Publications related to Propfan

The effect of nacelle-to-rotor size on the wake of a miniature wind turbine

Fernando Porté Agel, Arslan Salim Dar, Rim Majzoub

Wind tunnel experiments are performed to investigate the effect of nacelle-to-rotor size on the wake of a wind turbine under different Reynolds numbers. Four different turbine configurations are tested, which vary in the rotor diameter and nacelle length a ...

IOP Science2024

Influence of Large Relative Tip Clearances for a Micro Radial Fan and Design Guidelines for Increased Efficiency

Jan Van Herle, Jürg Alexander Schiffmann, Patrick Hubert Wagner

The blade tip clearance loss was studied experimentally and numerically for a micro radial fan with a tip diameter of 19:2mm. Its relative blade tip clearance, i.e., the clearance dividedby the blade height of 1:82mm, was adjusted with different shims. The ...

2021

Downside Up:Rethinking Parcel Position for Aerial Delivery

Dario Floreano, Przemyslaw Mariusz Kornatowski, William John Stewart, Mir Alikhan Bin Mohammad Feroskhan

The conventional approach to parcel placement in most delivery drone designs today is to place the parcel centrally beneath the drone's rotor plane. However, if the parcel is too large, this will result in an obstruction of the propeller slipstream, incurr ...

2020

A Morphing Cargo Drone for Safe Flight in Proximity of Humans

Dario Floreano, Przemyslaw Mariusz Kornatowski, William John Stewart, Mir Alikhan Bin Mohammad Feroskhan

Delivery drones used by logistics companies today are equipped with unshielded propellers, which represent a major hurdle for in-hand parcel delivery. The exposed propeller blades are hazardous to unsuspecting bystanders, pets, and untrained users. One sol ...

2020

Design and development of the efficient anguilliform swimming robot- MAR

Auke Ijspeert, Peter Eckert, Anouk Looijestijn

Propulsion of swimming robots at the surface and underwater is largely dominated by rotary propellers due to high thrust, but at the cost of low efficiency. Due to their inherently high speed turning motion, sharp propeller blades and generated noise, they ...

2020

Two-dimensional quasi-static debonding in GFRP/balsa sandwich panels

Thomas Keller, Anastasios Vassilopoulos, Aida Cameselle Molares

The two-dimensional (2D) debonding behavior of GFRP/balsa sandwich panels presenting embedded circular disbonds at the face sheet/core interface was experimentally investigated. The bottom of the panels was fixed and out-of-plane quasi-static tensile loads ...

2019

Passive damping of composite blades using embedded piezoelectric modules or shape memory alloy wires: a comparative study

Véronique Michaud, Antoine Sigg, Andrea Bergamini

Emission reduction from civil aviation has been intensively addressed in the scientific community in recent years. The combined use of novel aircraft engine architectures such as open rotor engines and lightweight materials offer the potential for fuel sav ...

Institute of Physics2012

Influence of Blade Aspiration on the Flow Quality of an Annular Axial Compressor Cascade

Peter Ott, Elia Colombo

Experimental and numerical investigations were performed in order to develop a technique of active flow control by aspiration applied to an annular axial compressor cascade. Continuous aspiration is applied through shaped slots located on the suction side ...

2011