Molding (process)

Natural sciences
Chemistry
Organic chemistry
Polymer chemistry

About
Privacy
Disclaimer

Graph Chatbot

Related publications (26)

Morphological investigation of polylactide/microfibrillated cellulose composites

Pierre-Etienne Bourban, John Christopher Plummer, Carole Boissard

Optical microscopy and transmission electron microscopy have been used to investigate the morphology of polylactide (PLA)/microfibrillated cellulose (MFC) composites prepared by: compression molding of wet-comingled MFC and PLA latex or powder, twin-screw ...

Springer Berlin Heidelberg2013

Fabrication of structured anode-supported solid oxide fuel cell by powder injection molding

Jan Van Herle, Antonin Faes, Zacharie Wuillemin, Amédée Zryd

Powder Injection Molding (PIM) gives the possibility to produce, at an industrial rate, ceramic parts with fine details. It is thus a possible approach to reduce the fabrication costs of Solid Oxide Fuel Cells (SOFCs). This work presents fabrication and el ...

2013

The effect of processing conditions on the morphology, thermomechanical, dielectric, and piezoelectric properties of P(VDF-TrFE)/BaTiO3 composites

Véronique Michaud, Yves Leterrier, Dragan Damjanovic, Sara Dalle Vacche

In this study (0-3) P(VDF-TrFE)/BaTiO3 composites containing up to 60 vol% of ceramic phase were prepared by solvent casting or compression molding. Their thermomechanical, dielectric, and piezoelectric properties were investigated, and discussed in the li ...

Springer Verlag2012

Processing and tribology of thermoplastic polyurethane particulate composite materials

Véronique Michaud, Stefano Mischler, Basile Golaz, Samy Tétouani

The processing, mechanical and tribological properties of wax containing thermoplastic polyurethane–filler composites were studied for different weight ratios of graphite, TiO2, MoS2, and ZrO2 microparticles and SiO2 nanoparticles. The composites were comp ...

Wiley-Blackwell2012

Heterogeneous material micro-transfer by ink-jet print assisted mould filling

Jürgen Brugger, Grégoire Maxime Smolik, Victor Javier Cadarso Busto, Loïc Jacot-Descombes, Vaida Auzelyte

A novel combination of ink-jet printing (IJP) and micro-transfer moulding (μ-TM) for high-resolution, heterogeneous material microstructuring is demonstrated. First, IJP is used to accurately fill the micro-cavities in an elastomeric mould, thus avoiding t ...

Elsevier2012

Investigation of process-induced strains development by fibre Bragg grating sensors in resin transfer moulded composites

Véronique Michaud

A comprehensive understanding of the development of residual strains in composite processing is essential to manufacture high quality composite parts. In this paper, the use of fibre Bragg grating (FBG) optical sensors was investigated to measure in situ t ...

Elsevier2011

Page 2 of 2