Publications associées à Testing and modelling of a novel oil-free co-rotating scroll machine with water injection

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

The simultaneous Selective Catalytic Reduction of N2O and NO over Fe-exchanged zeolites

Filippo Buttignol

Iron-exchanged zeolites are industrial heterogeneous catalysts deployed to remediate anthropogenic emissions of both nitrous oxide (N2O) and nitrogen oxides (NOx = NO + NO2). Despite the extensive scientific attention received, limited knowledge is availab ...

EPFL2024

Short-term behavior of glass fiber-polymer composite bending-active elastica beam under service load application

Thomas Keller, Landolf-Giosef-Anastasios Rhode-Barbarigos, Tara Habibi

Bending-active elastica beam is a structural configuration that is based on the elastic deformation of an initially straight beam. This deformation occurs when horizontal displacements are applied to a sliding support, causing the beam to bend into an arch ...

2024

Vapor compression and energy dissipation in a collapsing laser-induced bubble

Mohamed Farhat, Danail Obreschkow, Armand Baptiste Sieber, Davide Bernardo Preso

The composition of the gaseous phase of cavitation bubbles and its role on the collapse remains to date poorly understood. In this work, experiments of single cavitation bubbles in aqueous ammonia serve as a novel approach to investigate the effect of the ...

Aip Publishing2024

Experimental study and interpretative modelling of the Power Exhaust in Configurations with Multiple X-Points in TCV

Sophie Danielle Angelica Gorno

Nuclear fusion presents a promising clean energy source to mitigate future energy crises, with magnetic confinement fusion well-positioned to provide a baseload scenario to power future reactors. The unmitigated power exhaust of such reactors threatens its ...

EPFL2024

Increasing the Energy Efficiency of Gas Boosters for Hydrogen Storage and for Refueling Stations

Alfred Rufer

A new electrically driven gas booster is described as an alternative to the classical air-driven gas boosters known for their poor energetic efficiency. These boosters are used in small scale Hydrogen storage facilities and in refueling stations for Hydrog ...

MDPI2023

The thermodynamic and life-cycle assessments of a novel charging station for electric vehicles in dynamic and steady-state conditions

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

The current study performs the thermodynamic and life-cycle assessments (LCA) of a novel charging station in two system designs. The goal is to design an efficient charging station for electric vehicles with high efficiencies and low environmental impacts ...

Nature Portfolio2023

Combined Passive and Active Ultrasonic Stress Wave Monitoring of UHPFRC Properties on a Structural Level

Eugen Brühwiler, Numa Joy Bertola, Thomas Schumacher

Ultra-High-Performance Fiber-Reinforced Cementitious Composite (UHPFRC) is becoming popular in designing lightweight and durable structures. UHPFRC structural elements remain crack-free and waterproof under service conditions, significantly improving durab ...

2023

Renewable Energy Integration and Waste Heat Recovery for the Production of Sustainable Jet Fuel and Decarbonization of Industrial Heating Applications

François Maréchal, Daniel Alexander Florez Orrego, Meire Ellen Gorete Ribeiro Domingos, Réginald Germanier

The process synthesis and optimization methods used in this work include simulation of biomass gasification, hydrogen and synthetic natural gas production, and jet fuel production via a Fisher Tropsch unit. An energy integration approach, carried out by th ...

American Institute of Chemical Engineering2023

Readiness evaluation of SOFC-MGT hybrid systems with carbon capture for distributed combined heat and power

Jürg Alexander Schiffmann, Jan Van Herle, Michele Gaffuri, Victoria Xu Hong He

The aggravation of climate change calls for the timely development and implementation of highly efficient, renewable, zero- or negative-emission energy solutions with high technological readiness and feasibility levels. Solid oxide fuel cells (SOFC) consti ...

Elsevier2023

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

Flow Boiling of Carbon Dioxide at Different Channel Orientations for the Thermal Management of Future Detector Technologies at the High-Luminosity Large Hadron Collider at CERN

David Schmid

The global warming potential (GWP) of working fluids in thermodynamic cycles and their environmental impact have been gaining considerable attention within the recent years. The global objectives on climate protection are becoming increasingly ambitious, w ...

EPFL2022

Systematic extraction of a control-oriented model from perturbative experiments and SOLPS-ITER for emission front control in TCV

Mirko Wensing, Olivier Claude Martin Février, Artur Perek

Systematic extraction of locally valid dynamic models from experiments is necessary for controller design and the validation of high fidelity models. This paper describes the extraction of a dynamic model in the form of a transfer function, giving the dyna ...

IOP Publishing Ltd2022

Monomeric Fe Species in Square Planar Geometry Active for Low Temperature NH3-SCR of NO

Oliver Kröcher, Davide Ferri

Monomeric Fe species in zeolites are considered to be the active sites for the low temperature activity toward ammonia-assisted selective catalytic reduction of nitrogen oxides (NH3-SCR) in exhaust gases. Herein, we report on a preparation method to synthe ...

AMER CHEMICAL SOC2022

Analysis of barrette foundations subjected to mechanical and thermal loads

Lyesse Laloui, Alessandro Francesco Rotta Loria

In recent years, there has been increasing interest in the use of rectangular barrette foundations for the structural support and energy supply of tall buildings when circular piles become inefficient or uneconomical. In such applications, so-called energy ...

2022

Two novel cogeneration charging stations for electric vehicles: Energy, exergy, economic, environment, and dynamic characterizations

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

This paper suggests two novel designs for the electric vehicle charging stations using LiMn2O4 Lithium-ion battery and based on a Solid Oxide Fuel Cell (SOFC) and absorption refrigeration cycle (ARC) technologies to provide electricity and cooling, respect ...

Elsevier2022

Hybrid Modular Multilevel Converter for Pumped Hydro Storage Applications

Miodrag Basic

Energy balance in a power system must be maintained at all times, regardless of the variations in generation and consumption. Large Pumped Hydro Storage Plants (PHSPs) are introduced to the power system to accumulate the excess of energy during the low dem ...

EPFL2022

Intentional oxygen oscillations on Pd/Al2O3 for enhanced methane removal from the exhaust of natural gas engines

Maneka Claire Roger

Natural gas (NG) is a suitable alternative to gasoline and diesel fuels to decrease the carbon footprint of the mobility and energy sectors. Although NG is considered a fossil fuel, methane (CH4), its main component, can be produced industrially from power ...

EPFL2022

A High Efficiency Pneumatic Drive System Using Vane-Type Semi-Rotary Actuators

Alfred Rufer

A compressed air driven generator is proposed, where the pneumatic energy is converted into mechanical energy using two vane-type rotational actuators. The use of a second actuator with a higher displacement in order to produce a thermodynamic expansion al ...

UNIV NIS2021

Scoping the characteristics and benefits of a connected double-null configuration for power exhaust in EU-DEMO

Holger Reimerdes, Marco Wischmeier, Mirko Wensing

A double-null configuration is being considered for the EU-DEMO, due to its potential benefits for power exhaust arising from the use of two active divertors and magnetically disconnected low- and high-field sides. Using systematic parameter scans in fluid ...

Elsevier2021