Publications associées à Chaux (matière)

Experimental Investigation on Size-Effect of Rubble Stone Masonry Walls Under In-Plane Horizontal Loading: Overview and Preliminary Results

Rubble stone masonry is a common construction typology of historical city centres and vernacular architecture. While past earthquakes have shown that it is one of the most vulnerable masonry construction typologies, there are few experimental campaigns giv ...

2024

Decarbonization potential of steel fibre-reinforced limestone calcined clay cement concrete one-way slabs

Hisham Tarek Mohamed Hafez

This study deals with a comparison of the environmental performance of one-way slabs utilizing steel fibrereinforced limestone calcined clay cement (LC3) concrete with the control case of Ordinary Portland cement concrete. The experimental program constitu ...

Elsevier Sci Ltd2024

Characterisation and hydration kinetics of beta-C2S synthesised with K2SO4 as dopant

Karen Scrivener, Franco Alberto Zunino Sommariva, Shashank Bishnoi, Sreejith Krishnan

In this study, a protocol for synthesising beta-C2S using K2SO4 as a dopant has been reported. Quantitative X-Ray diffraction was used to characterise synthesised samples. It was observed that it is possible to synthesise beta-C2S with high purity (>96 wt% ...

Pergamon-Elsevier Science Ltd2023

Going Below 50% Clinker Factor in Limestone Calcined Clay Cements (LC3): A Comparison with Pozzolanic Cements from the South American Market

Karen Scrivener, Franco Alberto Zunino Sommariva

Limestone calcined clays are a promising technology as they offer similar performance to OPC from 7 days onwards, while enabling a reduction of the clinker content of 50%. In some regions of the world like South America, pozzolanic cements (i.e., blended c ...

SPRINGER INTERNATIONAL PUBLISHING AG2023

Influence of Low- to Medium-Kaolinite Clay on the Durability of Limestone Calcined Clay Cement (LC3) Concrete

Karen Scrivener, Matea Flegar

The kaolinite content is principally responsible for the durability performance of Limestone Calcined Clay Cement (LC3), which calls into question its global applicability. The clay supply has a significant impact on the LC3 system's reduced carbon footpri ...

MDPI2023

Unidirectional penetration approach for characterizing sulfate attack mechanisms on cement mortars and pastes

Karen Scrivener, Qiao Wang, William Wilson

Degradation of cementitious materials by sulfate ions is commonly classified into chemical and physical sulfate attack. So-called "physical" attack dominates in many field situations, but laboratory testing focuses on "chemical" attack under full-immersion ...

Pergamon-Elsevier Science Ltd2023

Investigation of phase formation, microstructure and mechanical properties of LC3 based autoclaved aerated blocks

Karen Scrivener

This study investigates the microstructure, phase formation, and mechanical properties of LC3-50 based auto-claved aerated blocks. The microstructure and phase formation is studied using SEM-EDS and X-ray diffraction techniques. The fresh and hardened prop ...

ELSEVIER SCI LTD2022

Report of RILEM TC 267-TRM: Improvement and robustness study of lime mortar strength test for assessing reactivity of SCMs

Karen Scrivener, Ruben Anton Snellings, Mohsen Ben Haha, Xuerun Li, Shashank Bishnoi, Pawel Tadeusz Durdzinski, Mathieu Antoni, Anuj Parashar, Yuvaraj Dhandapani

RILEM TC 267-TRM is studying tests for the reactivity supplementary cementitious materials (SCMs). In the first phase, the lime reactivity (LR) test, which is standardised in Indian standard (IS)-1727, gave promising correlations with 90-days cement mortar ...

SPRINGER2022

Pre-bcc: A novel integrated machine learning framework for predicting mechanical and durability properties of blended cement concrete

Hisham Tarek Mohamed Hafez

Partially replacing ordinary Portland cement (OPC) with low-carbon supplementary cementitious materials (SCMs) in blended cement concrete (BCC) is perceived as the most promising route for sustainable concrete production. Despite having a lower environment ...

ELSEVIER SCI LTD2022

ECO2 framework assessment of limestone powder concrete slabs and columns

Hisham Tarek Mohamed Hafez

Producing limestone powder requires comparably far less energy than the production of ordinary Portland cement (OPC), making it a promising sustainable solution for partial replacement of OPC in concrete. Lower production energy could be translated into lo ...

ELSEVIER2022

Hydration and durability of fast hardening binders incorporating supplementary cementitious materials

Sarra El Housseini

The use of supplementary cementitious materials (SCMs) is widely considered the most promis-ing approach to reduce CO2 emissions relative to cement production. SCMs are not commonly present in binders used for special applications. On the other hand, due t ...

EPFL2022

Freezing-induced stiffness and strength anisotropy in freezing clayey soil: Theory, numerical modeling, and experimental validation

Gioacchino Viggiani, Edward Carlo Giorgio Andò

This paper presents a combined experimental-modeling effort to interpret the coupled thermo-hydro-mechanical behaviors of the freezing soil, where an unconfined, fully saturated clay is frozen due to a temperature gradient. By leveraging the rich experimen ...

WILEY2022

Microstructural developments of limestone calcined clay cement (LC3) pastes after long-term (3 years) hydration

Karen Scrivener, Franco Alberto Zunino Sommariva

LC3 is one of the most promising alternatives for a high-performance blended cement with a significantly lower clinker content and with potential for worldwide adoption. For this reason, understanding its long-term performance is relevant to ensure service ...

Pergamon-Elsevier Science Ltd2022

Resistance of cementitious materials to sulfate attack: quantifying performance with a reliable unidirectional approach

Qiao Wang

Depending on the environmental conditions, concrete materials can come into contact with sulfate ions which are widely present in rivers, underground water, sewers, seawater and soil. Sulfates can react with the cement paste in concrete and cause damage wh ...

EPFL2022

Hydration and mixture design of calcined clay blended cements: review by the RILEM TC 282-CCL

Karen Scrivener, Franco Alberto Zunino Sommariva, Mohsen Ben Haha, François Henri Avet, Anuj Parashar, Yuvaraj Dhandapani, Sreejith Krishnan

The RILEM technical committee 282-CCL: Calcined Clays as Supplementary Cementitious Materials, investigates all the aspects related to calcined clays, from clay exploration and characterization to calcination process, hydration reactions and concrete prope ...

SPRINGER2022

The Challenge of Grinding Ternary Blends Containing Calcined Clays and Limestone

Karen Scrivener, Franco Alberto Zunino Sommariva, Juan Alberto Ribalta Quesada

The inclusion of high specific surface materials such as calcined clays in cementitious systems enhances the hydration of clinker products at very early ages, but it may also increase water demand; thus, the pursuit of a flowing concrete may demand an incr ...

MDPI2022

Reactive dicalcium silicate binders: Microstructure and transport properties

Adrian-Alexandru Pîrvan

The calcium silicate hydrates (C-S-H) are without doubt one of the most important hydration products in a hardened cement paste. Giving the complexity of the microstructure that forms by hydration of ordinary Portland cement (OPC) and the more recently use ...

EPFL2022

Limestone calcined clay cement and concrete: A state-of-the-art review

Karen Scrivener, Shashank Bishnoi, Meenakshi Sharma

This article reviews the rapidly developing state-of-the-art literature available on the subject of the recently developed limestone calcined clay cement (LC3). An introduction to the background leading to the development of LC3 is first discussed. The che ...

Pergamon-Elsevier Science Ltd2021

Understanding of the factors slowing down metakaolin reaction in limestone calcined clay cement (LC3) at late ages

Karen Scrivener, Paul Bowen, Mohsen Ben Haha, François Henri Avet, Yosra Briki

Factors which could explain the slowing down of the metakaolin reaction in LC3 blends are investigated. Portlandite availability and the presence of aluminium ions in the pore solution are shown not to be limiting factors. ...

Pergamon-Elsevier Science Ltd2021

Strength-promoting mechanism of alkanolamines on limestone-calcined clay cement and the role of sulfate

Karen Scrivener, François Henri Avet, Xuerun Li, Wilasinee Hanpongpun, Hong Huang

This paper reports the strength-promoting mechanism of alkanolamines on limestone-calcined clay cement (LC3). The hydration kinetics, phase formation and microstructure of LC3 with triethanolamine (TEA) or triisopropanolamine (TIPA) were investigated. TEA ...

Pergamon-Elsevier Science Ltd2021