Publications associées à Mass flow rate

Large-scale in-silico analysis of CSF dynamics within the subarachnoid space of the optic nerve

BackgroundImpaired cerebrospinal fluid (CSF) dynamics is involved in the pathophysiology of neurodegenerative diseases of the central nervous system and the optic nerve (ON), including Alzheimer's and Parkinson's disease, as well as frontotemporal dementia ...

BMC2024

Design, computational and experimental investigation of a small-scale turbopump for organic Rankine cycle systems

Jürg Alexander Schiffmann, Sajjad Zakeralhoseini

The hydraulic design, computational analysis, and experimental investigations of a high-speed small-scale turbopump for mobile waste heat recovery applications based on organic Rankine cycle systems are presented in this paper. Such applications demand hig ...

Elsevier2023

Highly Efficient Miniaturized Magnetorheological Valves Using Electropermanent Magnets

Yves Perriard, Christian Köchli, Sofia Lydia Ntella, Adrien Jean-Michel Thabuis, Kenny Jeanmonod, Bhawnath Tiwari

Fluidic systems enable actuation in various applications, such as automotive, medical, and industrial robotics. Miniaturized valves constitute a fundamental controlling element of modern fluidic systems, intriguing the interest of many researchers. This le ...

2023

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

Dynamic environmental flows using hydrodynamic-based solutions for sustainable hydropower

Giovanni De Cesare, Paolo Perona

Water diversions from rivers and torrents for anthropic uses of the resource alter the natural flow regime. As a measure, environmental flows have been prescribed and often are enforced by law to follow policies (e.g., minimal flow, proportional redistribu ...

CRC Press/Balkema2023

The effects of the tip clearance on the performance of small-scale turbopumps for ORC applications; analysis and modeling

Jürg Alexander Schiffmann, Sajjad Zakeralhoseini

In this paper, the influence of tip clearance on the performance of small-scale turbopumps is studied numerically on extensive parameter ranges suitable for organic Rankine cycle applications. A novel and fully parameterized design model is developed and u ...

Technical University of Munich2021

Homogenization-based design of microstructured membranes: wake flows past permeable shells

François Gallaire, Edouard Boujo, Pier Giuseppe Ledda, Giuseppe Antonio Zampogna

A formal framework to characterize and control/optimize the flow past permeable membranes by means of a homogenization approach is proposed and applied to the wake flow past a permeable cylindrical shell. From a macroscopic viewpoint, a Navier-like effecti ...

Cambridge University Press2021

Improved methodology for analysis and design of Molten Salt Reactors

Rodrigo Gonzalez Gonzaga De Oliveira

Molten Salt Reactors is a class of advanced reactors that is typically characterised by the presence of a molten inorganic salt of a fissile material as fuel. At the moment, this class of reactors is considered one of the promising options in the long run ...

EPFL2021

The Impact of Surfactants on the Inertial Separation of Bubbles in Microfluidic Electrolyzers

Demetri Psaltis, Seyyed Mohammad Hosseini Hashemi, Pooria Hadikhani

Improving the throughput of electrochemical reactions such as water electrolysis is an ongoing effort. In a membrane-less electrolyzer, product separation can be achieved via controlled two-phase flows within the electrochemical flow cells. In this case, i ...

ELECTROCHEMICAL SOC INC2020

Evaluation of a Dynamic Transfer Matrix for a Hydraulic Turbine

François Avellan, Andres Müller, Keita Yamamoto

It is well known that hydraulic machines experience various types of flow instabilities causing a negative influence on the system under off-design operations. The transfer matrix method correlating the flow properties in upstream and downstream of hydraul ...

2020

Microfluidics of binary liquid mixtures with temperature-dependent miscibility

Esther Amstad, Stefan Guldin

Liquid-liquid microfluidic systems rely on the intricate control over the fluid properties of either miscible or immiscible mixtures. Herein, we report on the use of partially miscible binary liquid mixtures that lend their microfluidic properties from a h ...

ROYAL SOC CHEMISTRY2020

Deformation of porous flexible strip in low and moderate Reynolds number flows

François Gallaire, Pedro Miguel Nunes Pereira de Almeida Reis, Matteo Pezzulla

We present results from a combined experimental and numerical investigation of the fluid-structure interaction of cantilevered porous flexible strips, towed through a fluid bath. We characterize the steady-state deformation of the strips and their associat ...

AMER PHYSICAL SOC2020

Numerical analysis for detecting head losses in trifurcations of high head in hydropower plants

François Avellan, Ramiro Gustavo Ramirez Camacho

Many different types of branching have been developed, such as bifurcation, trifurcation, and manifolds, among others. These configurations are used in penstocks to transport water from surge tanks to power houses in order to feed several turbines at the s ...

Pergamon-Elsevier Science Ltd2019

Cavitation induction by projectile impacting on a water jet

Mohamed Farhat

The present paper focuses on the simulation of the high-velocity impact of a projectile impacting on a water-jet, causing the onset, development and collapse of cavitation. The simulation of the fluid motion is carried out using an explicit, compressible, ...

PERGAMON-ELSEVIER SCIENCE LTD2019

Learning from droplet flows in microfluidic channels using deep neural networks

Demetri Psaltis, Seyyed Mohammad Hosseini Hashemi, Pooria Hadikhani

A non-intrusive method is presented for measuring different fluidic properties in a microfluidic chip by optically monitoring the flow of droplets. A neural network is used to extract the desired information from the images of the droplets. We demonstrate ...

Nature Research2019

Experimental Performance of Completely Passive Single and Recirculating Loop Thermosyphon Cooling Systems using Low GWP R1234ze and R1234yf

John Richard Thome

This paper proposes a novel concept for a loop thermosyphon cooling system, designed for the transistor module of a transformer. The thermosyphon uses a free convection cooled condenser, making the system completely passive, i.e. no energy consumption is n ...

IEEE2019

Simulation of the microfluidic mixing and the droplet generation for 3D printing of nuclear fuels

Manuel Alexandre Pouchon

This paper presents the computational fluid dynamics modeling of an additive manufacturing process that is candidate for the production of Gen IV nuclear reactor fuels. The modeled process combines the internal gelation to produce metal hydrous oxides with ...

ELSEVIER SCIENCE BV2019

Scalable production of double emulsion drops with thin shells

Esther Amstad, Antoine Claude Jean Vian

Double emulsions are often used as containers to perform high throughput screening assays and as templates for capsules. These applications require double emulsions to be mechanically stable such that they do not coalesce during processing and storage. A p ...

2018

Modeling and design guidelines for direct steam generation solar receivers

Sophia Haussener, Meng Lin

Concentrated solar energy is an ideal energy source for hightemperature energy conversion processes such as concentrated solar power generation, solar thermochemical fuel production, and solar driven hightemperature electrolysis. Indirectly irradiated sola ...

2018

Capsules with submicron shells: production, stability, and leakage behavior

Antoine Claude Jean Vian

Capsules are often employed to prolong the shelf-life of active ingredients such as many drugs, food additives, or cosmetic substances because they delay their oxidation or prevent interactions with molecules contained in the surrounding. If designed prope ...

EPFL2018