Publications associées à Triode Solid Oxide Fuel Cell Operation Under Sulfur-Poisoning Conditions

Contrasting Views of the Electric Double Layer in Electrochemical CO2 Reduction: Continuum Models vs Molecular Dynamics

In the field of electrochemical CO2 reduction, both continuum models and molecular dynamics (MD) models have been used to understand the electric double layer (EDL). MD often focuses on the region within a few nm of the electrode, while continuum models ca ...

Amer Chemical Soc2024

Quantifying mass transport limitations in a microfluidic CO2 electrolyzer with a gas diffusion cathode

Sophia Haussener, Venu Gopal Agarwal

A gas diffusion electrode (GDE) based CO2 electrolyzer shows enhanced CO2 transport to the catalyst surface, significantly increasing current density compared to traditional planar immersed electrodes. A two-dimensional model for the cathode side of a micr ...

2024

A pre-fatigue training strategy to stabilize LiCoO2 at high voltage

Lei Zhang, Rui Xia, Kangning Zhao

Layered cathodes are among the most promising cathodes for high-energy-density Li-ion batteries, yet hindered by the structural degradation from both bulk strain and surface oxygen loss at high voltage (above 4.5 V). Herein, we report a pre-fatigue trainin ...

Royal Soc Chemistry2024

Reversible photo-electrochemical device for solar hydrogen and power generation

Sophia Haussener, Alexandre Dominique M. Cattry, Saurabh Yuvraj Tembhurne, Matthieu Jonin, Mahendra Patel

A reversible photo-electrochemical device operating under concentrated irradiation could offer a stand-alone solution for producing solar fuel (in photo-driven electrolysis mode) and power (in fuel cell mode). This strategy would present the advantage of h ...

2024

Membrane electrode assembly simulation of anion exchange membrane water electrolysis

Jan Van Herle, Zoé Mury, Suhas Nuggehalli Sampathkumar, Khaled Lawand

Anion exchange membrane water electrolysis (AEMWE) offers a green hydrogen production method that eliminates the need for platinum group metals (PGM) as electrocatalysts. This study employs a COMSOL (R) 6.0 model to simulate a 1x1 cm(2) Ni fibre - Raney (R ...

Elsevier2024

Electrochemical sensors modified with iron oxide nanoparticles/ nanocomposites for voltammetric detection of Pb (II) in water: A review

Sandro Carrara

Permissible limits of Pb 2+ in drinking water are being reduced from 10 mu gL -1 to 5 mu gL -1 , which calls for rapid, and highly reliable detection techniques. Electrochemical sensors have garnered attention in detection of heavy metal ions in environmen ...

Cell Press2024

Green hydrogen production using Shewanella oneidensis MR-1 bioanode and cuprous oxide-based photocathode

Michele Morgante

In recent years, many efforts have been made to find alternative renewable energy sources that can ideally replace the use of fossil fuels in all aspects. One of the new emerging energy technologies is the bioelectrochemical system, of which two types are ...

EPFL2024

Gas generating membrane-less electrolyser

Demetri Psaltis, Steven Alexandre Schenk, Pooria Hadikhani

Electrolyser including a reactor (2) comprising a housing (4), fluidic channels (6a, 6b, 6c) within the housing, and electrodes (16a, 16c) comprising an anode (16a) and a cathode (16c). The fluidic channels include an inter-electrode channel (6b) arranged ...

2023

Raising the temperature on electrodes for anion exchange membrane electrolysis-activity and stability aspects

Jan Van Herle, Peter Hugh Middleton, Thomas Benjamin Ferriday

The membrane electrode assembly is the powerhouse of the anion exchange membrane water electrolyser (AEMWE), thereby placing a great importance on the associated preparation conditions. This paper investigated how annealing temperature and time impacted ac ...

ELSEVIER2023

Zinc carboxylate optimization strategy for extending Al-air battery system's lifetime

Thi Ha My Pham, Andreas Züttel, Liping Zhong, Manhui Wei

Although Al-air batteries are expected to be the candidates for energy conversion systems in renewable energy market due to the higher energy density, richer reserves, and lighter mass of Al metal, the anode self-discharge is seen as a notorious issue that ...

ELSEVIER SCI LTD2023

Voltage-driven Chemical Reactions Enable the Synthesis of Tunable Liquid Ga – Metal Nanoparticles

Raffaella Buonsanti, Anna Loiudice, Pascal Alexander Schouwink, Valery Okatenko, Coline Marie Agathe Boulanger, Alexander Nicolas Chen, Krishna Kumar

Nanosized particles of liquid metals are emerging materials which hold promise for applications spanning from microelectronics to catalysis. Yet, the knowledge of their chemical reactivity is largely unknown. Here, we study the reactivity of liquid Ga and ...

2023

Pure Amorphous and Ultrathin Phosphate Layer with Superior Ionic Conduction for Zinc Anode Protection

Kangning Zhao

Fast and uniform ion transport within the solid electrolyte interphase (SEI) is considered a crucial factor for ensuring the long-term stability of metal electrodes. In this study, we present the fabrication of ultrathin artificial interphases consisting o ...

Amer Chemical Soc2023

Voltage-driven Reactivity of Liquid Ga and CuGa Nanoparticles for Electrocatalytic CO2 Reduction and Synthesis

Valery Okatenko

The rising atmospheric level of carbon dioxide, CO2, contributes to climate change and poses urgent need to find scalable solutions both to decrease its emissions and to be able to recycle it, if the goals of Paris Agreement to limit the temperature rise a ...

EPFL2023

An Advanced Alkaline Al-Air Fuel Cell Using L-Ascorbic Acid Interface Layer upon Al Anode via Gradient Anti-corrosion

Pengfei Zhang, Manhui Wei

Al metal is considered as an excellent anode material for metal-air fuel cells thanks to the advantages in terms of capacity and energy density. However, the anodic parasitic corrosion has brought great obstacles to the performance breakthrough of Al-air f ...

AMER CHEMICAL SOC2023

Operando Electrochemical Liquid Cell Scanning Transmission Electron Microscopy Investigation of the Growth and Evolution of the Mosaic Solid Electrolyte Interphase for Lithium-Ion Batteries

Corsin Battaglia, Rolf Erni

The solid electrolyte interphase (SEI) is a key component of a lithium-ion battery forming during the first few dischage/charge cycles at the interface between the anode and the electrolyte. The SEI passivates the anode-electrolyte interface by inhibiting ...

Amer Chemical Soc2023

Energy Level Alignment at the Cobalt Phosphate/Electrolyte Interface: Intrinsic Stability vs Interfacial Chemical Reactions in 5 V Lithium Ion Batteries

Nicola Marzari, Matteo Cococcioni

The intrinsic stability of the 5 V LiCoPO4-LiCo2P3O10 thin-film (carbon-free) cathode material coated with MoO3 thin layer is studied using a comprehensive synchrotron electron spectroscopy in situ approach combined with firstprinciple calculations. The at ...

AMER CHEMICAL SOC2022

Sodium Superionic Conductors (NASICONs) as Cathode Materials for Sodium-Ion Batteries

Minmin Liu, Guangwei He, Kangning Zhao

Sodium-ion batteries (SIBs) have developed rapidly owing to the high natural abundance, wide distribution, and low cost of sodium. Among the various materials used in SIBs, sodium superion conductor (NASICON)-based electrode materials with remarkable struc ...

SPRINGERNATURE2021

Towards reproducible lithium-ion battery cycling using liquid-phase transmission electron microscopy

Jing Hou

Electric vehicles (EVs) have gained widespread attention in recent years as the dominant strategy for curbing CO2 emissions through transport electrification. Lithium-ion batteries (LIBs) are currently the most suitable and almost exclusively employed ener ...

EPFL2021

Cu/Metal Oxide Hybrid Nanocrystals as Electrocatalysts for the CO2 Reduction Reaction

Seyedehbehnaz Varandili

The electrochemical CO2 reduction reaction (CO2RR) is envisioned to play a significant role in achieving carbon neutrality while contributing to storing renewable energies. Cu-based materials are among the most promising electrocatalysts. However, 16 diffe ...

EPFL2021

System and method for ground consolidation

Lyesse Laloui, Dimitrios Terzis, Patrick Gabriel Yihsiu-Ming Hicher

The present invention relates to a method for inducing ground consolidation. The method comprises providing a first chamber (7) in a first hole (3) in the ground (5), and a second chamber (7) in a second hole (3) in the ground (5), the first and second cha ...

2020