Publications associées à Cathode thickness-dependent tolerance to Cr-poisoning in solid oxide fuel cells

Quantifying mass transport limitations in a microfluidic CO2 electrolyzer with a gas diffusion cathode

A gas diffusion electrode (GDE) based CO2 electrolyzer shows enhanced CO2 transport to the catalyst surface, significantly increasing current density compared to traditional planar immersed electrodes. A two-dimensional model for the cathode side of a micr ...

2024

Electrochemical devices and computer science: water/thermal management of proton exchange membrane fuel cells and electrolyzers in different scales

Hossein Pourrahmani

The current restrictions on the registration of combustion engines in different countries and the harmful impacts of fossil fuels on the environment and human health have motivated decision-makers to use batteries and/or fuel cells as alternatives for comb ...

EPFL2023

Reversible photo-electrochemical device for solar hydrogen and power generation

Sophia Haussener, Alexandre Dominique M. Cattry, Saurabh Yuvraj Tembhurne, Matthieu Jonin, Mahendra Patel

A reversible photo-electrochemical device operating under concentrated irradiation could offer a stand-alone solution for producing solar fuel (in photo-driven electrolysis mode) and power (in fuel cell mode). This strategy would present the advantage of h ...

2024

Contrasting Views of the Electric Double Layer in Electrochemical CO2 Reduction: Continuum Models vs Molecular Dynamics

Sophia Haussener, Evan Fair Johnson

In the field of electrochemical CO2 reduction, both continuum models and molecular dynamics (MD) models have been used to understand the electric double layer (EDL). MD often focuses on the region within a few nm of the electrode, while continuum models ca ...

Amer Chemical Soc2024

Membrane electrode assembly simulation of anion exchange membrane water electrolysis

Jan Van Herle, Zoé Mury, Suhas Nuggehalli Sampathkumar, Khaled Lawand

Anion exchange membrane water electrolysis (AEMWE) offers a green hydrogen production method that eliminates the need for platinum group metals (PGM) as electrocatalysts. This study employs a COMSOL (R) 6.0 model to simulate a 1x1 cm(2) Ni fibre - Raney (R ...

Elsevier2024

Spinel Protective Coatings for Solid Oxide Cell (SOC) Interconnects (ICs)

Samaneh Daviran

Abstract The degradation of metal interconnects (ICs) in Solid Oxide Cells (SOCs) primarily results from chromium (Cr) oxide scale growth on stainless-steel substrates, causing ohmic loss and air-side electrode poisoning by Cr. This thesis addresses these ...

EPFL2024

Artificial Hydrophilic Organic and Dendrite-Suppressed Inorganic Hybrid Solid Electrolyte Interface Layer for Highly Stable Zinc Anodes

Lei Zhang, Kangning Zhao

Aqueous zinc-ion batteries (AZIBs) have gained significant attentions for their inherent safety and cost-effectiveness. However, challenges, such as dendrite growth and anodic corrosion at the Zn anode, hinder their commercial viability. In this paper, an ...

Amer Chemical Soc2024

Microstructure - Electrochemical Surface Reactivity Relationship of Electrochemically Grown Manganese Oxides Films

Roberto Cestaro

This Thesis provides a comprehensive and correlative investigation of the microstructure, chemical state, and electrochemical reactivity of manganese oxide (MnOx) films, aiming to gain a deeper understanding of the deposition and dissolution mechanism of M ...

EPFL2024

Hydrogen-induced tunable remanent polarization in a perovskite nickelate

Michele Kotiuga

Materials with field-tunable polarization are of broad interest to condensed matter sciences and solid-state device technologies. Here, using hydrogen (H) donor doping, we modify the room temperature metallic phase of a perovskite nickelate NdNiO3 into an ...

Nature Portfolio2024

Quasi-operando Transmission Electron Microscopy Diagnostics for Electrocatalytic Processes in Liquids

Vasiliki Tileli

It is of great interest to the energy community to understand how the mechano-physico-chemical phenomena that eventually lead to device degradation are related to the startup, operation, and shutdown phases. For electrocatalytic systems operating in liquid ...

Swiss Chemical Soc2024

A pre-fatigue training strategy to stabilize LiCoO2 at high voltage

Lei Zhang, Rui Xia, Kangning Zhao

Layered cathodes are among the most promising cathodes for high-energy-density Li-ion batteries, yet hindered by the structural degradation from both bulk strain and surface oxygen loss at high voltage (above 4.5 V). Herein, we report a pre-fatigue trainin ...

Royal Soc Chemistry2024

Electrochemical sensors modified with iron oxide nanoparticles/ nanocomposites for voltammetric detection of Pb (II) in water: A review

Sandro Carrara

Permissible limits of Pb 2+ in drinking water are being reduced from 10 mu gL -1 to 5 mu gL -1 , which calls for rapid, and highly reliable detection techniques. Electrochemical sensors have garnered attention in detection of heavy metal ions in environmen ...

Cell Press2024

Active Power Decoupling for Single-Phase Input-Series-Output-Parallel Solid-State Transformers

Drazen Dujic, Tianyu Wei, Andrea Cervone

Solid-state transformers with input-series outputparallel structures are being considered for a variety of applications requiring MVAC to LVDC conversion. Due to the singlephase AC/DC conversion at the input side, all floating cells of the solid-state tran ...

2024

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Johann Michler, Ivo Utke, Xavier Maeder

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

Green hydrogen production using Shewanella oneidensis MR-1 bioanode and cuprous oxide-based photocathode

Michele Morgante

In recent years, many efforts have been made to find alternative renewable energy sources that can ideally replace the use of fossil fuels in all aspects. One of the new emerging energy technologies is the bioelectrochemical system, of which two types are ...

EPFL2024

An Advanced Alkaline Al-Air Fuel Cell Using L-Ascorbic Acid Interface Layer upon Al Anode via Gradient Anti-corrosion

Pengfei Zhang, Manhui Wei

Al metal is considered as an excellent anode material for metal-air fuel cells thanks to the advantages in terms of capacity and energy density. However, the anodic parasitic corrosion has brought great obstacles to the performance breakthrough of Al-air f ...

AMER CHEMICAL SOC2023

Gas generating membrane-less electrolyser

Demetri Psaltis, Steven Alexandre Schenk, Pooria Hadikhani

Electrolyser including a reactor (2) comprising a housing (4), fluidic channels (6a, 6b, 6c) within the housing, and electrodes (16a, 16c) comprising an anode (16a) and a cathode (16c). The fluidic channels include an inter-electrode channel (6b) arranged ...

2023

Pathways to enhance electrochemical CO2 reduction identified through direct pore-level modeling

Sophia Haussener, Shuo Liu, Etienne Boutin, Evan Fair Johnson

Electrochemical conversion of CO2 to fuels and valuable products is one pathway to reduce CO2 emissions. Electrolyzers using gas diffusion electrodes (GDEs) show much higher current densities than aqueous phase electrolyzers, yet models for multi-physical ...

2023

Readiness evaluation of SOFC-MGT hybrid systems with carbon capture for distributed combined heat and power

Jürg Alexander Schiffmann, Jan Van Herle, Michele Gaffuri, Victoria Xu Hong He

The aggravation of climate change calls for the timely development and implementation of highly efficient, renewable, zero- or negative-emission energy solutions with high technological readiness and feasibility levels. Solid oxide fuel cells (SOFC) consti ...

Elsevier2023

The thermodynamic and life-cycle assessments of a novel charging station for electric vehicles in dynamic and steady-state conditions

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

The current study performs the thermodynamic and life-cycle assessments (LCA) of a novel charging station in two system designs. The goal is to design an efficient charging station for electric vehicles with high efficiencies and low environmental impacts ...

Nature Portfolio2023