Publications associées à First Steps Towards The Development Of A 3D Nuclear Fuel Behavior Solver With Openfoam

Atomic level insight into irradiation effects in nuclear fuel materials

Microstructural evolution during in-pile irradiation, radiation damage effects and fission products behavior in UO2 nuclear fuel are key issues in understanding and for the modeling of the performance as well as safety characteristics of nuclear fuels in t ...

EPFL2024

Innovative thermophysical characterization of an ATF composite cladding: the case of silicon carbide

Andrea Cavaliere

Nuclear power is a powerful technology that plays an important role in the fight against climate change, and research is continuously engaged in studies that could further improve its safety. After the Fukushima accident, Accident Tolerant Fuels research h ...

EPFL2024

Gamma-ray Spectroscopy in Low-Power Nuclear Research Reactors

Andreas Pautz, Oskari Ville Pakari, Vincent Pierre Lamirand

Gamma-ray spectroscopy is an effective technique for radioactive material characterization, routine inventory verification, nuclear safeguards, health physics, and source search scenarios. Gamma-ray spectrometers typically cannot be operated in the immedia ...

MDPI2024

Gamma noise to non-invasively monitor nuclear research reactors

Pavel Frajtag, Andreas Pautz, Oskari Ville Pakari, Vincent Pierre Lamirand, Tom Mager

Autonomous nuclear reactor monitoring is a key aspect of the International Atomic Energy Agency’s strategy to ensure nonproliferation treaty compliance. From the rise of small modular reactor technology, decentralized nuclear reactor fleets may strain the ...

Nature Research2024

Neutron-Gamma Noise Measurements in a Zero-Power Reactor Using Organic Scintillators

Andreas Pautz, Oskari Ville Pakari, Vincent Pierre Lamirand

Noise measurements in light water reactor systems aid in generating validation data for integral point kinetic parameter predictions and generating monitoring parameters for reactor safety and safeguards. The CROCUS zero-power reactor has been used to supp ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Experimental study and interpretative modelling of the Power Exhaust in Configurations with Multiple X-Points in TCV

Sophie Danielle Angelica Gorno

Nuclear fusion presents a promising clean energy source to mitigate future energy crises, with magnetic confinement fusion well-positioned to provide a baseload scenario to power future reactors. The unmitigated power exhaust of such reactors threatens its ...

EPFL2024

Intra-pin Reaction Rate Measurements in the CROCUS Experimental Reactor

Andreas Pautz, Oskari Ville Pakari, Vincent Pierre Lamirand, Mathieu Hursin, Thomas Jean-François Ligonnet, Tom Mager

In response to the need for validating high-fidelity deterministic neutronics solvers capable of providing pin-resolved neutron flux distributions, intra-pin reaction rates measurements were performed in the CROCUS experimental reactor. A specially designe ...

2024

Computational Homogenization for Inverse Design of Surface-based Inflatables

Mark Pauly, Francis Julian Panetta, Uday Kusupati, Yingying Ren, Florin Isvoranu, Seiichi Eduardo Suzuki Erazo

Surface-based inflatables are composed of two thin layers of nearly inextensible sheet material joined together along carefully selected fusing curves. During inflation, pressure forces separate the two sheets to maximize the enclosed volume. The fusing c ...

2024

Demonstration of a sparse sensor placement technique to the limited diagnostic set in a fusion power plant

Lorenzo Martinelli, Artur Perek

DEMO will have a limited diagnostic set for optimization of reactor performance, and limited diagnostic coverage due to challenging reactor conditions. This poses challenges for control, especially for detachment control which is planned to be performed wi ...

Elsevier Science Sa2024

Short-term behavior of glass fiber-polymer composite bending-active elastica beam under service load application

Thomas Keller, Landolf-Giosef-Anastasios Rhode-Barbarigos, Tara Habibi

Bending-active elastica beam is a structural configuration that is based on the elastic deformation of an initially straight beam. This deformation occurs when horizontal displacements are applied to a sliding support, causing the beam to bend into an arch ...

2024

High brightness neutron source optimized for very high pulsed magnetic field experiments

Mina Akhyani

Conducting neutron scattering experiments in the presence of high pulsed magnetic fields, namely above 40 T, provides valuable information about the magnetic structures of materials. However, these experiments are challenging and time-consuming because the ...

EPFL2024

Extension of the OFFBEAT fuel performance code to finite strains and validation against LOCA experiments

Andreas Pautz, Alessandro Scolaro, Carlo Fiorina, Edoardo Luciano Brunetto

The mechanical analysis of nuclear fuel behavior under base-irradiation conditions has traditionally been performed adopting the small-strain approximation. However, many cases of interest for fuel behavior involve the occurrence of large rod deformations ...

ELSEVIER SCIENCE SA2023

Design of an Instrumented Fuel Rod for Intra-pin Neutron Flux Measurements in the CROCUS Experimental Reactor

Andreas Pautz, Vincent Pierre Lamirand, Mathieu Hursin, Thomas Jean-François Ligonnet, Won Dong Shin, Tom Mager

In response to the need for validating high-fidelity deterministic neutronics solvers capable of pin-resolved neutron flux distributions, an instrumented fuel rod was designed for the experimental reactor CROCUS, operated by EPFL’s Laboratory for Reactor P ...

2023

Shear strength and shear stiffness analysis of compacted Wyoming-type bentonite

Alessio Ferrari

Wyoming-type bentonite is one of the materials to be used as part of the Engineered Barrier System (EBS) in deep geological disposal facilities for the safe disposal of spent nuclear fuel.In the KBS-3 type repository, the canisters containing the spent fue ...

ELSEVIER2023

Gamma-Blind Fast Neutron Detection for Spent Nuclear Fuel Characterization

Alexander Wolfertz

In this thesis, the development and testing of a system for measuring the axial distribution of fast neutron emission of spent nuclear fuel rods is presented. Emphasis is placed on the novel fast neutron detector used which can reliably work in extremely h ...

EPFL2023

Design and operational guidelines of solar-driven catalytic conversion of CO2 and H2 to fuels

Sophia Haussener, Sha Li

Sunlight-powered catalytic conversion of CO2 and (green) H2 into fuels and chemicals via Sabatier and reverse water gas shift (RWGS) processes offers a promising solution to reduce greenhouse gas emissions and increase renewable energy utilization. The suc ...

ELSEVIER SCI LTD2023

A holistic investigation of photocatalytic hydrogen generation

Sangram Ashok Savant

Photocatalytic (PC) solar hydrogen production is a promising way to provide green hydrogen using only sunlight and abundant reactants such as water. PC approaches use catalytically active semiconductor particles suspended in liquid electrolytes. The partic ...

EPFL2023

Monte Carlo analysis of BWR geometries using a cycle check-up methodology

Abdelhamid Dokhane, Hakim Ferroukhi, Alexander Vasiliev, Mathieu Hursin, Dimitri Rochman

Recent fuel anomalies at a Swiss power plant have motivated the development at PSI of the "Cycle Check-Up" (CHUP) methodology which consists in performing Monte Carlo transport calculations using nuclide compositions and thermal-hydraulic boundary conditio ...

Pergamon-Elsevier Science Ltd2023

Preliminary safety analysis of the TRANSMUTEX sub-critical reactor using the GeN-Foam multi-physics solver

Andreas Pautz, Carlo Fiorina, Thomas Arthur Louis Joseph Guilbaud

This work presents a preliminary safety analysis of the accelerator-driven system under development at TRANSMUTEX. It is a sub-critical lead-cooled fast reactor with a nominal power of 300 MWth having the following features: (1) an inert-matrix fuel; (2) a ...

Pergamon-Elsevier Science Ltd2023

Integrated modelling of neon impact on JET H-mode core plasmas

Yann Camenen, Michele Marin

Nuclear fusion reactor plasmas will need to exhaust a significant proportion of energy flux through radiative processes, to enable acceptable divertor loads. This can be obtained by line radiation from impurities, injected from the plasma edge. There are h ...

IOP Publishing Ltd2023