Publications related to Pitot-static system

Numerical and experimental investigation of spiral-grooved gas journal bearings

Small-scale turbomachinery is increasingly used in carbon-free energy conversion systems, such as commercial or domestic scale heat pumps, fuels cells for transportation and waste heat recovery. The usage of aerodynamic bearings allows the design of compac ...

EPFL2022

The dynamics and timescales of static stall

Karen Ann J Mulleners, Sébastien Le Fouest, Julien Dominique Claude Deparday

Airfoil stall plays a central role in the design of safe and efficient lifting surfaces. We typically distinguish between static and dynamic stall based on the unsteady rate of change of an airfoil’s angle of attack. Despite the somewhat misleading denotat ...

2021

Analysis of Pitot tube Airflow Velocity Sensor Behavior in Blockage Situations

Ata Jedari Golparvar

Several airplanes crashes throughout the past decades are linked to the failure of the airplane flow velocity sensor known as pitot device or pitot tube. The study of its behavior in blockage, either due to human errors or due to environmental factors, cou ...

IEEE2020

Physical Mechanism and Flow Control of Tip Vortex Cavitation

Ali Amini

Occurrence of cavitation in hydraulic machines is a challenging issue because it is often accompanied with loss of efficiency, noise emissions, vibrations, and erosion damages. Tip vortices, in particular, are an ideal site for the development of cavitatio ...

EPFL2020

Time-Continuous Phosphorus Flows in the Indian Agri-Food Sector: Long-Term Drivers and Management Options

Claudia Rebeca Binder Signer

Phosphorus (P) is a major agricultural nutrient and, in its mineable form, a potentially scarce resource. Countries with limited physical access to P should hence develop an effective national P governance. This requires analyses of trends and variations i ...

2018

A new bioinspired method for pressure and flow sensing based on the underwater air-retaining surface of the backswimmer Notonecta

Goran Lovric

In technical systems, static pressure and pressure changes are usually measured with piezoelectric materials or solid membranes. In this paper, we suggest a new biomimetic principle based on thin air layers that can be used to measure underwater pressure c ...

2018

Compact and Efficient UC Commitments under Atomic-Exchanges

Serge Vaudenay

We devise a multiple (concurrent) commitment scheme operating on large messages. It uses an ideal global setup functionality in a minimalistic way. The commitment phase is non-interactive. It is presented in a modular way so that the internal building bloc ...

2014

Sampling and Reconstruction of Spatial Fields using Mobile Sensors

Martin Vetterli, Jayakrishnan Unnikrishnan

Spatial sampling is traditionally studied in a static setting where static sensors scattered around space take measurements of the spatial field at their locations. In this paper we study the emerging paradigm of sampling and reconstructing spatial fields ...

Institute of Electrical and Electronics Engineers2013

MEMS Tunable Asymmetric Fabry-Perot Cavity for High-Precision Weighing of Macro Samples

Luc Thévenaz, Alexandre Poulin, Yves-Alain Peter

We propose a microelectromechanical systems-based tunable asymmetric Fabry-Perot cavity for the high-precision weighing of macro samples. The device is based on an in-plane design and is structured in a silicon-on-insulator substrate. The cavity length of ...

Institute of Electrical and Electronics Engineers2013

Sampling and reconstructing spatial fields using mobile sensors

Martin Vetterli, Jayakrishnan Unnikrishnan

The classical approach to sampling time-invariant spatial fields uses static sensors distributed over space. We study a new approach involving mobile sensors that move through space measuring the field values along their paths. A single moving sensor can t ...

Ieee2012

Energy partition at the collapse of spherical cavitation bubbles

Mohamed Farhat, Nicolas Dorsaz, Danail Obreschkow, Philipp Kobel, Marc Tinguely, Aurèle De Bosset

Spherically collapsing cavitation bubbles produce a shock wave followed by a rebound bubble. Here we present a systematic investigation of the energy partition between the rebound and the shock. Highly spherical cavitation bubbles are produced in micrograv ...

American Physical Society2012

Influence of Blade Aspiration on the Flow Quality of an Annular Axial Compressor Cascade

Peter Ott, Elia Colombo

Experimental and numerical investigations were performed in order to develop a technique of active flow control by aspiration applied to an annular axial compressor cascade. Continuous aspiration is applied through shaped slots located on the suction side ...

2011

Advanced Instrumentation for Measuring Fluid-Structure Coupling Phenomena in the Guide Vanes Cascade of a Pump-Turbine Scale Model

François Avellan, Mohamed Farhat, Vlad Hasmatuchi, Steven Roth, Francisco Botero

In the present study, the fluid-structure coupling is investigated in the guide vanes of a pump-turbine scale model placed in one of the test rigs of the Laboratory for Hydraulic Machines (EPFL) in Lausanne. The paper focuses on the advanced instrumentatio ...

American Soc Mechanical Engineers, Three Park Avenue, New York, Ny 10016-5990 Usa2010

Structural identification to improve bridge management

Ian Smith, James-Alexandre Goulet

This paper presents results from static loads tests performed on the new Langensand Bridge built in Switzerland. A systematic study of over 1000 models subjected to three load cases identifies a set of 11 candidate models through static measurements. Predi ...

International Association for Bridge and Structural Engineering2009

A 10-gram Vision-based Flying Robot

Dario Floreano, Jean-Christophe Zufferey, Jean-Daniel Nicoud, Antoine Beyeler, Adam Klaptocz

We aim at developing ultralight autonomous microflyers capable of freely flying within houses or small built environments while avoiding collisions. Our latest prototype is a fixed-wing aircraft weighing a mere 10 g, flying around 1.5 m/s and carrying the ...

2007

A 10-gram Microflyer for Vision-based Indoor Navigation

Dario Floreano, Jean-Christophe Zufferey, Jean-Daniel Nicoud, Antoine Beyeler, Adam Klaptocz

We aim at developing ultralight autonomous microflyers capable of navigating within houses or small built environments. Our latest prototype is a fixed-wing aircraft weighing a mere 10 g, flying around 1.5 m/s and carrying the necessary electronics for air ...

IEEE2006

Sintering of NaCl powder: Mechanisms and first stage kinetics

Andreas Mortensen, Jean-François Despois

Isothermal NaCl sintering experiments are conducted between 500 and 790 degrees C on powders 75, 100, 150 and 400 mu m in average diameter. Along with literature data, the results are compared with theoretical predictions for the initial stage of sintering ...

2006

Characterization of supersonic low pressure plasma jets

Malko Gindrat

Low Pressure Plasma Spraying (LPPS) processes use a DC plasma jet expanding at low pressure for fast deposition of dense coatings in a controlled atmosphere. The LPPS technology is widely used industrially in particular in the aeronautics and medical indus ...

EPFL2004