Signal reflection

Applied sciences
Electrical engineering
Radio-frequency engineering
Topics in radio-frequency e...

About
Privacy
Disclaimer

Graph Chatbot

Related publications (29)

Nanocrystalline Low-Refractive Magnesium Fluoride Films Deposited by Reactive Magnetron Sputtering: Optical and Structural Properties

Jean-Louis Scartezzini, Paul Muralt, Silviu Cosmin Sandu, Stefan Mertin

In this work, we study MgF2 thin-film synthesis by reactive pulsed DC magnetron sputtering from a metallic magnesium target in a gas mixture of argon, oxygen, and carbon tetrafluoride (CF4). Nanocrystalline films on silicon and glass substrates with excell ...

Wiley-Blackwell2015

Calibration method and system

Martin Vetterli, Ivan Dokmanic

The present invention concerns a method for calibrating an array of receivers (ri), each receiver being configured for receiving a signal transmitted by at least one transmitter (si), and echoes of the transmitted signal as reflected by one or more reflect ...

2014

Reconfigurable Pixel-Layer Isolator for Frequency-Tunable On-Frequency Repeaters

Daniel Rodrigo Lopez

The maximum gain in on-frequency repeaters is limited by the isolation level between their two antennas due to close-loop stability conditions. In this letter, a novel pixel-layer isolator for tunable on-frequency repeaters is presented. The scattered fiel ...

Institute of Electrical and Electronics Engineers2014

Sparse Reverberant Audio Source Separation via Reweighted Analysis

Jean-Philippe Thiran, Pierre Vandergheynst, Yves Wiaux, Rafael Eduardo Carrillo Rangel

We propose a novel algorithm for source signals estimation from an underdetermined convolutive mixture assuming known mixing filters. Most of the state-of-the-art methods are dealing with anechoic or short reverberant mixture, assuming a synthesis sparse p ...

Institute of Electrical and Electronics Engineers2013

Electromagnetic Simulation of CERN Accelerator Components and Experimental Applications

Carlo Zannini

Wakes and impedances of single accelerator elements can be obtained by means of theoretical calculation, electromagnetic (EM) simulations or bench measurements. Since theoretical calculations apply only to simple structures and bench measurements have some ...

EPFL2013

Laboratory Investigation on Seismic Response of Rock Fractures Filled with Granular Materials

Wei Wu

Filling materials may exist in all scales of rock fractures, not only influencing seismic wave attenuation, but controlling rock mass instability. The objective of this study is to experimentally investigate the seismic response of rock fractures filled wi ...

EPFL2013

Dynamic response of a rock fracture filled with viscoelastic materials

Jian Zhao, Wei Wu, Jianbo Zhu

Rock fractures filled with viscoelastic materials, such as sand, usually contribute to rock mass instability under the influence of seismic waves and dynamic loads. The purpose of this study is to verify that the specific fracture stiffness and the specifi ...

Elsevier2013

An Efficient Method Based on the Electromagnetic Time Reversal to Locate Faults in Power Networks

Farhad Rachidi-Haeri, Mario Paolone, Carlos Alberto Romero Romero, Reza Razzaghi, Gaspard Lugrin

This paper presents a new method based on the electromagnetic time-reversal (EMTR) theory for locating faults in power networks. The applicability of the EMTR technique to locate faults is first discussed. Using the classical transmission-line equations in ...

Institute of Electrical and Electronics Engineers2013

Wave propagation across rock joints filled with viscoelastic medium using modified recursive method

Jian Zhao, Wei Wu, Jianbo Zhu

Rock joints have significant effects on wave propagation. When the joints are filled with saturated sand or clay, the filling materials exhibit viscoelastic behavior on wave propagation. In the present study, wave propagation across single and multiple par ...

Elsevier2012

Page 2 of 2