Publications related to Working fluid selection

Fiber pumps for wearable fluidic systems

Herbert Shea, Michael James Henry Smith, Vito Cacucciolo

Incorporating pressurized fluidic circuits into textiles can enable muscular support, thermoregulation, and haptic feedback in a convenient wearable form factor. However, conventional rigid pumps, with their associated noise and vibration, are unsuitable f ...

American Association for the Advancement of Science2023

The thermodynamic and life-cycle assessments of a novel charging station for electric vehicles in dynamic and steady-state conditions

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

The current study performs the thermodynamic and life-cycle assessments (LCA) of a novel charging station in two system designs. The goal is to design an efficient charging station for electric vehicles with high efficiencies and low environmental impacts ...

Nature Portfolio2023

Flow Boiling of Carbon Dioxide at Different Channel Orientations for the Thermal Management of Future Detector Technologies at the High-Luminosity Large Hadron Collider at CERN

David Schmid

The global warming potential (GWP) of working fluids in thermodynamic cycles and their environmental impact have been gaining considerable attention within the recent years. The global objectives on climate protection are becoming increasingly ambitious, w ...

EPFL2022

Organic Rankine Cycle as the Waste Heat Recovery Unit of Solid Oxide Fuel Cell: A Novel System Design for the Electric Vehicle Charging Stations Using Batteries as a Backup/Storage Unit

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

The novelty of this study is to suggest a novel design for electric vehicle charging stations using fuel cell technology. The proposed system benefits from the Organic Rankine Cycle (ORC) to utilize the exhaust energy of the Solid Oxide Fuel Cell (SOFC) st ...

MDPI2022

A parametric study on pool boiling heat transfer and critical heat flux on structured surfaces with artificial cavities

Luis Guillermo Villanueva Torrijo, Ahmad Reza Motezakker

Emerging applications in new generation electronic devices require effective heat removal and thermal man-agement. In this regard, boiling is a phase change phenomenon capable of dissipating a large amount of heat compared to the sensible heat. In this stu ...

PERGAMON-ELSEVIER SCIENCE LTD2022

Novel pulsating heat pipe for high density power data centres: performance and flow regime analysis

John Richard Thome, Jackson Braz Marcinichen, Filippo Cataldo, Raffaele Luca Amalfi

With the advancement of technologies such as Artificial Intelligence and 5G telecommunications, where computational rate is constantly pushing its limits, highly efficient and reliable cooling devices are starting to become an overly critical factor. Not o ...

IEEE2021

Simulation and experimental validation of pulsating heat pipes

John Richard Thome, Jackson Braz Marcinichen, Philippe Aubin, Filippo Cataldo

The one-dimensional transient numerical code of JJ Cooling Innovation has been significantly improved to simulate the thermal/hydraulic performance of pulsating heat pipes (PHPs). Using a mechanistic approach, the liquid slug and vapor plug flows and their ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Operational Map And Thermal Performance Of A Thermosyphon Cooling System For Compact Servers

John Richard Thome, Jackson Braz Marcinichen, Filippo Cataldo, Raffaele Luca Amalfi

This paper advances the state-of-the-art in novel passive two-phase systems for more efficient cooling of datacenters and telecom central offices compared to the traditional air-based cooling solutions (e.g. aisle-based containment systems). The proposed p ...

AMER SOC MECHANICAL ENGINEERS2021

Thermal management of components for high energy physics experiments and space applications

Timothée Robert Sophus Frei

High-energy physics (HEP) experiments and space missions share a common challenge: thermal management in harsh environments. The severe constraints in both fields make cooling of electronic components a major design concern. This thesis aims to develop hig ...

EPFL2021

Compact Thermosyphon Cooling System For High Heat Flux Servers: Validation Of Thermosyphon Simulation Code Considering New Test Data

John Richard Thome, Jackson Braz Marcinichen, Filippo Cataldo, Raffaele Luca Amalfi

Passive, gravity-driven thermosyphons represent a stepchange in technology towards the goal of greatly reducing PUE (Power Usage Effectiveness) of datacenters by replacing energy hungry fans of air-cooling approach with a highly-reliable solution able to d ...

AMER SOC MECHANICAL ENGINEERS2021

Scale limitations of gas bearing supported turbocompressors for vapor compression cycles

Jürg Alexander Schiffmann

An analysis of single-stage centrifugal compressors supported on dynamic, gas lubricated bearings for driving vapor compression cycles suggests that the maximum feasible compressor power is limited, primarily by the bearing load capacity, in the range from ...

2020

Multi-objective optimization and exergoeconomic analysis of a continuous solar-driven system with PCM for power, cooling and freshwater production

Hossein Pourrahmani

In this article, three different modes of a novel integrated system would be evaluated by the application of high temperature Thermal Energy Storage (TES) to produce electricity, cooling, and freshwater. Freshwater is produced using the reverse osmosis (RO ...

Elsevier2020

Autonomous oil flow generated by self-oscillating polymer gels

Vito Cacucciolo

The previously reported gel and polymer actuators require external inputs, such as batteries, circuits, electronic circuits, etc., compared with autonomous motions produced by the living organisms. To realize the spontaneous motions, here, we propose to in ...

Nature Research2020

Advanced design methods and non-ideal gas lubrication applied to aerodynamic bearings

Eliott Philippe Guenat

Clean and energy-efficient turbomachinery are playing an increasingly important role in the decarbonization of heating systems, waste heat recovery and transportation, as the use of small-scale heat pumping and fuel cells spreads. Such machines typically e ...

EPFL2020

Optimal retrofit and investment planning methodologies for improving industrial energy and resource efficiency

Hür Ebuzer Bütün

A major shift in energy systems has started due to drastic changes in climate and air quality, depleting resources, as well as rising social awareness to all these changes. As a result international protocols, such as the Paris agreement, are signed settin ...

EPFL2020

Experimental Performance of Completely Passive Single and Recirculating Loop Thermosyphon Cooling Systems using Low GWP R1234ze and R1234yf

John Richard Thome

This paper proposes a novel concept for a loop thermosyphon cooling system, designed for the transistor module of a transformer. The thermosyphon uses a free convection cooled condenser, making the system completely passive, i.e. no energy consumption is n ...

IEEE2019

Numerical Simulations of Pulsating Heat Pipes, Part 2: Comparison to Experimental Data

John Richard Thome, Jackson Braz Marcinichen, Philippe Aubin, Filippo Cataldo, Raffaele Luca Amalfi

Due to the local pulsating/transient nature and complex thermal-hydraulic coupling of a closed loop pulsating heat pipe (CLPHP), there is a need to develop an effective simulation code capable to design and predict the local and overall thermal performance ...

IEEE2019

Experimental Characterization of Different Condenser Technologies in a Passive Two-Phase Cooling System for Thermal Management of Electronics

John Richard Thome, Jackson Braz Marcinichen, Chiara Falsetti, Raffaele Luca Amalfi

Passive two-phase, micro-channel cooling for thermal management of electronics represents an efficient and viable solution to augment conventional air-cooling systems with the potential for higher power dissipation densities, increased reliability, reduced ...

IEEE2019

Design and optimization of a high-temperature latent heat storage unit

Sophia Haussener, Ehsan Rezaei, Alberto Ortona, Maurizio Barbato

High-temperature latent heat thermal energy storage systems offer compact storage solutions, benefiting from the large latent heat of phase change materials. Common challenges in their design process are the low thermal conductivity of the phase change mat ...

2019

Multi-objective optimization of turbo-ORC systems for waste heat recovery on passenger car engines

Jürg Alexander Schiffmann, Kévin Rosset, Eliott Philippe Guenat, Violette Mounier

Waste heat recovery from passenger car internal combustion engines by means of an organic Rankine cycle (ORC) system is promising for reducing CO2 emissions. In this study, different cycle configurations capable of converting waste heat from both coolant a ...

2018