Publications associées à Resonant planar antenna as an inductive plasma source

DC Power Distribution Networks with Direct Current Transformers

The shift towards DC power distribution networks, enabled by power electronics technologies, is changing the nature of electrical power systems. Nowadays, DC power distribution networks can effectively support the high penetration of distributed energy res ...

EPFL2024

A Two-Wired High Input Impedance and High CMRR Active Electrode Insensitive to Component Mismatch

Alexandre Schmid, Mehdi Saberi

This article proposes a new two-wired amplifying active electrode (AE), presenting a high input impedance and a high common-mode rejection ratio (CMRR). In the proposed structure, the input impedance and the CMRR of the system are considerably increased by ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Code for project entitled "study on conformal antennas, proof of concept prototype for a UAV"

Anja Skrivervik, Yuanyan Su

This code is used for developing the project entitled “Study on conformal antennas, proof of concept prototype for a UAV”, from the aspects of theory, design, and implementation. This code aims to speed up the investigation of an arbitrary phased array ant ...

Zenodo2024

Characterization of low-temperature plasmas generated by dielectric barrier discharges for bacterial inactivation

Lorenzo Ibba

Low-temperature plasmas (LTPs) at atmospheric pressure hold great promise for disinfection and sterilization applications. When compared to traditional sterilization technologies like autoclaving, LTPs may offer several benefits, including reduced energy c ...

EPFL2024

Enabling Wide Bandwidth in Substrate-Integrated Waveguide Slot Antennas by Using Low-Index Metamaterials

Romain Christophe Rémy Fleury, Jalaledin Tayebpour, Amir Jafargholi

This paper presents a solution to overcome the inherently limited bandwidth of substrate-integrated waveguide (SIW) slot antennas. It is analytically shown that by decreasing the permittivity of a dielectric loaded slot antenna, the resulting bandwidth inc ...

American Physical Society (APS)2024

Dual-Polarized SIW Slot Antenna Using ENZ Metamaterial for 5G and mmWave Applications

Romain Christophe Rémy Fleury, Amir Jafargholi

This paper presents a broadband dual-polarized substrate integrated waveguide (SIW) slot antenna. It is analytically shown that by decreasing the permittivity of a dielectricloaded slot antenna, the resulting bandwidth increases significantly, where the wi ...

IEEE2023

Control upgrade for the TCV coils power supplies

Damien Fasel, Ugo Siravo, Jérémie Dubray, Nicolas Cherix

The Tokamak a` Configuration Variable (TCV) coil converters are fed, during the plasma pulse, by a flywheel generator (FG) providing the AC voltages few seconds before the plasma pulse. The synchronization with the 120 Hz frequency delivered by the FG, var ...

ELSEVIER SCIENCE SA2023

Measuring the electron energy distribution in tokamak plasmas from polarized electron cyclotron radiation

Arsène Stéphane Tema Biwole

In this doctoral thesis, a promising technique has been used for the measurement of non-thermal electrons in TCV. The technique employs a Vertical viewing ECE to more easily discriminate the radiation according to the energy of the electrons. Successful ...

EPFL2023

Toward Metantennas: Metamaterial-Based Antennas for Wireless Communications

Yuanyan Su

Antennas have historically been the most common electromagnetic (EM) technology for wireless communication systems. Antenna as hardware is entirely dependent on the EM properties of the materials used, mostly related to the permittivity and permeability. I ...

Ieee-Inst Electrical Electronics Engineers Inc2023

On Energy Control of Modular Multilevel Converters

Milan Utvic

Owing to the advancements in the area of power electronics, efficient and flexible ac to dc conversion is made possible, bringing back into focus the idea of the dc power transmission at various voltage levels. Several technical and economical factors advo ...

EPFL2023

Dc-Link Ripple Suppression of Cascaded H-Bridge Based MV Grid Emulator Apparatus for Analysis and Testing of Grid-Tied Converters in Distribution System

Drazen Dujic, Chengmin Li, Xin Xiang, Jing Sheng

The medium-voltage grid emulator is gaining popularity for testing grid-code compliance of large-capacity converters for renewable energy resources. The cascaded H-bridge converter based on active-front-ends is a promising candidate for high-power grid emu ...

2023

Microstrip patch antennas with broad beamwidth

Ismael Vico Triviño

Microstrip antennas offer a broad set of advantages such as low profile, light weight, easy fabrication and low cost. As these are desirable or even critical for a broad range of applications, there has been a large interest for these antennas in the anten ...

EPFL2023

From pulsed-DCMS and HiPIMS to microwave plasma-assisted sputtering: Their influence on the properties of diamond-like carbon films

Aïcha Hessler-Wyser, Johann Michler, David Brown, Caroline Hain, Thomas Nelis

The fabrication of high-hardness non-hydrogenated diamond-like carbon (DLC) via standard magnetron sputtering (MS) is often hindered by the low sputtering yields and ionisation rates of carbon, therefore investigations into pulsed alternatives of MS, else ...

ELSEVIER SCIENCE SA2022

Microwave plasma-assisted reactive HiPIMS of InN films: Plasma environment and material characterisation

Aïcha Hessler-Wyser, Johann Michler, Jonathan Emanuel Thomet, Caroline Hain, Thomas Nelis

This work focuses on the low temperature fabrication process of InN thin films via microwave plasma-assisted reactive high power impulse magnetron sputtering (MAR-HiPIMS). The influence of microwave plasma on the HiPIMS discharge process at various nitroge ...

ELSEVIER SCIENCE SA2022

A 1.5D fluid-Monte Carlo model of a hydrogen helicon plasma

Philippe Frédérique Bruno Guittienne, Alan Howling, Ivo Furno, Rémy Jacquier, Riccardo Agnello

Helicon plasma sources operating with hydrogen or deuterium might be attractive for fusion applications due to their higher power efficiency compared to inductive radiofrequency plasma sources. In recent years, the resonant antenna ion device (RAID) has be ...

2022

High frequency IGCT operation for DC transformer

Gabriele Ulissi

In spite of the dominance of ac technology for the vast majority of power transmission and distribution since the late 19th century, the past decades have seen an increase in use of dc electrical power. In particular, this has been the case both in high vo ...

EPFL2022

Optimization of Edge Profile for Improved Anti-Resonance Quality Factor in Lithium Niobate SH0 Resonators

Luis Guillermo Villanueva Torrijo, Silvan Stettler

Thin-film lithium niobate (LNO) has been identified as a promising material platform for enabling high electromechanical coupling and low-loss piezoelectric resonators for filtering applications. In this work, the design and fabrication of fundamental shea ...

IEEE2022

Experimental studies of plasma-antenna coupling with the JET Alfven Eigenmode Active Diagnostic

Ambrogio Fasoli, Duccio Testa, Mikhail Maslov, Paulo Giovane Paschoali Pereira Puglia

This paper presents a dedicated study of plasma-antenna (PA) coupling with the Alfven Eigenmode Active Diagnostic (AEAD) in JET. Stable AEs and their resonant frequencies f, damping rates gamma < 0, and toroidal mode numbers n are measured for various PA s ...

IOP Publishing Ltd2021

Ultra-High-Voltage (7-kV) Bidirectional Flyback Converter Used to Drive Capacitive Actuators

Yves Perriard, Alexis Boegli, Raphaël Johannes Charles Mottet, Morgan Almanza, Lucas Pniak

Dielectric elastomer actuators (DEAs) have extremely advantageous characteristics such as lightness, compactness, flexibility, and large displacements. However, in order to operate, they can require voltages in the order of several thousands of volts. Thus ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2021

Terminal Characteristics Measurements and Analysis of the Three-Phase Active Front End Converter Building Block

Marko Petkovic, Drazen Dujic

The safe and reliable operation of modern power system imposes the need to describe and estimate the system stability through impedance-admittance measurement and identification. The integration and operation of medium voltage equipment in existing infrast ...

Wiley2021