Publications associées à Embedded emissions

Embodied Carbon Premium for Cantilevers

David Michael Volpe Ruggiero, Paola Costanza Miglietta

This study addresses the critical need for sustainable architectural designs within the context of climate change and the significant role the built environment plays in greenhouse gas emissions. The focus of this paper is on understanding the influence of ...

2024

An explorative method to support design decisions based on carbon constraints and daylight sufficiency needs

Nazanin Rezaei Oghazi

The global construction industry contributes to 37% of carbon emissions associated to both building operations and construction. To help achieve the net-zero targets set by 2050, it is mandated to achieve a 50% reduction in carbon emissions by 2030. As we ...

EPFL2024

RE:SLAB — a load bearing system for open-ended component reuse in building structures

Corentin Jean Dominique Fivet, Jan Friedrich Georg Brütting, Dario Redaelli, Edisson Xavier Estrella Arcos, Alex-Manuel Muresan

The construction industry plays a major role in the high levels of greenhouse gas emissions, resource consumption, and waste generation observed nowadays. Key to the circular economy, structural component reuse arises as a promising solution to divert cons ...

2024

Equivalent black carbon concentration measured with an aethalometer AE33 during the Arctic Ocean 2018 expedition

Julia Schmale, Andrea Baccarini, Benjamin Jérémy Laurent Heutte

Equivalent black carbon (eBC) mass concentration was measured with a commercial aethalometer (model AE33, Magee Scientific, Berkeley, USA). Measurements were performed onboard of the Swedish icebreaker (I/B) Oden from August to September 2018 as part of th ...

EPFL Infoscience2024

Quantifying functional group compositions of household fuel-burning emissions

Satoshi Takahama, Amir Yazdani

Globally, billions of people burn fuels indoors for cooking and heating, which contributes to millions of chronic illnesses and premature deaths annually. Additionally, residential burning contributes significantly to black carbon emissions, which have the ...

Copernicus Gesellschaft Mbh2024

Spatio-temporal patterns and drivers of CH4 and CO2 fluxes from rivers and lakes in highly urbanized areas

Alexandre Buttler

Gaseous carbon exchange at the water-air interface of rivers and lakes is an essential process for regional and global carbon cycle assessments. Many studies have shown that rivers surrounding urban landscapes can be hotspots for greenhouse gas (GHG) emiss ...

Elsevier2024

Impact of CO2-rich seawater injection on the flow properties of basalts

Lyesse Laloui, Eleni Stavropoulou, Cesare Griner

Permanent CO storage in basalts through mineralisation offers a promising solution for reducing carbon emissions and mitigating climate change. This study focuses on the impact of potential mineralisation on the flow properties of the basaltic material. Fl ...

2024

Mesh-based topology, shape and sizing optimization of ribbed plates

In this paper, we present a new parameterization and optimization procedure for minimizing the weight of ribbed plates. The primary goal is to reduce embodied CO2 in concrete floors as part of the effort to diminish the carbon footprint of the construction ...

Springer2024

Multiscale Spatiotemporal Characterization of Embodied Environmental Performance of Building Structures in Geneva from 1850 to 2018

Corentin Jean Dominique Fivet, Catherine Elvire L. De Wolf, Serena Vanbutsele

Load-bearing systems in buildings, significant in material use and embodied greenhouse gas emissions (EGHGE), have lacked detailed analysis on their environmental and functional relationships over time and space. This study evaluates the environmental impa ...

2024

Climate risk assessment of buildings: An analysis of operating emissions of commercial offices in Australia

Arianna Brambilla

Building climate risk assessment involves benchmarking a building's energy use intensity against decarbonisation pathways to mitigate the impacts on climate change. Various climate risk assessment tools and frameworks are used for commercial buildings in d ...

Elsevier Science Sa2024

Impact of anthropogenic emission control in reducing future PM2.5 concentrations and the related oxidative potential across different regions of China

Athanasios Nenes, Yuan Yuan

Affected by both future anthropogenic emissions and climate change, future prediction of PM2.5 and its Oxidative Potential (OP) distribution is a significant challenge, especially in developing countries like China. To overcome this challenge, we estimated ...

Elsevier2024

Lotic-SIPCO2: Adaptation of an open-source CO2 sensor system and examination of associated emission uncertainties across a range of stream sizes and land uses

Andrew Lean Robison

River networks play a crucial role in the global carbon cycle, as relevant sources of carbon dioxide (CO2) to the atmosphere. Advancements in high-frequency monitoring in aquatic environments have enabled measurement of dissolved CO2 concentration at tempo ...

Association for the Sciences of Limnology and Oceanography (ASLO)2024

A concrete answer for circular construction: three prototypes reusing saw-cut elements

Corentin Jean Dominique Fivet, Maléna Bastien Masse, Célia Marine Küpfer

Existing concrete buildings should be retained for as long as possible to reduce the environmental burden of demolition and new construction. However, when urban pressure makes demolition unavoidable, salvaging and reusing concrete elements elsewhere in ne ...

2024

Mapping drivers of tropical forest loss with satellite image time series and machine learning

Devis Tuia, Gaston Jean Lenczner, Jan Pisl, Jan Dirk Wegner, Marc Conrad Russwurm, Lloyd Haydn Hughes

The rates of tropical deforestation remain high, resulting in carbon emissions, biodiversity loss, and impacts on local communities. To design effective policies to tackle this, it is necessary to know what the drivers behind deforestation are. Since drive ...

Iop Publishing Ltd2024

Renewable energy integration and waste heat valorization in aluminum remelting for co-producing kerosene and methanol

François Maréchal, Daniel Alexander Florez Orrego, Meire Ellen Gorete Ribeiro Domingos, Réginald Germanier

The aluminium sector relies on natural gas for the conversion of recycled scrap into new feedstock, which results in substantial atmospheric emissions. Hydric resources are also impacted, as they serve as heat sinks for the waste heat generated during the ...

Associazione Italiana Di Ingegneria Chimica2024

Toward Superior Hydroisomerization Catalysts through Thermodynamic Optimization

Berend Smit

The need to reduce the lifecycle greenhouse gas emissions of fuels and lubricants has renewed interest in hydroisomerization processes. Here it is shown how recognizing the signature of individual alkane hydrocracking pathways enables delineating changes t ...

AMER CHEMICAL SOC2023

Diffusion of connected and autonomous vehicles concerning mode choice, policy interventions and sustainability impacts: A system dynamics modelling study

Evangelos Paschalidis

Connected and autonomous vehicles (CAV) have seen a rapid development over the past decade. However, wide diffusion of high level CAVs is still decades to come, and will depend on many technological, policy and public acceptance factors. Merging a traditio ...

ELSEVIER SCI LTD2023

Upper bounds on technoemission rates from 60 years of "silence"

Claudio Grimaldi

The lack of detection to date of electromagnetic technosignatures implies either that we have been unable to detect them due to incomplete sampling of the search space or that we cannot detect them because the Earth has been located during the entire histo ...

PERGAMON-ELSEVIER SCIENCE LTD2023

A multi-model analysis of the EU’s path to net zero

Marc Vielle, Sigit Pria Perdana

The European Union (EU) recently ratcheted its climate ambition to net-zero emissions by 2050, with a milestone of 55% emissions cuts in 2030. This study carries out a model inter-comparison to assess the EU’s path, from “Fit for 55” in 2030 to an intermed ...

2023

Tuning the Solar Performance of Building Facades through Polymer 3D Printing: Toward Bespoke Thermo-Optical Properties

Stephen William Wasilewski, Arno Schlueter

Facades are the primary interface controlling the flow of solar energy in buildings and affecting their energy balance and environmental impact. Recently, large-scale 3D printing (3DP) of translucent polymers has been explored as a technique for fabricatin ...

Wiley2023