Bank switching

Bank switching is a technique used in computer design to increase the amount of usable memory beyond the amount directly addressable by the processor instructions. It can be used to configure a system differently at different times; for example, a ROM required to start a system from diskette could be switched out when no longer needed. In video game systems, bank switching allowed larger games to be developed for play on existing consoles. Bank switching originated in minicomputer systems. Many modern microcontrollers and microprocessors use bank switching to manage random-access memory, non-volatile memory, input-output devices and system management registers in small embedded systems. The technique was common in 8-bit microcomputer systems. Bank-switching may also be used to work around limitations in address bus width, where some hardware constraint prevents straightforward addition of more address lines, and to work around limitations in the ISA, where the addresses generated are narrower than the address bus width. Some control-oriented microprocessors use a bank-switching technique to access internal I/O and control registers, which limits the number of register address bits that must be used in every instruction. Unlike memory management by paging, data is not exchanged with a mass storage device like disk storage. Data remains in quiescent storage in a memory area that is not currently accessible to the processor (although it may be accessible to the video display, DMA controller, or other subsystems of the computer) without the use of special prefix instructions. Bank switching can be considered as a way of extending the address space of processor instructions with some register. Examples: The follow-on system to a processor with a 12 bit address has a 15 bit address bus, but there is no way to directly specify the high three bits on the address bus. Internal bank registers can be used to provide those bits. The follow-on system to a processor with a 15 bit address has an 18 bit address bus, but legacy instructions only have 15 address bits; internal bank registers can be used to provide those bits.