Novel structured adsorber and oxidation catalysts for the removal of VOCs in low concentration

One possibility for the removal of volatile organic compounds (VOCs) is catalytic oxidation. For the removal of VOCs in low concentration (≲ 3000 ppmv for propane) it is not possible to sustain the required oxidation temperature over the catalyst without external heating. An approach to overcome this problem is to concentrate the VOC by adsorption, in a "two-step adsorption-incineration" process. This is an unsteady state process in which the VOC laden effluent gas is cleaned by passing it through an adsorber. Once the adsorber is saturated the VOC is desorbed by heating and purging. The concentrated VOC from the desorber can then be oxidized over the catalyst, producing enough heat to sustain the oxidation temperature. Conventional adsorbents have some drawbacks such as tailing during desorption due to the large particle size, high pressure drop and hot-spot formation. The objective of this work was to develop, characterize and test the adsorbent and catalyst, with low resistance to mass transfer resulting from thin films of active material, for the two-step adsorption-incineration process. Both the adsorbent and the oxidation catalysts were supported on sintered metal fibers (SMF). This is a novel, structured support offering several advantages over conventional randomly packed beds: Low pressure drop, due to the high porosity of the SMF, which is important where large flow rates and/or high quantities of gas must be treated. High thermal conductivity, due to the metallic nature, leading to smaller temperature gradients in the fixed-bed. A very high geometric surface area, due to the small fiber size. On the order of 200,000 m2/m3 with a fiber diameter of 20 µm. Furthermore, a mathematical model was developed to show the feasibility of the coupling of the two steps in the process. The adsorber was made from a thin, homogeneous film of MFI-type zeolite covering the fibers of the SMF. The film was grown by the seed-film method by hydrothermal treatment. A 3 µm film was obtained with 10 wt.% zeolite on the fiber after 24 h synthesis at 125 °C. This material had a specific surface area of 30 m2/g. The adsorption equilibrium of propane was described well by the Langmuir isotherm and the heat of adsorption was found to be ΔH0ads = - 43.1 kJ/mol. Isothermal breakthrough curves were measured as a function of temperature and film thickness. A mathematical model, comprised of a tanks-in-series model with a linear driving force (LDF) mass transfer description, successfully described the breakthrough behavior. The overall mass transfer was found to be solely due to diffusion in the zeolite film. However, the thin films show very low resistance to mass transfer leading to low internal concentration gradients and efficient utilization of the adsorbent. The pressure drop was measured and compared to that of a randomly packed fixed-bed of spheres. The equivalent diameter for a constant volumetric flow rate and superficial cross sectional area was dp = 18