Publications associées à Paramètres S

Sensitivity Analysis of the Lumped Thermal Model of the EU 170 GHz Gyrotron Magnetron Injection Gun

The ITER Electron Cyclotron Resonance Heating and Current Drive (ECRH&CD) system relies on 1 MW 170 GHz Gyrotrons to provide the mm-wave power needed for plasma heating, current drive, and magneto-hydrodynamic control. The design and modeling of the contro ...

Ieee-Inst Electrical Electronics Engineers Inc2024

On the use of Cramér-Rao Lower Bound for least-variance circuit parameters identification of Li-ion cells

Mario Paolone, Vladimir Sovljanski

Electrochemical Impedance Spectroscopy (EIS) and Equivalent Circuit Models (ECMs) are widely used to characterize the impedance and estimate parameters of electrochemical systems such as batteries. We use a generic ECM with ten parameters grouped to model ...

2024

The effect of plasma shaping on high density H-mode SOL profiles and fluctuations in TCV

Holger Reimerdes, Benoît Labit, Christian Gabriel Theiler, Umar Sheikh, Guang-Yu Sun, Luke Simons, Nicola Vianello, Sophie Danielle Angelica Gorno, Cedric Kar-Wai Tsui, Claudia Colandrea, Adriano Stagni, Yi Wang

The impact of plasma shaping on the properties of high density H-mode scrape-off layer (SOL) profiles and transport at the outer midplane has been investigated on Tokamaka configuration variable. The experimental dataset has been acquired by evolving the u ...

IOP Publishing Ltd2024

Primary and secondary order parameters in the fully frustrated transverse-field Ising model on the square lattice

Frédéric Mila

Using quantum Monte Carlo simulations and field-theory arguments, we study the fully frustrated transversefield Ising model on the square lattice for the purpose of quantitatively relating two different order parameters to each other. We consider a "primar ...

Amer Physical Soc2024

A Two-Wired High Input Impedance and High CMRR Active Electrode Insensitive to Component Mismatch

Alexandre Schmid, Mehdi Saberi

This article proposes a new two-wired amplifying active electrode (AE), presenting a high input impedance and a high common-mode rejection ratio (CMRR). In the proposed structure, the input impedance and the CMRR of the system are considerably increased by ...

Ieee-Inst Electrical Electronics Engineers Inc2024

The connection of the acyclic disconnection and feedback arc sets - On an open problem of Figueroa et al

Lukas Fritz Felix Vogl

We examine the connection of two graph parameters, the size of a minimum feedback arcs set and the acyclic disconnection. A feedback arc set of a directed graph is a subset of arcs such that after deletion the graph becomes acyclic. The acyclic disconnecti ...

Elsevier2024

Topological photonic transport in disordered scattering networks

Zhechen Zhang

This Ph.D. thesis unveils the unique topological phenomena occurring in such networks, focusing on the intricate interplay between their Floquet topology, the presence of disorder, and their unitary scattering at microscopic and macroscopic scales. Using t ...

EPFL2024

Large reconfigurable quantum circuits with SPAD arrays and multimode fibers

Edoardo Charbon, Claudio Bruschini, Ivan Michel Antolovic

Reprogrammable integrated optics provides a natural platform for tunable quantum photonic circuits, but faces challenges when high dimensions and high connectivity are involved. Here, we implement high-dimensional linear transformations on spatial modes of ...

Optica Publishing Group2024

Role of Minimum Adhesive Wear Particle Size in Third-Body Layer Properties

Jean-François Molinari, Son-Jonathan Pham-Ba

We employ a novel discrete element method (DEM) force formulation to simulate adhesive wear and assess the effects of material and loading parameters on the properties of the third-body layer (TBL) formed during sliding motion. The study emphasizes the rol ...

2023

Diagnosing weakly first-order phase transitions by coupling to order parameters

Jonathan D'Emidio

The hunt for exotic quantum phase transitions described by emergent fractionalized de-grees of freedom coupled to gauge fields requires a precise determination of the fixed point structure from the field theoretical side, and an extreme sensitivity to weak ...

2023

Design and Development of a Diagnostic System for a Non-Intercepting Direct Measure of the SPIDER Ion Source Beamlet Current

Stable and uniform beams with low divergence are required in particle accelerators; therefore, beyond the accelerated current, measuring the beam current spatial uniformity and stability over time is necessary to assess the beam performance, since these pa ...

MDPI2023

Beam homogeneity of caesium seeded SPIDER using a direct beamlet current measurement

The ITER Heating Neutral Beam (HNB) source prototype SPIDER (Source for the Production of Ions of Deuterium Extracted from a Radio frequency plasma), hosted at the Neutral Beam Test Facility (NBTF) in Padova, Italy, has recently started operating with evap ...

ELSEVIER SCIENCE SA2023

Data-driven modeling of beam loss in the LHC

Tatiana Pieloni, Michael Schenk, Ekaterina Krymova, Loïc Thomas Davies Coyle

In the Large Hadron Collider, the beam losses are continuously measured for machine protection. By design, most of the particle losses occur in the collimation system, where the particles with high oscilla-tion amplitudes or large momentum error are scrape ...

FRONTIERS MEDIA SA2023

Comparison of momentum transport in matched hydrogen and deuterium H-mode plasmas in ASDEX Upgrade

Basil Duval, Emiliano Fable, Giovanni Tardini

Advanced momentum transport analysis is used to study matched hydrogen (H) and deuterium (D) plasmas in the core of ASDEX Upgrade. The aim is to validate gyrokinetic theory and assess a possible isotope dependence. The methodology extracts momentum diffusi ...

IOP Publishing Ltd2023

Electronic Coupling of Metal-to-Insulator Transitions in Nickelate-Based Heterostructures

Duncan Thomas Lindsay Alexander, Bernat Mundet, Jean-Marc Triscone

In rare earth nickelates, the metal-to-insulator transition observed as a function of temperature can be described using an electronic and a structural order parameter. The electronic one is linked to the electronic disproportionation observed below the tr ...

WILEY2023

Hybridization driving distortions and multiferroicity in rare-earth nickelates

Nicola Marzari, Iurii Timrov, Michele Kotiuga, Luca Binci

For decades transition-metal oxides have generated a huge interest due to the multitude of physical phenomena they exhibit. In this class of materials, the rare-earth nickelates, RNiO3, stand out for their rich phase diagram stemming from complex couplings ...

Amer Physical Soc2023

Diverse parameters of ambulatory knee moments differ with medial knee osteoarthritis severity and are combinable into a severity index

Julien Favre, Brigitte Jolles-Haeberli

Objective: To characterize ambulatory knee moments with respect to medial knee osteoarthritis (OA) severity comprehensively and to assess the possibility of developing a severity index combining knee moment parameters. ...

FRONTIERS MEDIA SA2023

Performance of the Cable-in-Conduit Conductors for Super-X Test Facility

Kamil Sedlák

Following the conceptual design, the engineering design of the dc magnet and cable-in-conduit conductor (CICC) for the Super-X test facility has been done in 2021. Totally three types of conductors with different structures were designed for the three pair ...

IEEE Institute of Electrical and Electronics Engineers2023

Indentation and stability of woven domes

Pedro Miguel Nunes Pereira de Almeida Reis, Célestin Vallat, Tian Chen, Tomohiko Sano, Samuel Jean Bernard Poincloux

Discrete domes are doubly curved structures comprising a network of beam-like elements. We study the mechanics of discrete domes made of ribbons woven in a pentagonal triaxial pattern. Experiments and finite element simulations are performed to characteriz ...

ELSEVIER2023

ICRH assisted breakdown study on JET

Benoît Labit, Thomas Binderup Jensen, Haomin Sun

Ion cyclotron (IC) wave assisted breakdown has the potential to increase the robustness of plasma initiation during the ITER pre-fusion operation phase. Studies were performed at JET at ITER relevant loop electric field, E-loop ? 0.33 Vm(-1), and a range o ...

IOP Publishing Ltd2023