Publications associées à Montmorillonite

Insights from an extensive triaxial testing campaign on a shale for comparative site characterization of a deep geological repository

Lyesse Laloui, Alessio Ferrari, Eleonora Crisci

Several boreholes were drilled for site comparison of a deep geological repository (DGR) in Northern Switzerland. The main target of the exploration program was the >100m thick Opalinus Clay, the designated host rock encountered at approximately 450 to 100 ...

Elsevier2024

Durability Challenges of Low-Grade Calcined Clay Opposed to High-Volume Fly Ash in General Purpose Concrete

Karen Scrivener, Matea Flegar

With the decrease in availability of common supplementary cementitious materials (SCMs) such as fly ash in Europe, the search for appropriate SCMs should be dealt with locally. A com-bination of abundant low-grade calcined clay and limestone powder has pro ...

AMER SOC TESTING MATERIALS2023

Does carbon footprint reduction impair mechanical properties and service life of concrete?

Karen Scrivener, Diana Londoño Zuluaga

The aim of this study is to evaluate how much the changes in the concrete mix design, which enable carbon footprint reduction, are impacting mechanical properties and predicted service life of concrete structure. The starting point of this study was concre ...

SPRINGER2023

Influence of Low- to Medium-Kaolinite Clay on the Durability of Limestone Calcined Clay Cement (LC3) Concrete

Karen Scrivener, Matea Flegar

The kaolinite content is principally responsible for the durability performance of Limestone Calcined Clay Cement (LC3), which calls into question its global applicability. The clay supply has a significant impact on the LC3 system's reduced carbon footpri ...

MDPI2023

Atomistic modeling of C-S-H: bulk and surface

Ziga Casar

By replacing part of Portland cement with so-called supplementary cementitious materials (SCMs) it is possible to reduce the CO2 footprint of the cement industry. These SCMs are commonly limestone, calcined clay, slag and fly ash. While doing so the early ...

EPFL2023

Characterisation and hydration kinetics of beta-C2S synthesised with K2SO4 as dopant

Karen Scrivener, Franco Alberto Zunino Sommariva, Shashank Bishnoi, Sreejith Krishnan

In this study, a protocol for synthesising beta-C2S using K2SO4 as a dopant has been reported. Quantitative X-Ray diffraction was used to characterise synthesised samples. It was observed that it is possible to synthesise beta-C2S with high purity (>96 wt% ...

Pergamon-Elsevier Science Ltd2023

Data-driven optimization tool for the functional, economic, and environmental properties of blended cement concrete using supplementary cementitious materials

Hisham Tarek Mohamed Hafez

The need to produce more sustainable concrete is proving imminent given the rising environmental concerns facing the industry. Blended cement concrete, based on any of the prominent supplementary cementitious materials (SCMs) such as fly ash, ground granul ...

ELSEVIER2023

Properties and occurrence of clay resources for use as supplementary cementitious materials: a paper of RILEM TC 282-CCL

Franco Alberto Zunino Sommariva, Ruben Anton Snellings, Alastair Thomas Matthew Marsh, Adrian Alujas Diaz

The use of clays as resource of supplementary cementitious materials (SCMs) for a new generation of low-carbon cements and concretes is currently the subject of intense research efforts. To this purpose, a large number of clay resources have been explored, ...

SPRINGER2022

The Challenge of Grinding Ternary Blends Containing Calcined Clays and Limestone

Karen Scrivener, Franco Alberto Zunino Sommariva, Juan Alberto Ribalta Quesada

The inclusion of high specific surface materials such as calcined clays in cementitious systems enhances the hydration of clinker products at very early ages, but it may also increase water demand; thus, the pursuit of a flowing concrete may demand an incr ...

MDPI2022

Hydration and mixture design of calcined clay blended cements: review by the RILEM TC 282-CCL

Karen Scrivener, Franco Alberto Zunino Sommariva, Mohsen Ben Haha, François Henri Avet, Anuj Parashar, Yuvaraj Dhandapani, Sreejith Krishnan

The RILEM technical committee 282-CCL: Calcined Clays as Supplementary Cementitious Materials, investigates all the aspects related to calcined clays, from clay exploration and characterization to calcination process, hydration reactions and concrete prope ...

SPRINGER2022

Paper of RILEM TC 282-CCL: mineralogical characterization methods for clay resources intended for use as supplementary cementitious material

Franco Alberto Zunino Sommariva, Ruben Anton Snellings, Alastair Thomas Matthew Marsh, Adrian Alujas Diaz

To respond to the rapid introduction and development of calcined clays as supplementary cementitious material (SCM), the toolbox of characterization methods for cementitious materials requires extension to raw clay characterization. Borrowing concepts and ...

SPRINGER2022

Oxidation of pyrite (FeS2) and troilite (FeS) impurities in kaolinitic clays after calcination

Karen Scrivener, Franco Alberto Zunino Sommariva

Valorisation of locally available clays for producing blended cements is crucial for a widespread adoption of sustainable binders incorporating these materials. In some places, clays can be intermixed with small amounts of iron sulfides, which could eventu ...

SPRINGER2022

Clay calcination technology: state-of-the-art review by the RILEM TC 282-CCL

Karen Scrivener, Franco Alberto Zunino Sommariva, François Henri Avet, Alastair Thomas Matthew Marsh, Mohsen Ben Haha, Shashank Bishnoi, Adrian Alujas Diaz, Anuj Parashar

The use of calcined clays as supplementary cementitious materials provides the opportunity to significantly reduce the cement industry's carbon burden; however, use at a global scale requires a deep understanding of the extraction and processing of the cla ...

SPRINGER2022

Pre-bcc: A novel integrated machine learning framework for predicting mechanical and durability properties of blended cement concrete

Hisham Tarek Mohamed Hafez

Partially replacing ordinary Portland cement (OPC) with low-carbon supplementary cementitious materials (SCMs) in blended cement concrete (BCC) is perceived as the most promising route for sustainable concrete production. Despite having a lower environment ...

ELSEVIER SCI LTD2022

Mechanistic classification and benchmarking of polyolefin depolymerization over silica-alumina-based catalysts

Paul Joseph Dyson, Mounir Driss Mensi, Felix Daniel Bobbink, Antoine Philippe Van Muyden, Wei-Tse Lee, Jed Russell Carullo

Carbon-carbon bond cleavage mechanisms play a key role in the selective deconstruction of alkanes and polyolefins. Here, we show that the product distribution, which encompasses carbon range and formation of unsaturated and isomerization products, serves a ...

Nature Research2022

Concrete cancer : characterization of Alkali Silica Reaction early stage products by electron microscopy

Solène Anne-Lise Albinski

Concrete deterioration is a natural process, which has to be carefully monitored over a the service life of a structure. The Alkali-Silica Reaction (ASR) is a slow-process degradation, which devel-ops over decades and is therefore difficult to predict. Sin ...

EPFL2022

Studies on the mechanical evolution of compacted bentonite subjected to environmental actions

Jose Antonio Bosch Llufriu

Deep geological disposal is currently the most feasible option for the long-term isolation of radioactive waste, consisting in emplacing the waste into tunnels or drifts excavated at great depths in suitable geological formations. The use of bentonite, a h ...

EPFL2021

The Influence of some calcined clays from Nigeria as clinker substitute in cementitious systems

Karen Scrivener, François Henri Avet, Akindehinde Ayotunde Akindahunsi

This paper examines the possibility of the use of some clays calcined from Nigeria as partial substitutes for clinker in the production of Limestone Calcined Clay Cement (LC3). The clays were calcined in the oven at a temperature of 800 degrees C and for o ...

2020

Porous granules by freeze granulation of Pickering emulsions stabilized with halloysite particles

Paul Bowen

Pickering emulsions stabilized with a natural silicate mineral, halloysite, were dried by freeze granulation in order to prepare porous granules. Different formulations were studied, by varying the pH of the suspension, the ionic strength and with the addi ...

ELSEVIER2020

Advances in heterogeneous catalysis for the synthesis of polyoxymethylene dimethyl ethers

Christophe Jean Baranowski

Our society is engaged in a major shift towards more sustainable industries. The required transition from fossils to renewable resources with low greenhouse gas emission is specifically challenging in the transportation sector where high thermal efficiency ...

EPFL2020