Publications associées à Two-phase flow operational maps for multi-microchannel evaporators

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

General and Unified Model of the Power Flow Problem in Multiterminal AC/DC Networks

Mario Paolone, Willem Lambrichts

This paper proposes a generic and unified model of the power flow (PF) problem for multiterminal hybrid AC/DC networks. The proposed model is an extension of the standard AC-PF. The DC network is treated as an AC one and, in addition to the Slack, PV and P ...

IEEE Institute of Electrical and Electronics Engineers2024

Heat transfer of uncoated and nanostructure coated commercially micro-enhanced refrigeration tubes under pool boiling conditions

John Richard Thome

The heat transfer performance of commercially produced micro-enhanced tubes with and without a nanocoating was investigated under pool boiling of saturated refrigerant. These multiscale enhancements were on the outside of 19 mm horizontal copper tubes heat ...

Pergamon-Elsevier Science Ltd2023

Experimental study of the hydrodynamic and thermal performances of ventilated wall structures

Mohammad Rahiminejad, Dolaana Khovalyg

The presence of a ventilated air gap behind the external cladding in a building envelope is known to have a tangible contribution to the overall performance of the wall assembly. In the present study, the hydrodynamic and thermal performances of ventilated ...

2023

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

Development of next-generation microfluidic systems for enhanced, faster, and cost-effective immunoassays for tissue diagnostics - Ac electrothermal flow & Acoustofluidics

Muaz Salama Abdelmonem Draz

The application of microfluidics in the field of surface-based assays and more specifically, the spatial molecular profiling of tumor tissues has gained a lot of interest, especially with the increased interest in personalized medicine and targeted therapy ...

EPFL2023

Near-junction microfluidic cooling for high power-density GaN-on-Si electronics: A wafer, device, packaging, and system-level investigation

Remco Franciscus Peter van Erp

Electrification of the energy section, from generation to end-use, plays an essential role in reducing global CO2 emission. Innovations in power electronics are required to increase conversion efficiency and power density. Gallium nitride (GaN) transistors ...

EPFL2022

Design and management of three-dimensional multi-processor systems-on-chip with integrated flow cell arrays

Halima Najibi

Three-Dimensional Multi-Processor Systems-on-Chip (3D MPSoCs) are promising solutions for highly intensive Artificial Intelligence (AI) and Big Data applications. They combine remarkably dense computation capabilities and massive communication bandwidths. ...

EPFL2022

Flow Boiling of Carbon Dioxide at Different Channel Orientations for the Thermal Management of Future Detector Technologies at the High-Luminosity Large Hadron Collider at CERN

David Schmid

The global warming potential (GWP) of working fluids in thermodynamic cycles and their environmental impact have been gaining considerable attention within the recent years. The global objectives on climate protection are becoming increasingly ambitious, w ...

EPFL2022

Flow boiling heat transfer and two-phase flow phenomena of CO2 in macro-and micro-channel evaporators: Fundamentals, applications and engineering design

John Richard Thome

The paper presents a comprehensive review of fundamentals and engineering applications of CO2 flow boiling heat transfer, flow patterns and two-phase pressure drops in macro- and micro-channel evaporators. First, distinctions of macro- and micro-channels a ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Thermal management of components for high energy physics experiments and space applications

Timothée Robert Sophus Frei

High-energy physics (HEP) experiments and space missions share a common challenge: thermal management in harsh environments. The severe constraints in both fields make cooling of electronic components a major design concern. This thesis aims to develop hig ...

EPFL2021

Energy-Efficient Design Techniques for High-Speed Wireline Serial Links

Firat Çelik

The exponential growth in computing power and multimedia services has caused a tremendous increase in data traffic in recent years. This increase in data traffic brings a strong demand for data bandwidth of electrical input/output (I/O) links and pushes th ...

EPFL2021

Embedded Microchannel Cooling for Monolithically-integrated GaN Half-bridge ICs

Elison de Nazareth Matioli, Palliyage Srilak Nirmana Perera, Remco Franciscus Peter van Erp, Luca Nela

Efficient and compact power conversion is a key requirement to achieve sustainable electrification of our society. GaN-based power devices offer major benefits compared to their silicon counterparts in terms of efficiency and integration but suffer from se ...

IEEE2021

Simulation and experimental validation of pulsating heat pipes

John Richard Thome, Jackson Braz Marcinichen, Filippo Cataldo, Philippe Aubin

The one-dimensional transient numerical code of JJ Cooling Innovation has been significantly improved to simulate the thermal/hydraulic performance of pulsating heat pipes (PHPs). Using a mechanistic approach, the liquid slug and vapor plug flows and their ...

PERGAMON-ELSEVIER SCIENCE LTD2021

3D-ICE 3.0: efficient nonlinear MPSoC thermal simulation with pluggable heat sink models

David Atienza Alonso, Marina Zapater Sancho, Federico Terraneo

The increasing power density in modern high-performance multi-processor system-on-chip (MPSoC) is fueling a revolution in thermal management. On the one hand, thermal phenomena are becoming a critical concern, making accurate and efficient simulation a nec ...

2021

Multiphase transport and evaporative cooling in fuel cell gas diffusion layers

Sarah van Rooij

The use of evaporative cooling in the gas diffusion layer (GDL) of polymer electrolyte fuel cells has been proposed as a simple yet impactful solution to simultaneously provide the functionality of cell cooling, thanks to the dissipation of the latent heat ...

EPFL2021

Novel pulsating heat pipe for high density power data centres: performance and flow regime analysis

John Richard Thome, Jackson Braz Marcinichen, Raffaele Luca Amalfi, Filippo Cataldo

With the advancement of technologies such as Artificial Intelligence and 5G telecommunications, where computational rate is constantly pushing its limits, highly efficient and reliable cooling devices are starting to become an overly critical factor. Not o ...

IEEE2021

Compact Thermosyphon Cooling System For High Heat Flux Servers: Validation Of Thermosyphon Simulation Code Considering New Test Data

John Richard Thome, Jackson Braz Marcinichen, Raffaele Luca Amalfi, Filippo Cataldo

Passive, gravity-driven thermosyphons represent a stepchange in technology towards the goal of greatly reducing PUE (Power Usage Effectiveness) of datacenters by replacing energy hungry fans of air-cooling approach with a highly-reliable solution able to d ...

AMER SOC MECHANICAL ENGINEERS2021

Influencing factors on flow boiling of carbon dioxide in enhanced tubes and comparison with correlations

John Richard Thome

Carbon dioxide two-phase flow characteristics are different from those of conventional refrigerants, due to the CO2 particular thermodynamic and transport properties obtained by working at high reduced pressures. Moreover, the use of peculiar heat transfer ...

IOP PUBLISHING LTD2020

Towards Deeply Scaled 3D MPSoCs with Integrated Flow Cell Array Technology

David Atienza Alonso, Mohamed Mostafa Sabry Aly, Halima Najibi, Marina Zapater Sancho, Alexandre Sébastien Julien Levisse

Deeply-scaled three-dimensional (3D) Multi-Processor Systems-on-Chip (MPSoCs) enable high performance and massive communication bandwidth for next-generation computing. However, as process nodes shrink, temperature-dependent leakage dramatically increases, ...

2020