Publication
The aim of this work is to develop a microstructured reactor based on filamentous catalysts for the Oxidative Steam-Reforming of Methanol (OSRM), to produce hydrogen as feed for a fuel cell, in an autothermal way. Hydrogen is produced by the methanol Steam-Reforming (SR) reaction. This endothermic reaction requires an external heat source which is, in our case, generated by methanol oxidation. The coupling of these two reactions – SR and oxidation, called oxidative steam-reforming of methanol – is performed in a single reactor. As the oxidation is much faster than SR, it occurs in the first part of the reactor, the SR takes place in the second part. If a conventional fixed bed reactor is used, pronounced axial temperature profiles are developed: a hot–spot due to the exothermicity of the oxidation is generated at the entrance followed by a cold–spot due to the SR. The high temperature may damage the catalyst and the low temperature diminishes the rate of reforming reaction leading to poor reactor performance. Thus the temperature control is crucial. Consequently, a microstructured reactor is used. This kind of reactor has multiple parallel channels with a diameter ranging from ten to several hundreds micrometers. These submillimetric dimensions lead to a high surface to volume ratio and a much higher heat transfer coefficient than in the traditional heat exchangers. These characteristics allow to increase heat exchange between reactions and to avoid hot–spot formation. In this work, brass wires introduced into a macro tubular reactor parallel to the walls are used to create the microstructure. Brass is chosen because of its composition – it contains copper and zinc catalyzing the reforming/oxidation of methanol – and for its high heat conductivity which ensures heat exchange improvements. Moreover the small diameter of reactor channels ensures narrow residence time distribution, leading to high selectivity, and a short residence time, improving reactors dynamic. The characteristics mentioned above are verified in chapter 4 for the reactor developed during this study. The hydrodynamic of this reactor is presented under the influence of wire diameter and catalyst preparation treatment. The flow in the microstructure is close to a plug flow: a Bodenstein number of 105 is obtained for brass wires with a diameter of 480μm. Concerning catalytic treatment, it doesn't appear to modify the hydrodynamic. Compared to a fixed bed reactor, the measured residence time distribution for our microstructured reactor is found to be much narrower; the pressure drops are also smaller. Chapter 5 focuses on the reaction conditions for SR of methanol, the reaction that generates hydrogen. These conditions are determined by using an industrial catalyst (based on copper –zinc – aluminium) and by comparing the catalytic activity measured in our conditions with the ones found in the literature. A molar water to methanol ratio of 1.2 is chosen in order to avoid carbon monoxi
Andreas Pautz, Oskari Ville Pakari, Vincent Pierre Lamirand