Publications related to Rotating air-water ring in the vaneless gap of a pump-turbine operating in condenser mode

Enhancing Wind Farm Performance through Axial Induction and Tilt Control: Insights from Wind Tunnel Experiments

Fernando Porté Agel, Guillem Armengol Barcos

Static axial induction control and tilt control are two strategies that have the potential to increase power production in wind farms, mitigating wake effects and increasing the available power for downstream turbines. In this study, wind tunnel experiment ...

MDPI2024

Wind turbine wake superposition under pressure gradient

Fernando Porté Agel, Arslan Salim Dar

We investigate the effect of pressure gradient on the cumulative wake of multiple turbines in wind tunnel experiments spanning across a range of adverse pressure gradient (APG), zero pressure gradient (ZPG), and favorable pressure gradient (FPG). Compared ...

2024

The effect of nacelle-to-rotor size on the wake of a miniature wind turbine

Fernando Porté Agel, Arslan Salim Dar, Rim Majzoub

Wind tunnel experiments are performed to investigate the effect of nacelle-to-rotor size on the wake of a wind turbine under different Reynolds numbers. Four different turbine configurations are tested, which vary in the rotor diameter and nacelle length a ...

IOP Science2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Power performance of a model floating wind turbine subjected to cyclic pitch motion: A wind tunnel study

Fernando Porté Agel, Guiyue Duan, Daniele Gattari

Wind tunnel experiments were performed with a miniature floating wind turbine model to study the effects of cyclic pitch motion on its power performance. The cyclic pitch motion was prescribed by two key parameters: pitch frequency and amplitude. The power ...

IOPscience2024

On the prediction of the induced damage by the start-up sequence of Francis turbines: On operational resilience framework

Christophe Nicolet, Mario Paolone, Martin Seydoux, Elena Vagnoni

The number of transient operations in hydraulic machinery connected to power grid, notably start-ups and shut-downs, has observed a substantial increase in recent decades, primarily driven by the global shift toward intermittent renewable energy sources. S ...

Pergamon-Elsevier Science Ltd2024

Study of flexible operating conditions in variable-speed hydraulic turbines : advanced models and experimental validation

Martin Seydoux

The global imperative to transition from fossil fuel-based energy sources to renewable alternatives has become increasingly urgent in the pursuit of sustainable and renewable power generation. This paradigm shift necessitates innovative approaches to manag ...

EPFL2024

Optimal blade pitch control for enhanced vertical-axis wind turbine performance

Sébastien Le Fouest, Karen Ann J Mulleners

Vertical-axis wind turbines are great candidates to enable wind power extraction in urban and off-shore applications. Currently, concerns around turbine efficiency and structural integrity limit their industrial deployment. Flow control can mitigate these ...

Nature Research2024

Towards an improved understanding of wind turbine wakes in complex terrain

Arslan Salim Dar

In this thesis, we explored the effect of certain terrain-induced flow phenomena on the development of wind turbines sited in complex terrain. A combined experimental and analytical approach is used to study wind turbine wakes in different types of complex ...

EPFL2024

Reactive collision-free motion generation in joint space via dynamical systems and sampling-based MPC

Aude Billard, Nadia Barbara Figueroa Fernandez, Mikhail Koptev

Dynamical system (DS) based motion planning offers collision-free motion, with closed-loop reactivity thanks to their analytical expression. It ensures that obstacles are not penetrated by reshaping a nominal DS through matrix modulation, which is construc ...

Sage Publications Ltd2024

Comparison of selected surface level ERA5 variables against in‐situ observations in the continental Arctic

Jules Gros-Daillon, Julia Schmale, Jakob Boyd Pernov

In this study, data from 17 ground-based, continental Arctic observatories areused to evaluate the performance of the European Centre for Medium-RangeWeather Forecasts Reanalysis version 5 (ERA5) reanalysis model. Three aspectsare evaluated: (i) the overal ...

2024

Fiber pumps for wearable fluidic systems

Herbert Shea, Vito Cacucciolo, Michael James Henry Smith

Incorporating pressurized fluidic circuits into textiles can enable muscular support, thermoregulation, and haptic feedback in a convenient wearable form factor. However, conventional rigid pumps, with their associated noise and vibration, are unsuitable f ...

American Association for the Advancement of Science2023

Dynamic stall characterisation and control for vertical-axis wind turbines

Sébastien Le Fouest

According to the International Energy Agency, the global net-zero emissions objective requires the installed wind power capacity to increase 11-fold between 2020 and 2050. The scientific community has recently voiced concerns about the logistic feasibility ...

EPFL2023

Wind farm power density optimization according to the area size using a novel self-adaptive genetic algorithm

Fernando Porté Agel, Nicolas Otto Kirchner Bossi

This work studies the power density (PD) optimization in wind farms, and its sensitivity to the available area size. A novel genetic algorithm (PDGA) is introduced, which optimizes PD and the turbine layout, by self-adapting to the PD and to the solutions ...

Pergamon-Elsevier Science Ltd2023

Research data supporting 'Fiber pumps for wearable fluidic systems'

Herbert Shea, Vito Cacucciolo, Michael James Henry Smith

The dataset supporting 'Fiber pumps for wearable fluidic systems', published in Science in March 2023. In this work, we present a fluidic pump in the form of a flexible and stretchable tube. These tubes - or 'fiber pumps' - can generate significant fluidic ...

2023

Gaia Focused Product Release: Radial velocity time series of long-period variables

Stephan Morgenthaler, Shuangqing Liao

Context. The third Gaia Data Release (DR3) provided photometric time series of more than 2 million long-period variable (LPV) candidates. Anticipating the publication of full radial-velocity data planned with Data Release 4, this Focused Product Release (F ...

Edp Sciences S A2023

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

The influence of the gas on the dynamics of cavitation bubbles

Davide Bernardo Preso

Cavitation bubbles, extensively investigated in fluid mechanics, present enduring challenges in hydraulic machinery, while holding considerable potential for practical applications in biomedicine and sonochemistry. Despite more than a century of research, ...

EPFL2023

Radiation-tolerant Multichannel Dew Point Temperature Monitoring System for High Energy Physics Applications

Amar Kapic

The next generation of high-energy physics (HEP) detectors will predominantly be silicon-based. As pixel sensor technology gains momentum and the number of channels surpasses one billion (for a volume of approximately 20 m3) to achieve the high resolution ...

EPFL2023

Cross-code verification of non-neutral ABL and single wind turbine wake modelling in LES

Fernando Porté Agel, Marwa Souaiby

Large Eddy Simulations (LES) of atmospheric boundary layer (ABL) flow with the actuator disc (AD) for turbine modelling is a widely used method of simulating wind farm flows. Hence, it is important to understand the requirements for achieving a good compar ...

IOP PUBLISHING LTD2023