Publications associées à Architectural Modeling of a Single-Sideband Wireline Serial Data Transceiver for Multi-Drop I/O

A 0.14-nJ/b 200-Mb/s 2.7-3.5-GHz Quasi-Balanced FSK Transceiver With PLL-Based Modulation and Sideband Energy Detection

This paper describes a balanced frequency shift keying (FSK) modulation, namely quasi-balanced FSK (QB-FSK), for energy-efficient high-data-rate communication. Not suffering from data-pattern dependency, the proposed modulation method enables frequency mod ...

2024

Magnetism of Single Surface Adsorbed Atoms Studied with Radio-Frequency STM

Clément Marie Soulard

This thesis investigates the magnetic properties of single atoms and molecules adsorbed on thin magnesium oxide decoupling layers, grown on a silver single crystal. To address these systems experimentally, we use a low temperature scanning tunneling micros ...

EPFL2024

Energy-Efficient Design Techniques for High-Speed Wireline Serial Links

Firat Çelik

The exponential growth in computing power and multimedia services has caused a tremendous increase in data traffic in recent years. This increase in data traffic brings a strong demand for data bandwidth of electrical input/output (I/O) links and pushes th ...

EPFL2021

High-Speed ADC Design and Optimization for Wireline Links

Ayça Akkaya

The ever-growing global internet traffic has increased demand for higher speed data transmission. As the bandwidth requirements of wireline links increase, extensive digital equalization techniques are required to compensate for the high-frequency channel ...

EPFL2021

Resource Trade-Offs in Circuits and Systems: from Neurotechnology to Communications

Arda Uran

This thesis aims to explore and exploit trade-offs in integrated circuits and systems to overcome the fundamental bottlenecks faced by future data acquisition and communication systems. Specifically, we target the emerging implantable neurotechnology and t ...

EPFL2021

A 161-mW 56-Gb/s ADC-Based Discrete Multitone Wireline Receiver Data-Path in 14-nm FinFET

Yusuf Leblebici, Alessandro Cevrero, Andreas Peter Burg, Gain Kim, Lukas Kull, Thomas Toifl, Cosimo Aprile, Ilter Ozkaya

This article introduces a wireline receiver (RX) data-path employing discrete multi-tone (DMT) modulation for communicating over electrical links. The DMT RX incorporates a fully digital equalization data-path, with a synthesized and automatically placed a ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2020

Demonstration of Tunable Optical Aggregation of QPSK to 16-QAM Over Optically Generated Nyquist Pulse Trains Using Nonlinear Wave Mixing and a Kerr Frequency Comb

Tobias Kippenberg, Martin Hubert Peter Pfeiffer, Fatemeh Alishahi, Arne Kordts, Maxim Karpov, Ahmad Fallahpour, Cong Liu

A tunable and reconfigurable optical aggregation system is experimentally demonstrated. Optical Nyquist pulses are generated on multiple channels using a microresonator-based Kerr optical frequency comb and insertion of uniform lines by an intensity modula ...

IEEE Institute of Electrical and Electronics Engineers2020

Physical Layer Aspects of LoRa and Full-Duplex Wireless Transceivers

Orion Afisiadis

Wireless communications are currently faced with two main challenges. The first challenge stems from the enormous number of Internet of Things (IoT) devices that transmit very small amounts of data. The second challenge is the need for ever-increasing data ...

EPFL2020

ISI Sensitivity of PAM Signaling for Very High-Speed Short-Reach Copper Links

Yusuf Leblebici, Seyed Armin Tajalli, Ayça Akkaya, Firat Çelik

This paper presents a comparative study, analyzing the potentials of pulse amplitude modulation (PAM) for implementing next generation high-speed copper wireline links. This comparative study analyzes the sensitivities of PAM2, PAM4 and PAM8 to inter-symbo ...

IEEE2019

Analysis, modeling and design of a CMOS Super-Regenerative Receiver for implanted medical devices under square and sinusoidal quench signals

Catherine Dehollain, Naci Pekçokgüler

Medical implant devices have found widespread application in recent years. The Super-Regenerative Receiver has been one preferred architecture due to its power advantage over other architectures. We present a detailed analysis of the circuits and their equ ...

ELSEVIER SCIENCE BV2019

Improved Delay Bound for a Service Curve Element with Known Transmission Rate

Jean-Yves Le Boudec, Eleni Stai, Ehsan Mohammadpour

Network calculus is often used to prove delay bounds in deterministic networks, using arrival and service curves. We consider a FIFO system that offers a rate-latency service curve and where packet transmission occurs at line rate without pre-emption. The ...

2019

JESD204B Compliant 12.5 Gb/s LVDS and SST Transmitters in 28 nm FD-SOI CMOS

Yusuf Leblebici, Seyed Armin Tajalli, Andreas Peter Burg, Ayça Akkaya, Firat Çelik

JESD204B compliant low-voltage differential signaling (LVDS), and source-series-terminated (SST) transmitters in 28 nm FD-SOI CMOS technology are presented with 1.1 pJ/bit and 1.7 pJ/bit at 12.5 Gb/s, respectively. An external 6.25 GHz single-ended clock, ...

IEEE2019

A 4.8pJ/b 6Gb/s ADC-Based PAM-4 Wireline Receiver Data -Path with Cyclic Prefix in 14nm FinFET

Yusuf Leblebici, Alessandro Cevrero, Andreas Peter Burg, Gain Kim, Lukas Kull, Thomas Toifl, Cosimo Aprile, Ilter Ozkaya

This work presents an ADC-bascd receiver (RX) data-path for frame-based PAM-4 modulation with a cyclic prefix (CP). Similar to discrete multi-tone (DMT) modulation, a frame of PAM-4 symbols arc protected from the channel delay spread by the CP taps. A PAM- ...

IEEE2019

Experimental demonstration of three-fold wavelength multicasting of a 64-QAM 120 Gbit/s data channel using a Kerr frequency comb and nonlinear wave mixing

Tobias Kippenberg, Martin Hubert Peter Pfeiffer, Fatemeh Alishahi, Arne Kordts, Maxim Karpov, Ahmad Fallahpour

We experimentally demonstrate three-fold wavelength multicasting of a 64-quadrature-amplitude-modulation (QAM), 120-Gbit/s data channel using a microresonator Kerr frequency comb and nonlinear wave mixing. The multicasting is achieved with a data signal an ...

SPIE-INT SOC OPTICAL ENGINEERING2019

Multi-Tone Signaling and ADC-Based Digital Receiver for High-Speed Wireline Serial Links

Gain Kim

The exponential growth of Internet traffic and related demands for higher communication speed pushes processor-to-processor and processor-to-memory interconnects to provide further higher data-rate. Often time, processor-to-memory interconnectsâ speed is ...

EPFL2018

Adaptive Receiver Design for High Speed Optical Communication

Ilter Ozkaya

Conventional input/output (IO) links consume power, independent of changes in the bandwidth demand by the system they are deployed in. As the system is designed to satisfy the peak bandwidth demand, most of the time the IO links are idle but still consumin ...

EPFL2018

Ultra Low Power FM-UWB Transceiver for High-Density Wireless Sensor Networks

Vladimir Kopta

The WiseSkin project aims to provide a non-invasive solution for restoration of a natural sense of touch to persons using prosthetic limbs. By embedding sensor nodes into the silicone coating of the prosthesis, which acts as a sensory skin, WiseSkin target ...

EPFL2018

Parallel Implementation Technique of Digital Equalizer for Ultra-High-Speed Wireline Receiver

Yusuf Leblebici, Alessandro Cevrero, Gain Kim, Lukas Kull, Thomas Toifl, Cosimo Aprile, Ilter Ozkaya

This paper presents a parallel implementation technique of digital equalizer for high-speed wireline serial link receiver (RX). In wireline RX, inter-symbol interference (ISI) is mitigated by continuous-time linear equalizer, and the remaining ISI is cance ...

2018

A Sub-μW/Channel, 16-Channel Seizure Detection and Signal Acquisition SoC Based on Multichannel Compressive Sensing

Alexandre Schmid, Reza Ranjandish

An accurate 16-channel seizure detection system-on-chip is presented, which is based on extracting features from the compressed recorded data using multichannel compressive sensing (MCS). MCS is used to reduce the transmission data rate of sparse biologica ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2018

TIA Linearity Analysis for Current Mode Receivers

Catherine Dehollain

Current-mode signal processing offers superior linearity and flexibility in front-end implementation. The linearity of a low-input-impedance Trans-Impedance Amplifier (TIA), which is used as a buffer stage that follows a passive mixer, is important in dete ...

IEEE2018