Antique radio

An antique radio is a radio receiving set that is collectible because of its age and rarity. The first radio receivers used a coherer and sounding board, and were only able to receive CW continuous wave (CW) transmissions, encoded with Morse code (wireless telegraphy). Later wireless telephony|transmission and reception of speech became possible, although Morse code transmission continued in use until the 1990s. All the following sections concern speech-capable radio, or wireless telephony. The idea of radio as entertainment took off in 1920, with the opening of the first stations established specifically for broadcast to the public such as KDKA in Pittsburgh and WWJ in Detroit. More stations opened in cities across North America in the following years and radio ownership steadily gained in popularity. Radio sets from before 1920 are rarities, and are probably military artifacts. Sets made prior to approximately 1924 were usually made on wooden breadboards, in small cupboard style cabinets, or sometimes on an open sheet metal chassis. Homemade sets remained a strong sector of radio production until the early 1930s. Until then there were more homemade sets in use than commercial sets. Early sets used any of the following technologies: Crystal set Crystal set with carbon or mechanical amplifier Basic Tuned Radio Frequency (TRF) Sets Reaction Sets Super-Regenerative Receiver Superheterodyne Receiver Crystal radio These basic radios used no battery, had no amplification and could operate only high-impedance headphones. They would receive only very strong signals from a local station. They were popular among the less wealthy due to their low build cost and zero run cost. Crystal sets had minimal ability to separate stations, and where more than one high power station was present, inability to receive one without the other was a common problem. Some crystal set users added a carbon amplifier or a mechanical turntable amplifier to give enough output to operate a speaker. Some even used a flame amplifier.