Compositional and interfacial optimization for enhancement of perovskite solar cells performance

Non-renewable sources are responsible for most of the overall greenhouse gas emissions, the development of sustainable energy sources is of prime importance to mitigate the negative effects of climate change. Among renewable sources, solar energy is one of the most abundant forms of energy available. Perovskite photovoltaics has emerged as one of the promising candidates for harvesting solar energy. However, these perovskite solar cells suffer from instability which is primarily due to the bulk and interface defects. In this thesis, we focus on the passivation of the bulk and interface defects to enable high-performance and stable devices. At the beginning of the thesis, we engineered the composition of mixed-cation and mixed-halide perovskite films by judicious incorporation of guanidinium iodide to suppress the parasitic charge carrier recombination, which enabled the fabrication of >20% efficient and operationally stable PSCs yielding reproducible photovoltage as high as 1.20 V. Thereafter, in our next project, we develop a facile strategy to reduce the level of electronic defects present at the interface between the perovskite film and the hole transport layer by treating the perovskite surface with different types of ammonium salts, namely ethylammonium, imidazolium, and guanidinium iodide. We find that this treatment boosts the power conversion efficiency from 20.5% for the control to 22.3%, 22.1%, and 21.0% for the devices treated with ethylammonium, imidazolium, and guanidinium iodide, respectively. Best performing devices showed a loss in efficiency of only 5% under full sunlight intensity with maximum power tracking for 550 h. We employed 2D-solid-state NMR (1H-1H correlation) spectroscopy to unravel the atomic-level mechanism of this passivation effect. Following that, we applied a facile and very effective method that employs methylammonium triiodide (MAI3) for bulk passivation together with interface passivation developed in the second project for holistic defect mitigation in perovskite solar cells. As a result, the champion device shows a power conversion efficiency (PCE) of 23.46% with a high fill factor (FF) of over 80%. Furthermore, these devices exhibit enhanced operational stability, with the best device retaining ~ 90% of its initial PCE under 1 Sun illumination with maximum power point tracking for 350 h. Finally, in our last project, we reconfigured the design of the alkylammonium halide salts to create a holistic bulk and interface engineering. We show that dimethylammonium head along with octyl chain and iodide counter anion works best in the bulk whereas dimethylammonium head along with octyl chain and fluoride counter anion works best at the interface. With a synergistic combination of both bulk and surface passivation, we achieved a high PCE of 24.91% along with exceptional long-term operational stability. In summary, in this thesis we employed different strategies based on organic ammonium salts to engineer the bulk a