Publications associées à Data-Driven Predesign Tool for Small-Scale Centrifugal Compressor in Refrigeration

Vapor compression and energy dissipation in a collapsing laser-induced bubble

Mohamed Farhat, Danail Obreschkow, Armand Baptiste Sieber, Davide Bernardo Preso

The composition of the gaseous phase of cavitation bubbles and its role on the collapse remains to date poorly understood. In this work, experiments of single cavitation bubbles in aqueous ammonia serve as a novel approach to investigate the effect of the ...

Aip Publishing2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Increasing the Energy Efficiency of Gas Boosters for Hydrogen Storage and for Refueling Stations

Alfred Rufer

A new electrically driven gas booster is described as an alternative to the classical air-driven gas boosters known for their poor energetic efficiency. These boosters are used in small scale Hydrogen storage facilities and in refueling stations for Hydrog ...

MDPI2023

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

High-speed turbocompressors for natural fluid heat-pumps: from integrated design to digital-twin

Luis Eric Olmedo Ocampo

Compressors for commercial and industrial heat-pumps in the 100kW-load range are currently dominated by positive displacementmachines. In the context of refrigerant phaseouts and changing regulations, natural refrigerants are seen as a compelling alternati ...

EPFL2023

Heat pumping and renewable energy integration for decarbonizing brewery industry and district heating

François Maréchal, Daniel Alexander Florez Orrego, Meire Ellen Gorete Ribeiro Domingos

The energy integration of brewery plants and urban agglomerations has many benefits in terms of rational energy use and reduced environmental impact, especially during scenarios of uncertain supply chain and volatile market prices. In fact, the diversifica ...

Elsevier2023

The influence of splitter blades and meridional profiles on the performance of small-scale turbopumps for ORC applications; analysis, neural network modeling and optimization

Jürg Alexander Schiffmann, Sajjad Zakeralhoseini

This work presents the influence of splitters on the performance of small-scale turbopumps for organic Rankine cycle applications numerically. Different design parameters, such as impeller diameter at the outlet, number of blades, blade angle at the traili ...

2023

Design, computational and experimental investigation of a small-scale turbopump for organic Rankine cycle systems

Jürg Alexander Schiffmann, Sajjad Zakeralhoseini

The hydraulic design, computational analysis, and experimental investigations of a high-speed small-scale turbopump for mobile waste heat recovery applications based on organic Rankine cycle systems are presented in this paper. Such applications demand hig ...

Elsevier2023

Experimental study of the hydrodynamic and thermal performances of ventilated wall structures

Mohammad Rahiminejad, Dolaana Khovalyg

The presence of a ventilated air gap behind the external cladding in a building envelope is known to have a tangible contribution to the overall performance of the wall assembly. In the present study, the hydrodynamic and thermal performances of ventilated ...

2023

Heat transfer of uncoated and nanostructure coated commercially micro-enhanced refrigeration tubes under pool boiling conditions

John Richard Thome

The heat transfer performance of commercially produced micro-enhanced tubes with and without a nanocoating was investigated under pool boiling of saturated refrigerant. These multiscale enhancements were on the outside of 19 mm horizontal copper tubes heat ...

Pergamon-Elsevier Science Ltd2023

Renewable Energy Integration and Waste Heat Recovery for the Production of Sustainable Jet Fuel and Decarbonization of Industrial Heating Applications

François Maréchal, Daniel Alexander Florez Orrego, Meire Ellen Gorete Ribeiro Domingos, Réginald Germanier

The process synthesis and optimization methods used in this work include simulation of biomass gasification, hydrogen and synthetic natural gas production, and jet fuel production via a Fisher Tropsch unit. An energy integration approach, carried out by th ...

American Institute of Chemical Engineering2023

DIET Controller: Dynamic Indoor Environment using Deep Reinforcement Learning

Arnab Chatterjee

Heating, Ventilation, and Air Conditioning (HVAC) Systems utilize much energy, accounting for 40% of total building energy use. The temperatures in buildings are commonly held within narrow limits, leading to higher energy use. Measurements from office bui ...

EPFL2023

Techno-economic and environmental analysis of high temperature heat pumps integration into industrial processes: the ammonia plant and pulp mill cases

François Maréchal, Daniel Alexander Florez Orrego, Meire Ellen Gorete Ribeiro Domingos

Heat pumps will play an important role in improving the performance of the industrial processes aiming to decarbonize their heating requirements. Yet, defining the best operating conditions of those devices may be a challenging task, as they are embedded i ...

2023

Transparent structured conductive coating for applications in smart windows

Jérémy Jacques Antonin Fleury

Solar radiation reaching the surface of the earth for a period of one hour contains more energy than that consumed by mankind over an entire year. Some of this solar energy is already collected by photovoltaic cells to cover the electricity needs of buildi ...

EPFL2023

An Integrated Approach to Designing Robust Turbocompressors on Gas Bearings Through Surrogate Modeling and Constrained Multi-Objective Optimization

Jürg Alexander Schiffmann, Cyril Picard, Soheyl Massoudi

Designing turbocompressors is a complex and challenging task, as it involves balancing conflicting objectives such as efficiency, stability, and robustness against manufacturing deviations. This paper proposes an integrated design methodology for turbocomp ...

ASME Amer Soc Mechanical Engineers2023

Numerical and experimental investigation of spiral-grooved gas journal bearings

Elia Iseli

Small-scale turbomachinery is increasingly used in carbon-free energy conversion systems, such as commercial or domestic scale heat pumps, fuels cells for transportation and waste heat recovery. The usage of aerodynamic bearings allows the design of compac ...

EPFL2022

Flow Boiling of Carbon Dioxide at Different Channel Orientations for the Thermal Management of Future Detector Technologies at the High-Luminosity Large Hadron Collider at CERN

David Schmid

The global warming potential (GWP) of working fluids in thermodynamic cycles and their environmental impact have been gaining considerable attention within the recent years. The global objectives on climate protection are becoming increasingly ambitious, w ...

EPFL2022

Robust design using multiobjective optimisation and artificial neural networks with application to a heat pump radial compressor

Jürg Alexander Schiffmann, Cyril Picard, Soheyl Massoudi

Although robustness is an important consideration to guarantee the performance of designs under deviation, systems are often engineered by evaluating their performance exclusively at nominal conditions. Robustness is sometimes evaluated a posteriori throug ...

2022

Heat recovery potential from ventilated passive and active facades

Mohammad Rahiminejad, Dolaana Khovalyg

A ventilated air-space behind external claddings can potentially affect the thermal performance of the entire building structure. In particular, in the Building Integrated Photovoltaic (BIPV) facades, ventilated cavities are typically present between the P ...

TU Delft OPEN2022

Two novel cogeneration charging stations for electric vehicles: Energy, exergy, economic, environment, and dynamic characterizations

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

This paper suggests two novel designs for the electric vehicle charging stations using LiMn2O4 Lithium-ion battery and based on a Solid Oxide Fuel Cell (SOFC) and absorption refrigeration cycle (ARC) technologies to provide electricity and cooling, respect ...

Elsevier2022