Publications related to Micro combined heat and power

Decoupling the Contributions of Different Instability Mechanisms to the PEMFC Performance Decay of Non-noble Metal O2-Reduction Catalysts

Vasiliki Tileli, Robin Pierre Alain Girod, Secil Unsal

Non-noble metal catalysts (NNMCs) hold the potential to replace the expensive Pt-based materials currently used to speed up the oxygen reduction reaction (ORR) in proton exchange membrane fuel cell (PEMFC) cathodes, but they feature poor durability that in ...

AMER CHEMICAL SOC2023

Readiness evaluation of SOFC-MGT hybrid systems with carbon capture for distributed combined heat and power

Jan Van Herle, Jürg Alexander Schiffmann, Victoria Xu Hong He, Michele Gaffuri

The aggravation of climate change calls for the timely development and implementation of highly efficient, renewable, zero- or negative-emission energy solutions with high technological readiness and feasibility levels. Solid oxide fuel cells (SOFC) consti ...

Elsevier2023

Hybridisation Scenarios of Solid Oxide Fuel Cells, Batteries, and Internal Combustion Engines for Waterborne Transportation

François Maréchal, Daniel Alexander Florez Orrego

The shipping industry was responsible for about 3% of global greenhouse gas (GHG) emissions in 2018. In this context, the International Maritime Organisation (IMO) has established stringent targets to reduce GHG emissions by at least 50% by 2050 compared t ...

Universidad de Las Palmas de Gran Canaria2023

The thermodynamic and life-cycle assessments of a novel charging station for electric vehicles in dynamic and steady-state conditions

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

The current study performs the thermodynamic and life-cycle assessments (LCA) of a novel charging station in two system designs. The goal is to design an efficient charging station for electric vehicles with high efficiencies and low environmental impacts ...

Nature Portfolio2023

Local electrochemical and thermal investigation of a segmented reversible solid oxide fuel cell and electrolyzer

Jan Van Herle, Stefan Diethelm, Audrey Désirée Wesoly, Zacharie Wuillemin, Hamza Moussaoui

A novel setup has been designed and mounted to investigate the local electrochemical and thermal behavior of a cell from a 4-cell short stack under reversible operation solid oxide fuel cell/solid oxide electrolyzer (SOFC/SOE). It consists in the partition ...

Pergamon-Elsevier Science Ltd2023

Comparative Exergy and Economic Assessment of Fossil and Biomass-Based Routes for Ammonia Production

François Maréchal, Daniel Alexander Florez Orrego

Due to the increasing concerns about the marked dependence on fossil resources and their intrinsic economic uncertainty, as well as motivated by more stringent environmental regulations, the pursuit of alternative energy resources for the synthetic fertili ...

Silesian University of Technology2023

Catalyst Aggregate Size Effect on the Mass Transport Properties of Non-Noble Metal Catalyst Layers for PEMFC Cathodes

Vasiliki Tileli, Robin Pierre Alain Girod, Michele Bozzetti, Yen-Chun Chen, Secil Unsal

Non-noble metal catalysts (NNMCs) are regarded as a promising alternative to the costly Pt-based materials required to catalyze the oxygen reduction reaction (ORR) in proton exchange membrane fuel cell (PEMFC) cathodes. However, the large diversity of NNMC ...

ELECTROCHEMICAL SOC INC2023

Multidimensional Electron Imaging of Catalyst Layer Materials

Robin Pierre Alain Girod

The proton exchange membrane fuel cell (PEMFC) is an important technology for clean power generation in a decarbonized hydrogen system and is notably envisioned for applications in heavy-duty transportation. However, for cost and performance competitivenes ...

EPFL2023

Two novel cogeneration charging stations for electric vehicles: Energy, exergy, economic, environment, and dynamic characterizations

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

This paper suggests two novel designs for the electric vehicle charging stations using LiMn2O4 Lithium-ion battery and based on a Solid Oxide Fuel Cell (SOFC) and absorption refrigeration cycle (ARC) technologies to provide electricity and cooling, respect ...

Elsevier2022

Organic Rankine Cycle as the Waste Heat Recovery Unit of Solid Oxide Fuel Cell: A Novel System Design for the Electric Vehicle Charging Stations Using Batteries as a Backup/Storage Unit

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

The novelty of this study is to suggest a novel design for electric vehicle charging stations using fuel cell technology. The proposed system benefits from the Organic Rankine Cycle (ORC) to utilize the exhaust energy of the Solid Oxide Fuel Cell (SOFC) st ...

MDPI2022

The impacts of the gas diffusion layer contact angle on the water management of the proton exchange membrane fuel cells: Three-dimensional simulation and optimization

Jan Van Herle, Hossein Pourrahmani

Water management of the proton exchange membrane fuel cell (PEMFC) is an important parameter to improve efficiency, especially in cold weather conditions. The generated water of the electrochemical reactions inside PEMFC may stay inside the cell and fill t ...

WILEY2022

Linear Recursive State Estimation of Hybrid and Unbalanced AC/DC Micro-Grids using Synchronized Measurements

Mario Paolone, Willem Lambrichts

In this paper, we present an exact (i.e. non-approximated) and linear measurement model for hybrid AC/DC micro-grids for recursive state estimation (SE). More specifically, an exact linear model of a voltage source converter (VSC) is proposed. It relies on ...

2022

Theory-guided design of high-strength, high-melting point, ductile, low-density, single-phase BCC high entropy alloys

William Curtin, Christian Leinenbach, Carolina Baruffi, You Rao

The search for new high-temperature alloys that can enable higher-efficiency/lower-emissions power generation has accelerated with the discovery of body-centered cubic (bcc) refractory High Entropy Alloys (HEAs). These many-component, non-dilute alloys in ...

PERGAMON-ELSEVIER SCIENCE LTD2022

Performance Analysis of Ammonia in Solid Oxide Fuel Cells

Jan Van Herle, Suhas Nuggehalli Sampathkumar, Peter Hugh Middleton, Steve Joris

Ammonia (NH3) has 17.8 wt% hydrogen and is easily liquified at 25°C and 8 bar pressure. Ammonia is carbon-free and can be produced sustainably at large scale and low cost. Solid oxide fuel cells generate electricity with efficiencies greater than 60% and c ...

ECS2021

Thermal management of components for high energy physics experiments and space applications

Timothée Robert Sophus Frei

High-energy physics (HEP) experiments and space missions share a common challenge: thermal management in harsh environments. The severe constraints in both fields make cooling of electronic components a major design concern. This thesis aims to develop hig ...

EPFL2021

Assessment of ammonia as energy carrier in the use with reversible solid oxide cells

Jan Van Herle, Michele Zendrini

Ammonia represents one of the most promising potential solutions as energy vector and hydrogen carrier, having a higher potential to transport energy than hydrogen itself in a pressurized form. Furthermore, solid oxide fuel cells (SOFCs) can directly be fe ...

2021

Boosting hydrogen production via urea electrolysis on an amorphous nickel phosphide/graphene hybrid structure

Paul Joseph Dyson, Zhaofu Fei, Lu Chen, Yun Tong

Overall urea electrolysis has favorable thermodynamic properties and can complement traditional water splitting by simultaneously purifying urea-rich waste streams. However, the kinetics of the reaction is slow and more efficient catalysts are required. In ...

SPRINGER2021

In-situ experimental benchmarking of solid oxide fuel cell metal interconnect solutions

Jan Van Herle, Stefan Diethelm, Priscilla Caliandro, Manuel Bianco

The progress in the diffusion of solid oxide fuel cell (SOFC) as commercial devices is not paired by literature production. Articles describing the behaviour of SOFC stacks are rare because of confidentiality reasons for commercial suppliers while research ...

2020

Advanced analytical electron microscopy applied to Solid Oxide Cell materials and their degradation

Stéphane François Jean Poitel

Electron microscopy offers a wide range of techniques to study materials. Environmental Scanning Electron Microscopy (ESEM), in particular, allows the characterisation of samples at high-temperature using a laser heating stage, and under various gaseous at ...

EPFL2020

Sofc system with anode off-gas recirculation

Daniel Favrat, Jan Van Herle, Jürg Alexander Schiffmann, Zacharie Wuillemin, Patrick Hubert Wagner

The present invention concerns an SOFC system comprising an anode off-gas recirculation arrangement in which anode off-gas is pumped by a fan or pump of a coaxial turbine-fan assembly, the system comprising a condenser for condensing water contained in sai ...

2020