Analogie électro-mécanique

Applied sciences
Information engineering
Traitement du signal
Filtre (audio)

À propos
Confidentialité
Mentions légales

Graph Chatbot

Publications associées (27)

Self-Heating Aware Design of ICs in Deep Sub-Micron FDSOI and Bulk Technologies

Can Baltaci

Bulk CMOS technologies left the semiconductor market to the novel device geometries such as FDSOI and FinFET below 30 nm, mainly due to their insufficient electrical characteristics arising from different physical limitations. These innovative solutions en ...

EPFL2018

The mechanics of punching in reinforced concrete slabs and footings without shear reinforcement

João Tiago Ramos Bernardo de Santa Rita Simões

Punching shear failures of structural concrete members have been the focus of attention of numerous works presented over the last decades. Although various rational approaches have been developed to predict these failures, there is still no unanimity on a ...

EPFL2018

Energy analysis of a DEAP based cylindrical actuator coupled with a radial negative stiffness spring

Yves Perriard, Yoan René Cyrille Civet, Jonathan André Jean-Marie Chavanne

The main problem to obtain considerable deformation with dielectric electro-active polymer based technology is the electrical breakdown. A simple solution consists in pre-stretching the elastomer before activating it which cancels the snap-through effect a ...

Spie-Int Soc Optical Engineering2017

Design, modeling and experimental validation of a novel finned reciprocating compressor for Isothermal Compressed Air Energy Storage applications

Alfred Rufer, Mahbod Heidari

Considering the need for a reliable and environmentally friendly energy storage solution for addressing renewable energy intermittency issue and following the developments on Isothermal Compressed Air Energy Storage (I-CAES) systems, a new finned piston co ...

Pergamon-Elsevier Science Ltd2017

Broadband Low-Frequency Electroacoustic Absorbers Through Hybrid Sensor-/Shunt-Based Impedance Control

Hervé Lissek, Etienne Thierry Jean-Luc Rivet, Sami Driss Karkar

This paper proposes a hybrid impedance control architecture for an electroacoustic absorber, that combines an improved microphone-based feedforward control with a currentdriven electrodynamic loudspeaker system. Feedforward control architecture enables sta ...

Institute of Electrical and Electronics Engineers2017

Inkjet 3D printing of UV and thermal cure silicone elastomers for dielectric elastomer actuators

Herbert Shea, Samuel Rosset, Samuel Schlatter, David James McCoul

Dielectric elastomer actuators (DEAs) are an attractive form of electromechanical transducer, possessing high energy densities, an efficient design, mechanical compliance, high speed, and noiseless operation. They have been incorporated into a wide variety ...

Institute of Physics2017

Electronics Emulation for Real-Time Fault Location in Power Systems

François Pierre Gaugaz

This research presents a high-speed hardware platform dedicated to emulate electrical power networks for the fault location. The solution implements an algorithm based on the Electromagnetic Time-Reversal (EMTR) principle, which allows locating faults in v ...

EPFL2017

Page 2 sur 2