they often possess excellent mechanical properties and sometim ...

EPFL2024

Biocompatible and Biodegradable 3D Printing from Bioplastics: A Review

Sandro Carrara

There has been a lot of interest in developing and producing biodegradable polymers to address the current environmental problem caused by the continued usage of synthetic polymers derived from petroleum products. Bioplastics have been identified as a poss ...

MDPI2023

Controlling the Microstructure and Composition of 3D Printed Soft Load-Bearing Hydrogels

Matteo Hirsch

Hydrogels are among the first materials expressly designed for their use in biomedicine. However, state-of-the-art applications of hydrogels are severely limited because they are typically either too soft or too brittle such that they cannot bear significa ...

EPFL2023

Chlorination of amides: Kinetics and mechanisms of formation of N-chloramides and their reactions with phenolic compounds

Urs von Gunten, Tianqi Zhang

Amides are common constituents in natural organic matter and synthetic chemicals. In this study, we investi-gated kinetics and mechanisms of the reactions of chlorine with seven amides, including acetamide, N-meth-ylformamide, N-methylacetamide, benzamide, ...

2023

Slot-Die Coating of an On-the-Shelf Polymer with Increased Dielectric Permittivity for Stack Actuators

Yauhen Sheima

Nitrile-butadiene rubbers (NBR) have been extensively used as dielectric materials due to their commercial availability, excellent mechanical properties, glass transition temperature below 0 degrees C, and increased dielectric permittivity owing to the pre ...

AMER CHEMICAL SOC2022

Highly Stretchable Silicone Elastomer Applied in Soft Actuators

Fabio Beco Albuquerque, Pengpeng Hu

In this work, a highly stretchable silicone elastomer is incorporated into dielectric elastomer actuators (DEAs) in order to decrease operation voltages by applying high prestretches. Results show that the fabricated DEAs (5 mm diameter circle active regio ...

WILEY-V C H VERLAG GMBH2022

(4+3) Annulation of Donor-Acceptor Cyclopropanes and Azadienes: Highly Stereoselective Synthesis of Azepanones

Jérôme Waser, Stefano Nicolai

Azepanes are important seven-membered heterocycles, which are present in numerous natural and synthetic compounds. However, the development of convergent synthetic methods to access them remains challenging. Herein, we report the Lewis acid catalyzed (4+3) ...

Wiley-VCH Verlag GmbH2022

Automated test setup to quantify the lifetime of dielectric elastomer actuators under a wide range of operating conditions

Herbert Shea, Fabio Beco Albuquerque, Djen Timo Kühnel, Valentin Colin Py

We present an automated test setup for the systematic performance and lifetime evaluation of dielectric elastomer actuators (DEAs). This setup, called the MAPLE setup, performs accelerated aging tests and allows quantifying how material choice, fabrication ...

IOP PUBLISHING LTD2021

Macrocyclization of omega-Isocyanoaldehydes and Towards the Total Synthesis of Jamaicensamide A

Teerawat Songsichan

In the first chapter of this thesis, the macrocyclization of a new type of bifunctional substrates, omega-isocyanoaldehyde derivatives, is described. Ten different omega-isocyanoaldehydes in terms of different ring sizes and functional groups were prepared ...

EPFL2021

Development of remote C-H bond functionalization of redox-active alcohol derivatives and oxidative transformations under photoredox catalysis

Alexandre Julien Florent Leclair

The development of radical-based remote C(sp3)-H functionalizations of redox-active alcohol derivatives, oxidative cycloaddition and rearrangement transformations under visible light photocatalysis constitute the basis of this thesis. The first chapter des ...

EPFL2021

Strain and filler ratio transitions from chains network to filler network damage in EPDM during single and cyclic loadings

Nicolas Candau, Oguzhan Oguz

Chains and filler network damage were investigated during single and multiple cycles on a series of vulcanized EPDM containing various filler contents. In both series of experiments, a strain and a filler ratio transitions for damage mechanisms were identi ...

2020

Copper-Catalyzed 1,2-Methoxy Methoxycarbonylation of Alkenes with Methyl Formate and Synthetic Studies Towards the Total Synthesis of Koumine, Voacafricine A and Voacafricine B

Balázs Budai

The development of an unusual oxidative alkene difunctionalization using methyl formate and syn-thetic studies towards alkaloid natural products provide the basis of the thesis. The first chapter details the development of a method that forges methoxycarbo ...

EPFL2020

Increased electromechanical sensitivity of polysiloxane elastomers by chemical modification with thioacetic groups

Yee Song Ko

Chemically cross-linked polydimethylsiloxane (PDMS) elastomers have gained importance as a dielectric in elastic capacitor actuators, which elongate when electrically charged. Common PDMS elastomers have a dielectric permittivity of only about 3 and thus e ...

2020

Soft Printable Electrode Coating for Neural Interfaces

Stéphanie Lacour, Grégoire Courtine, Quentin Barraud, Florian Dylan Fallegger, Elvira Pirondini, Michael Shur, Arnaud Bichat

The mechanical mismatch between implantable interfaces and neural tissues may be reduced by employing soft polymeric materials. Here, we report on a simple strategy to prepare and pattern a soft electrode coating of neural interfacing devices based on a sc ...

2020

Light-Activated, Bioadhesive, Poly(2-hydroxyethyl methacrylate) Brush Coatings

Dominique Pioletti, Harm-Anton Klok, Peyman Karami, Jian Wang, Nariye Cavusoglu Ataman

Rapid adhesion between tissue and synthetic materials is relevant to accelerate wound healing and to facilitate the integration of implantable medical devices. Most frequently, tissue adhesives are applied as a gel or a liquid formulation. This manuscript ...

American Chemical Society2020

Synthetic Studies toward Amanita Phalloides Toxins

Philipp Georg Werner Seeberger

Amatoxins are ribosomally synthesized and post-translationally modified bicyclic octapeptides biosynthesized by the deadly basidiomycete fungus Amanita phalloides. Amongst this group, alpha-amanitin is the most widely known toxin and is currently under inv ...

EPFL2020

Functional and Responsive Polymers via Controlled Radical Polymerization

Jian Wang

This Thesis is built around 4 topics, which share in common that they all take advantage of the assets of controlled radical polymerization to either (i) prepare well-defined model systems to address fundamental research questions with regard to the sensit ...

EPFL2020

Influence of humidity, temperature and prestretch on the dielectric breakdown strength of silicone elastomer membranes for DEAs

Herbert Shea, Fabio Beco Albuquerque

Humidity, temperature and membrane prestretch influence the dielectric breakdown strength of elastomer membranes. These three factors thus also influence the maximum force and strain that dielectric elastomer actuators (DEAs) can generate, as the Maxwell p ...

IOP PUBLISHING LTD2020

Data-Driven Model for the Dynamic Characteristics of O-Rings for Gas Bearing Supported Rotors

Jürg Alexander Schiffmann, Philipp Kaspar Bättig

The measurement results of various nitrile butadiene rubber (NBR) O-Ring sizes are pre-sented, and reduced-order models are developed in order to predict the stiffness and damping coefficient as a function of O-Ring geometry, Shore hardness, squeeze, and e ...

2019