Publications associées à Prospective short-circuit current

Assessment of the Feasibility of Applying the Electromagnetic Time Reversal Theory to Locate Defects in Grounding Electrodes

Farhad Rachidi-Haeri, Marcos Rubinstein, Hamidreza Karami, Rafael Silva Alipio

In recent years, the electromagnetic time reversal (EMTR) theory has been successfully applied for locating various sources of disturbances, such as short-circuit faults, in power systems. In this paper, a theoretical analysis of the feasibility of applyin ...

2023

Potential-induced degradation in bifacial silicon heterojunction solar modules: Insights and mitigation strategies

Christophe Ballif, Quentin Thomas Jeangros, Alessandro Francesco Aldo Virtuani, Olatz Arriaga Arruti, Luca Gnocchi

Potential-induced degradation (PID) may be a serious concern in photovoltaic (PV) modules and plants, particularly when approaching high system voltages (1500+ V). Here, we investigate PID occurring in bifacial rear-emitter silicon heterojunction (SHJ) sol ...

Wiley2023

Some Results of the EU Project FASTGRID

Manuel Bauer

The EU FASTGRID project aimed at improving the REBCO conductor in order to enhance its economical attractiveness for the Superconducting Fault Current Limiter (SFCL). Two approaches were simultaneously investigated: i) the reduction of the tape length thro ...

IEEE Institute of Electrical and Electronics Engineers2022

Vacuum Circuit Breaker Closing Time Key Moments Detection via Vibration Monitoring: A Run-to-Failure Study

Olga Fink, Gaëtan Michel Frusque

Circuit breakers (CBs) play an important role in modern society because they make the power transmission and distribution systems reliable and resilient. Therefore, it is important to maintain their reliability and to monitor their operation. A key to ensu ...

2022

Shoot-Through Protection for an IGCT-Based ZVS Resonant DC Transformer

Drazen Dujic, Jakub Kucka

IGCTs have successfully demonstrated to be well-suited devices for an application in medium-voltage dc transformers based on LLC resonant converter topology. This application enables unusually high switching frequencies in kHz range thanks to the zero-volt ...

2022

Corrosion testing of solar cells: Wear-out degradation behavior

Christophe Ballif, Alessandro Francesco Aldo Virtuani, Luca Gnocchi, Andrew Wayne Fairbrother

Corrosion is one of the main end-of-life degradation and failure modes in photovoltaic (PV) modules. However, it is a gradual process and can take many years to become a major risk factor because of the slow accumulation of water and acetic acid (from enca ...

ELSEVIER2022

Superconductors for power applications: an executable and web application to learn about resistive fault current limiters

Francesco Grilli, Nicolo' Riva, Bertrand Dutoit, Bertrand Dutoit

High-temperature superconductors (HTS) can be superconducting in liquid nitrogen (77 K) at atmospheric pressure, which holds immense promises for our future such as nuclear fusion, compact medical devices and efficient power applications. In a power system ...

2021

An Effective EMTR-Based High-Impedance Fault Location Method for Transmission Lines

Farhad Rachidi-Haeri, Rong Zeng

This article summarizes the electromagnetic time-reversal (EMTR) technique for fault location, and further numerically validates its effectiveness when the fault impedance is negligible. In addition, a specific EMTR model considering the fault impedance is ...

2021

Performance assessment of Synchronous Condensers vs Voltage Source Converters providing grid-forming functions

Mario Paolone

Having sufficient grid-forming sources is one of the necessary conditions to guarantee the stability in a power system hosting a very large share of inverter-based generation. The grid-forming function has been historically fulfilled by synchronous machine ...

IEEE2021

Fast Hotspot Detection in SFCLs by Exploiting Strain Response in Optical Fiber Sensing

Luc Thévenaz, Nicolo' Riva, Zhisheng Yang, Arooj Akbar, Bertrand Dutoit, Bertrand Dutoit

Superconducting fault current limiters (SFCLs) can be used to limit fault currents in both meshed DC and AC grids by transitioning from superconducting to resistive state, in the presence of high currents. While the device is theoretically a great way to p ...

IEEE Institute of Electrical and Electronics Engineers2021

Potential Induced Degradation Mechanism in Rear-Emitter Bifacial Silicon Heterojunction Solar Cells Encapsulated in Different Module Structures

Christophe Ballif, Quentin Thomas Jeangros, Alessandro Francesco Aldo Virtuani, Olatz Arriaga Arruti, Luca Gnocchi

Recent studies showed that silicon heterojunction (SHJ) solar cells can be prone to potential induced degradation (PID) when encapsulated with ethylene vinyl acetate (EVA). Here, to gain understanding in the role of EVA, we perform PID test in humid condit ...

IEEE2021

Protection Coordination for Reliable Marine DC Power Distribution Networks

Drazen Dujic, Seongil Kim, Gabriele Ulissi

This paper presents demonstration of a protection scheme integrated into marine DC power distribution networks to investigate the coordination between each protection action. The integrated protection scheme is based on three different time-frame protectio ...

2020

Solid State Bus Tie Switch for Shipboard Power Distribution Networks

Drazen Dujic, Gabriele Ulissi

Recent trends in shipboard power distribution network design, such as the transition from AC to DC result in new challenges on the issue of distribution network protection. Devices such as a solid state bus tie switch provide a first line of defence agains ...

2020

Hole transporting materials for perovskite solar cells and a simple approach for determining the performance limiting factors

Mohammad Khaja Nazeeruddin, Iwan Zimmermann, Tom Theodorus Antonius Lummen

The synthesis and characterization of three novel HTMs with different highest occupied molecular orbital (HOMO) energy levels and their performances in MAPbI(3)-based devices in comparison with Spiro-OMeTAD is reported. Without systematic optimization, the ...

Royal Society of Chemistry2020

Time-resolved open-circuit conductive atomic force microscopy for direct electromechanical characterisation

Anna Fontcuberta i Morral, Wonjong Kim, Jelena Vukajlovic Plestina

Studying nanomaterial piezoelectricity and triboelectricity is attractive for energy and sensing applications. However, quantitative characterisation of electromechanical effects in nanomaterials is challenging due to practical limitations and possible com ...

2020

Deexcitation Characterization for Power Supply Protection in DC Shipboard Power Systems

Drazen Dujic, Seongil Kim

The deexcitation of a synchronous machine has been used for the protection of the power supply based on a diode rectifier in marine dc power distribution networks. The fault current from the generator can be eliminated with the protection method utilizing ...

IEEE2020

Scalable Marine Bus-Tie Switch for Switchboard Interconnections

Drazen Dujic, Gabriele Ulissi

DC power distribution systems in marine applications are in the process of being established as the preferred solution for shipboard power distribution systems. This paper presents a bus-tie switch topology for the protection of such systems. The device is ...

2020

A cost-device efficiency balanced spiro based hole transport material for perovskite solar cells

Mohammad Khaja Nazeeruddin

Although spiro-MeOTAD 1 is a superior hole-transporting material (HTM) commonly employed in perovskite solar cells (PSC), its high cost is one of the major issues holding back commercialization, which has not been resolved to-date. In this article we intro ...

Royal Society of Chemistry2020

Integrative decision-making strategy for fluvial neighborhoods in transition

Martine Laprise, Sara Sonia Formery Regazzoni, Emmanuel Rey

The changing relationships between cities and their waters over the centuries lead today – after a clear sidelining of rivers in the city – to question their potential for building new interactions. Current densification objectives of the existing built fa ...

2020

Optimized kW-Range Boost Converter Based on Impulse Rectification with 52 kW/l and 98.6% Efficiency

Elison de Nazareth Matioli, Remco Franciscus Peter van Erp, Armin Jafari

Maximizing the efficiency and power density of dc-dc converters demands parallel optimizations in design and control, especially for variable-frequency converters operating over wide frequency ranges. This work presents the full-scale optimization of a kil ...

2021