Triaxial shear test

Applied sciences
Civil engineering
Geotechnical engineering
Topics in geotechnical engi...

About
Privacy
Disclaimer

Graph Chatbot

Related publications (31)

Transversal Spurious Mode Suppression in Ultra-Large-Coupling SH0 Acoustic Resonators on YX36 degrees-Cut Lithium Niobate

Luis Guillermo Villanueva Torrijo, Silvan Stettler

This work reports on the design and fabrication of fundamental shear horizontal (SH0) mode acoustic resonators based on a suspended lithium niobate (LNO) film at 1.04 GHz. Due to the large e16 piezoelectric coefficient of YX36 degrees.-cut LNO, fabricated ...

Institute of Electrical and Electronics Engineers2023

Influence of depositional fabric on mechanical properties of naturally deposited sands

Gioacchino Viggiani, Edward Carlo Giorgio Andò

Fabric characteristics and shear deformation behaviour were analysed in four intact small-scale samples, including two disturbed and two undisturbed samples of naturally deposited sand from a shoal in the San Francisco Bay. Triaxial compression tests were ...

ICE PUBLISHING2022

Swelling and shrinkage of partially saturated gas shales: from laboratory tests to an effective stress framework

Jinwoo Kim

Gas shale swelling during hydraulic stimulation is one of the major challenges in unconventional gas development. It is hypothesized that the large volumetric strain upon water imbibition is a consequence of dramatic changes in capillary pressure and disjo ...

EPFL2022

Characterization of shear deformations in reinforced concrete members without shear reinforcement

Aurelio Muttoni, Miguel Fernández Ruiz, Raffaele Cantone, Andri Setiawan

The load-carrying capacity of many reinforced concrete structures is governed by shear failures, occurring before reaching the flexural capacity of the member. For redundant systems, such as slabs subjected to concentrated loads, local shear failures (typi ...

2022

Failure mechanism of fine-grained soil-structure interface for energy piles

Lyesse Laloui, Elena Ravera

The response of the soil-structure interface can significantly affect the performance of any geotechnical structure. Thermal cycles are a new factor that influence the response to all structures that have an energy function in addition to the structural on ...

2022

Investigation of the effect of mineral dissolution on the geomechanical behaviour of geomaterials

Taeheon Kim

Geotechnical engineering scenarios engaged in internal erosion or mineral dissolution were found worldwide, from CO2 sequestration projects to internal erosion of earth dams. Materials subjected to loss of solid phase from their internal fabric vary from s ...

EPFL2022

Transport barrier in 5D gyrokinetic flux-driven simulations

Two ways for producing a transport barrier through strong shear of the E x B poloidal flow have been investigated using GYSELA gyrokinetic simulations in a flux-driven regime. The first one uses an external poloidal momentum (i.e. vorticity) source that lo ...

IOP Publishing Ltd2022

Auto-tuning deep forest for shear stiffness prediction of headed stud connectors

Xianlin Wang, Yuqing Liu

The shear stiffness of headed stud connector is a critical parameter for the calculation of deflection and inter-facial shear force for steel-concrete composite structure. Thus, this study presented a promising data-driven model auto-tuning Deep Forest (AT ...

2022

Determination of Parameters Characteristic of Dynamic Weakening Mechanisms During Seismic Faulting in Cohesive Rocks

Marie Estelle Solange Violay, François Xavier Thibault Passelègue, Chiara Cornelio

While sliding at seismic slip-rates of ∼1 m/s, natural faults undergo an abrupt decrease of shear stress called dynamic weakening. Asperity-scale processes related to flash heating and weakening and, meso-scale (mm-cm) processes involving shear across the ...

AGU2022

Drained Axial Pipe-Soil Resistance at Low Confinement Using Tilt Table and Direct Shear Tests

Roba Houhou

Establishing a reliable value for the axial pipe-soil interface resistance is critical for the design of offshore pipelines. Over the last few years, several independent research groups have modified existing methodologies or devised new testing setups to ...

ASCE-AMER SOC CIVIL ENGINEERS2022

Experimental quantification of 3D deformations in sensitive clay during stress-probing

Edward Carlo Giorgio Andò

Unique four-dimensional (4D) deformation data are collected during drained triaxial tests on intact specimens of a natural sensitive clay. This requires the development of a miniature triaxial cell for advanced stress path testing, specifically designed fo ...

ICE PUBLISHING2022

Page 2 of 2