Publications associées à Mécanique des sols

X-ray chemical imaging for assessing redox microsites within soils and sediments

Redox reactions underlie several biogeochemical processes and are typically spatiotemporally heterogeneous in soils and sediments. However, redox heterogeneity has yet to be incorporated into mainstream conceptualizations and modeling of soil biogeochemist ...

Frontiers Media Sa2024

Pore-pressure coefficients for unsaturated soils: generalized effective stress approach

Lyesse Laloui, Alessio Ferrari, Angelica Tuttolomondo

Geotechnical problems with total stress changes occurring rapidly relative to the soil consolidation time can be conveniently addressed using an effective stress-based approach. For saturated states, analytical formulations of pore-pressure coefficients ad ...

CANADIAN SCIENCE PUBLISHING2023

Data-driven 1D wave propagation for site response analysis

Jean-François Molinari, Antonio Joaquin Garcia Suarez, Sacha Zenon Wattel

Prediction of ground motion triggered by earthquakes is a prime concern for both the seismology community and geotechnical earthquake engineering one. The subfield occupied with such a problem is termed site response analysis (SRA), its one-dimensional fla ...

WILEY2023

INFLUENCE OF VOIDS ON THICK DCB JOINT BEHAVIOR

Véronique Michaud, Anastasios Vassilopoulos, Jialiang Fan

The influence of voids on the quasi-static Mode I fracture performance of thick adhesive joints was investigated in this article. Double Cantilever Beam (DCB) joints were manufactured with glass fiber reinforced epoxy adherends and SikaPower®-830 epoxy adh ...

2023

Drained Clay-Pipe Interface Resistance at Low Normal Stresses and Elevated Temperatures

Roba Houhou

Offshore pipelines that transport hydrocarbons under high pressure and high temperature are usually thermally insulated to maintain an elevated temperature and prevent any heat loss to the surroundings. However, the temperatures at the outer-wall of the pi ...

AMER SOC CIVIL ENGINEERS2023

Modeling the mechanics and rheology of porous and granular media: an elastoplastic continuum approach

Lars Kristoffer Uhlen Blatny

The complex mechanics of porous and granular media play a significant role in various industrial processes and natural phenomena. As an example, understanding the mechanics of how failure occurs, localizes and propagates in porous brittle solids under vari ...

EPFL2023

Addressing the challenges of homogeneity, quality control and waste handling in soil bio-cementation: A large-scale experiment

Lyesse Laloui, Dimitrios Terzis, Ray Harran

In an attempt to go beyond the conventional laboratory experiments widely reported in literature around the emerging technique of soil bio-cementation, this work addresses key challenges related to its large-scale application. Precisely, a state-of-the-art ...

JAPANESE GEOTECHNICAL SOC2023

Single-Well Pore Pressure Preconditioning for Enhanced Geothermal System Stimulation

Marie Estelle Solange Violay, Mathias Alexandre David Lebihain, Barnaby Padraig Fryer

The stress state is an important parameter in terms of both earthquake nucleation and rupture. Here, a new stimulation technique is proposed for Enhanced Geothermal Systems (EGSs), which have previously been burdened with a number of high-profile incidence ...

2023

A fully-coupled highly-parallelized geomechanical simulator for assessing induced seismicity

Jean-François Molinari, Brice Tanguy Alphonse Lecampion, Guillaume Anciaux, Nicolas Richart, Emil Gallyamov

Induced seismicity caused by anthropogenic modification of the subsurface effective stress state has been observed in a number of industrial applications -- from hydrocarbon extraction (e.g., Groningen [1]), drilling waste-water disposal (e.g., [2]) to the ...

2023

On the Fabric of a 3D Printed Soil

Alessio Ferrari

3D printing of earthen materials is on the rise in the field of Additive Manufacturing (AM) due to the opportunity this technique offers to realize structures and manufacts with low environmental impacts, but very little is known about the hydromechanical ...

2023

Experimental characterization of root-reinforced riparian sediment deposits in a restored and widened river course

Giovanni De Cesare, Paolo Perona

The Arbogne River is located mainly in the Swiss canton of Fribourg. The River was meandering through the plane at a very low gradient and several exceptional historic floods with large sediment accumulation are mentioned. After important river training wo ...

2023

Global Mapping of Potential and Climatic Plant‐Available Soil Water

Sara Bonetti, Dani Or

The estimation of plant-available soil water (PASW) is essential to quantify transpiration fluxes, the onset of heatwaves, irrigation water management, land-use decisions, vegetation ecology, and land surface memory in climate models. PASW is the amount of ...

2023

3-D contact and pore network analysis of MICP cemented sands

Dimitrios Terzis, Nimisha Roy

The study describes a comprehensive methodology to evaluate X-Ray micro-computed tomography data from sand samples and to characterize their 3D microstructural properties. Fine and medium-grained sands are analyzed in their natural and bio-cemented states. ...

SPRINGER2023

Influence of a lossy ground on the lightning performance of overhead transmission lines

Farhad Rachidi-Haeri, Rafael Silva Alipio

This paper investigates the impact of incorporating both displacement currents and frequency-dependent soil parameters in the calculation of the ground-return impedance for the determination of the backflashover rate of 138 kV and 230 kV overhead transmiss ...

Elsevier2023

Investigation of the effect of mineral dissolution on the geomechanical behaviour of geomaterials

Taeheon Kim

Geotechnical engineering scenarios engaged in internal erosion or mineral dissolution were found worldwide, from CO2 sequestration projects to internal erosion of earth dams. Materials subjected to loss of solid phase from their internal fabric vary from s ...

EPFL2022

Freezing-induced stiffness and strength anisotropy in freezing clayey soil: Theory, numerical modeling, and experimental validation

Gioacchino Viggiani, Edward Carlo Giorgio Andò

This paper presents a combined experimental-modeling effort to interpret the coupled thermo-hydro-mechanical behaviors of the freezing soil, where an unconfined, fully saturated clay is frozen due to a temperature gradient. By leveraging the rich experimen ...

WILEY2022

Life cycle environmental assessment of retaining walls in unsaturated soils

Alessio Ferrari, Gianluca Speranza

Retaining structures above groundwater level support soils that are usually in a state of partial saturation and subject to the actions of atmospheric agents. The current design approach considers the possible extremes of soil conditions - either totally d ...

ELSEVIER2022

Failure mechanism of fine-grained soil-structure interface for energy piles

Lyesse Laloui, Elena Ravera

The response of the soil-structure interface can significantly affect the performance of any geotechnical structure. Thermal cycles are a new factor that influence the response to all structures that have an energy function in addition to the structural on ...

2022

Swelling and shrinkage of partially saturated gas shales: from laboratory tests to an effective stress framework

Jinwoo Kim

Gas shale swelling during hydraulic stimulation is one of the major challenges in unconventional gas development. It is hypothesized that the large volumetric strain upon water imbibition is a consequence of dramatic changes in capillary pressure and disjo ...

EPFL2022

Role of Stress History on the Swelling-Shrinkage Behavior of Compacted Scaly Clay

Alessio Ferrari

Compacted scaly clays are complex geomaterials widely used for the realization of dam cores and waste dump liners. This research aims to investigate the swelling/shrinkage behavior of these geomaterials subjected in an oedometric cell to complex hydromecha ...

ASCE-AMER SOC CIVIL ENGINEERS2022