Publications associées à Computer fan control

Radiation-tolerant Multichannel Dew Point Temperature Monitoring System for High Energy Physics Applications

The next generation of high-energy physics (HEP) detectors will predominantly be silicon-based. As pixel sensor technology gains momentum and the number of channels surpasses one billion (for a volume of approximately 20 m3) to achieve the high resolution ...

EPFL2023

Dynamic Thermal Management with Proactive Fan Speed Control Through Reinforcement Learning

David Atienza Alonso, Marina Zapater Sancho, Arman Iranfar, Federico Terraneo, Gabor Andras Csordas

Dynamic Thermal Management (DTM) has become a major challenge since it directly affects Multiprocessors Systems-on-chip (MPSoCs) performance, power consumption, and reliability. In this work, we propose a transient fan model, enabling adaptive fan speed co ...

IEEE2020

Experimental Characterization of Different Condenser Technologies in a Passive Two-Phase Cooling System for Thermal Management of Electronics

John Richard Thome, Jackson Braz Marcinichen, Chiara Falsetti, Raffaele Luca Amalfi

Passive two-phase, micro-channel cooling for thermal management of electronics represents an efficient and viable solution to augment conventional air-cooling systems with the potential for higher power dissipation densities, increased reliability, reduced ...

IEEE2019

Identification of optimal operating strategy of direct air-cooling condenser for Rankine cycle based power plants

François Maréchal, Ligang Wang, Xiang Li

Direct air-cooling condenser has attracted significant attention in the last decade due to the employment of Rankine-cycle based power plants from renewable (e.g., concentrated solar) or traditional (e.g., coal) heat sources in water-scarce areas. The opti ...

2018

Development of a laser-based heating system for in situ synchrotron-based X-ray tomographic microscopy

Michel Rappaz, Marco Stampanoni

Understanding the formation of materials at elevated temperatures is critical for determining their final properties. Synchrotron-based X-ray tomographic microscopy is an ideal technique for studying such processes because high spatial and temporal resolut ...

International Union of Crystallography2012

Effects of Swirl Velocities From Fan Assemblies Mounted on Lifting Surfaces

Alexandros Terzis, Charilaos Kazakos, Nikolaos Papadopoulos

The penetration of a jet of fluid into a traversal moving stream is a basic configuration of a wide range of engineering applications, such as film cooling and V/STOL aircrafts. This investigation examines experimentally the effect of blowing ratio of fans ...

2011