Publications related to Development of a New Generation of Ammonia Sensors on Printed Polymeric Hotplates

Colloidal Atomic Layer Deposition on Nanocrystals Using Ligand-Modified Precursors

Raffaella Buonsanti, Anna Loiudice, Petru Pasquale Albertini, Ona Segura Lecina, Coline Marie Agathe Boulanger, Philippe Benjamin Green, Mark Adrian Newton, Krishna Kumar, Jari Leemans

Atomic layer deposition (ALD) is a method to grow thin metal oxide layers on a variety of materials for applications spanning from electronics to catalysis. Extending ALD to colloidally stable nanocrystals promises to combine the benefits of thin metal oxi ...

Amer Chemical Soc2024

Font Side Solutions for c-Si Solar Cells with High-Temperature Passivating Contacts

Ezgi Genç

In this work, we studied the potential of using thin films deposited by plasma-enhanced chemical vapor deposition (PECVD) for two main purposes: introducing an n-type passivating contact at the front of a TOPCon solar cell, or simplifying the fabrication o ...

EPFL2024

Innovative thermophysical characterization of an ATF composite cladding: the case of silicon carbide

Andrea Cavaliere

Nuclear power is a powerful technology that plays an important role in the fight against climate change, and research is continuously engaged in studies that could further improve its safety. After the Fukushima accident, Accident Tolerant Fuels research h ...

EPFL2024

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Johann Michler, Ivo Utke, Xavier Maeder

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

Shortwave Infrared-Sensitive, Narrowband Organic Upconversion Devices with a Gain

Wei-Hsu Hu

Sensing and imaging of light in the shortwave infrared (SWIR) range is increasingly used in various fields, including bio-imaging, remote sensing, and semiconductor process control. SWIR-sensitive organic photodetectors (OPDs) are promising because organic ...

EPFL2024

Study of growth-induced point defects and their impact on InGaN-based optoelectronic devices

Yao Chen

GaN exhibits a decomposition tendency for temperatures far below its melting point and common growth temperatures used in metal-organic vapour phase epitaxy (MOVPE).This characteristic is known to be a major obstacle for realising GaN bulk substrate. There ...

EPFL2024

Piezoelectric and elastic properties of Al0.60Sc0.40N thin films deposited on patterned metal electrodes

Luis Guillermo Villanueva Torrijo, Silvan Stettler, Marco Liffredo, Nan Xu, Federico Peretti

Sc-doped aluminum nitride (AlScN) allows for piezoelectric devices with large electromechanical coupling and the benefits increase with larger Sc doping in the film. However, with a larger Sc concentration, the process window narrows, and it is necessary t ...

2024

Durable Perovskite Solar Cells with 24.5% Average Efficiency: The Role of Rigid Conjugated Core in Molecular Semiconductors

Michael Graetzel, Shaik Mohammed Zakeeruddin, Peng Wang, Felix Thomas Eickemeyer, Ming Ren

Efficient and robust n-i-p perovskite solar cells necessitate superior organic hole-transport materials with both mechanical and electronic prowess. Deciphering the structure-property relationship of these materials is crucial for practical perovskite sola ...

Wiley-V C H Verlag Gmbh2024

Microstructural and electrical characterization of high temperature passivating contacts for silicon solar cells

Sofia Libraro

Recombination at metal/semiconductor interfaces represents the main limitation in mainstream c-Si solar cells, primarily based on the passivated emitter and rear cell (PERC) concept. Full-area passivating contacts based on SiOx/poly-Si stacks are a candida ...

EPFL2024

Towards Scalable Electronics: Synthetic 2D Materials for Large-Area 2D Circuit Integration

Zhenyu Wang

In the past decades, a significant increase of the transistor density on a chip has led to exponential growth in computational power driven by Moore's law. To overcome the bottleneck of traditional von-Neumann architecture in computational efficiency, effo ...

EPFL2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Thermal conductivity of Li 3 PS 4 solid electrolytes with ab initio accuracy

Michele Ceriotti, Federico Grasselli

The vast amount of computational studies on electrical conduction in solid-state electrolytes is not mirrored by comparable efforts addressing thermal conduction, which has been scarcely investigated despite its relevance to thermal management and (over)he ...

Amer Physical Soc2024

Nanostructure and Optical Property Tailoring of Zinc Tin Nitride Thin Films through Phenomenological Decoupling: A Pathway to Enhanced Control

Aïcha Hessler-Wyser, Johann Michler, Amit Sharma, Daniele Casari, Caroline Hain, Thomas Nelis

This work addresses the need for precise control of thin film sputtering processes to enable thin film material tailoring on the example of zinc tin nitride (ZTN) thin films deposited via microwave plasma-assisted high power reactive magnetron sputtering ( ...

Amer Chemical Soc2024

Electrochemical sensors modified with iron oxide nanoparticles/ nanocomposites for voltammetric detection of Pb (II) in water: A review

Sandro Carrara

Permissible limits of Pb 2+ in drinking water are being reduced from 10 mu gL -1 to 5 mu gL -1 , which calls for rapid, and highly reliable detection techniques. Electrochemical sensors have garnered attention in detection of heavy metal ions in environmen ...

Cell Press2024

Vapor compression and energy dissipation in a collapsing laser-induced bubble

Mohamed Farhat, Danail Obreschkow, Armand Baptiste Sieber, Davide Bernardo Preso

The composition of the gaseous phase of cavitation bubbles and its role on the collapse remains to date poorly understood. In this work, experiments of single cavitation bubbles in aqueous ammonia serve as a novel approach to investigate the effect of the ...

Aip Publishing2024

III-V Nitride Semiconductors Deposited At Low Temperature For Photovoltaic Applications

Jonathan Emanuel Thomet

This thesis reports on the study and use of low temperature processes for the deposition of indium gallium nitride (InGaN) thin films in order to alleviate some of the present drawbacks of its monolitic deposition on silicon for photovoltaic applications. ...

EPFL2023

Interlocking modular microfluidic cooling substrates for future high energy physics experiments

Massimo Angeletti

In high energy physics, semiconductor-based sensors are widely used in particle tracking applications. These sensors are typically glued on low-mass cooling substrates, which guarantee the correct thermal management and, at the same time, minimise their in ...

EPFL2023

Drift-Diffusion Simulations of Charge Transport and Trap Dynamics in Organic Semiconductor Materials

Camilla Arietta Vael-Garn

Polymeric semiconductors have gained significant attention in the field of organic electronics due to their unique properties and potential applications. Through their ability to transport charge carriers and to absorb or emit light, they have attracted mu ...

EPFL2023

Plasma-Assisted Hybrid Vapour Deposition Technology for Thin Film Fabrication

Caroline Hain

Continuous development of thin film deposition technologies is essential for the fabrication of films that meet the specific requirements of their target applications and working conditions. Therefore, it is necessary to increase the number of accessible a ...

EPFL2023

Control of intermetallics in the interface in directed energy deposition of titanium on stainless steel 316L

Di Cui

Application of a single metal or alloy is often restricted by its properties from optimal combination of performance and cost. Therefore, there is a vast need of joining dissimilar metals for various applications in biomedical, aerospace, automobile and ma ...

EPFL2023