Publications associées à Ring Modulator

Modulation Considerations for Modular Multilevel Converter Operating with Parallel Branches and Phase-Shifted Carriers

The branch paralleling represents one of the available options with regards to the modular multilevel converter power extension. In such a case, the main technical challenge resides in the control domain, whereas a new set of possibilities from the voltage ...

IEEE2020

Remotely-Powered Front-End at 2.45 GHz for Real-Time Continuous Temperature Sensing

Catherine Dehollain, Onur Kazanç, Franco Maloberti

Remote powering and power management of a passive sensor system employing antenna-rectifier co-design is presented. The operating frequency of the system is chosen at 2.45 GHz in order to reduce the antenna size. A co-design approach enables the coupling o ...

IEEE2018

A Subthreshold Current-Sensing Sigma-Delta Modulator for Low-Voltage and Low-Power Sensor Interfaces

Alexandre Schmid, Seyed Armin Tajalli, Yusuf Leblebici, Nikola Katic

A continuous-time (CT) ΣΔ modulator for sensing and direct analog-to-digital conversion of nA-range (subthreshold) currents is presented in this work. The presented modulator uses a subthreshold technique based on subthreshold source-coupled logic cells to ...

Wiley2015

3.6 GHz CMOS Ring Oscillator with Low Tune Voltage Sensitivity and Temperature Compensation

Yusuf Leblebici, Tugba Demirci, Hasene Gülperi Özsema

In this paper we present the design of a temperature compensated low-tune-voltage-sensitive CMOS ring oscillator in 40nm standard CMOS technology. The oscillator has an overall frequency range from 3.1 GHz to 3.6 GHz. The effect of temperature variations o ...

2015

Nanoelectromechanical digital logic circuits using curved cantilever switches with amorphous-carbon-coated contacts

Montserrat Fernandez-Bolanos Badia, Antonios Bazigos, Daniel Grogg

Nanoelectromechanical (NEM) switches have the potential to complement or replace traditional CMOS transistors in the area of ultra-low-power digital electronics. This paper reports the demonstration of prototype circuits including the first 3-stage ring os ...

2014

Continuous-wave four-wave mixing in cm-long Chalcogenide microstructured fiber

Camille Sophie Brès

We present the experimental demonstration of broadband four-wave mixing in a 2.5 cm-long segment of AsSe Chalcogenide microstructured fiber. The parametric mixing was driven by a continuous-wave pump compatible with data signal wavelength conversion. Four- ...

2011

Low power frequency synthesizer for mobile communications systems

Imre Kovacs

A novel frequency synthesizer with a strong emphasis on low-power consumption (2mW) was developed for this thesis. A BAW-resonator was used for the design of the high-frequency oscillator. The BAW's high Q-Factor ensured a minimal power consumption, while ...

EPFL2009

Autonomous effects of shear stress and cyclic circumferential stretch regarding endothelial dysfunction and oxidative stress: an ex vivo arterial model

Nikolaos Stergiopoulos, Rafaela Fernandes Da Silva, Paolo Silacci, Tyler Nerton Thacher

Cyclic circumferential stretch and shear stress caused by pulsatile blood flow work in concert, yet are very different stimuli capable of independently mediating endothelial function by modulating eNOS expression, oxidative stress (via production of supero ...

American Soc Mechanical Engineers, Three Park Avenue, New York, Ny 10016-5990 Usa2009

Methodology for the digital calibration of analog circuits and systems : application to a Hall sensor microsystem

Marc Pastre

This thesis presents a complete methodology for the digital calibration of analog circuits. It shows how to relax the extreme design constraints in analog circuits, allowing the realization of high-precision systems even with low-performance components. In ...

EPFL2005