Publications associées à Radiateur (moteur thermique)

Flash Melting Amorphous Ice

Marcel Drabbels, Ulrich Lorenz, Constantin Richard Krüger, Gabriele Bongiovanni, Nathan Junior Mowry

Water can be vitrified if it is cooled at high rates, which makes it possible to outrun crystallization in so-called no man’s land, a range of deeply supercooled temperatures where water crystallizes rapidly. Here, we study the reverse process in pure wate ...

2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Ion Spectroscopy Reveals Structural Difference for Proteins Microhydrated by Retention and Condensation of Water

Oleg Boyarkine, Andrei Zviagin

Protein ubiquitin in its +7 charge state microhydrated by 5 and 10 water molecules has been interrogated in the gas phase by cold ion UV/IR spectroscopy. The complexes were formed either by condensing water onto the unfolded bare proteins in a temperature- ...

Amer Chemical Soc2024

Salt Bridge Structure of Microhydrated Arginine Kinetically Trapped in the Gas Phase by Evaporative Cooling

Oleg Boyarkine, Andrei Zviagin

Aminoacids and peptides generally exhibit zwitterionic forms withsalt bridge (SB) structures in solution but charge-solvated (CS) motifsin the gas phase. Here, we report a study of non-covalent complexesof the protonated amino acid arginine, ArgH(+)(H2O)( ...

2023

Advancing efficiency and reliability in thermal analysis of laser powder-bed fusion

Christian Leinenbach, Rafal Wróbel, Thomas Mayer

In laser based powder-bed fusion of metals (PBF-LB/M), parts are fabricated by melting layers of powder using a high-intensity laser beam. During this process, the material is exposed to rapid cooling rates and intense thermal gradients, which are the unde ...

2023

Radiation-tolerant Multichannel Dew Point Temperature Monitoring System for High Energy Physics Applications

Amar Kapic

The next generation of high-energy physics (HEP) detectors will predominantly be silicon-based. As pixel sensor technology gains momentum and the number of channels surpasses one billion (for a volume of approximately 20 m3) to achieve the high resolution ...

EPFL2023

Efficacy of temporal and spatial abstraction for training accurate machine learning models: A case study in smart thermostats

Rachid Guerraoui, Alexandre David Olivier Maurer, Omid Ardakanian

Smart thermostats are increasingly popular in homes and buildings as they improve occupant comfort, lower energy use in heating and cooling systems, and reduce utility bills by automatically adjusting room temperature according to measurements of their bui ...

ELSEVIER SCIENCE SA2023

Bridging Native and Intrinsic Structures of Microhydrated Biomolecules by Cold Ion Spectroscopy

Andrei Zviagin

Solving native structures of such large molecules, like biomolecules, is often challenging, particularly due to the potentially infinite number of non-covalent interactions with water. In this thesis, we report the use of cold ion gas-phase action spectros ...

EPFL2023

Design and management of three-dimensional multi-processor systems-on-chip with integrated flow cell arrays

Halima Najibi

Three-Dimensional Multi-Processor Systems-on-Chip (3D MPSoCs) are promising solutions for highly intensive Artificial Intelligence (AI) and Big Data applications. They combine remarkably dense computation capabilities and massive communication bandwidths. ...

EPFL2022

Conductive Heat Transfer in Partially Saturated Gas Diffusion Layers with Evaporative Cooling

Sophia Haussener, Felix N. Büchi, Mirco Magnini

Heat transport is an important, though often neglected function of gas diffusion layers (GDLs) of polymer electrolyte membrane fuel cells. Thermal conductivity is a key property, especially in partially water saturated GDLs and when the phase change of wat ...

2022

How to improve the efficiency of a traditional dissolution dynamic nuclear polarization (dDNP) apparatus: Design and performance of a fluid path compatible dDNP/LOD-ESR probe

Andrea Capozzi, Jean-Noël Hyacinthe, Thanh Phong Kevin Lê

Dissolution Dynamic Nuclear Polarization (dDNP) was invented almost twenty years ago. Ever since, hardware advancement has observed 2 trends: the quest for DNP at higher field and, more recently, the development of cryogen free polarizers. Despite the DNP ...

Academic Press Inc - Elsevier Science2022

Convective regimes induced by surface cooling and topography in stratified waterbodies

Damien Bouffard, Tomy Doda, Hugo Nicolás Ulloa Sánchez, Cintia Luz Ramon Casanas

Gravitational convection plays a significant role in the ventilation, heat and mass distribution of aquatic systems. This study investigates thermally driven convection resulting from heat loss at the air-water interface during cooling periods in freshwate ...

Iahr-Int Assoc Hydro-Environment Engineering Research2022

Near-junction microfluidic cooling for high power-density GaN-on-Si electronics: A wafer, device, packaging, and system-level investigation

Remco Franciscus Peter van Erp

Electrification of the energy section, from generation to end-use, plays an essential role in reducing global CO2 emission. Innovations in power electronics are required to increase conversion efficiency and power density. Gallium nitride (GaN) transistors ...

EPFL2022

Seasonality of density currents induced by differential cooling

Alfred Johny Wüest, Damien Bouffard, Hugo Nicolás Ulloa Sánchez, Tomy Doda

When lakes experience surface cooling, the shallow littoral region cools faster than the deep pelagic waters. The lateral density gradient resulting from this differential cooling can trigger a cold downslope density current that intrudes at the base of th ...

2022

80 K cryogenic stage for ice lithography

Danick Briand, Rubaiyet Iftekharul Haque, Jaemin Kim

We present a cryogenic system design and development for ice lithography. The cryo-stage is designed with embedded channels to allow direct liquid nitrogen flow, enabling fast cryogenic cooling, and low sample temperature. The stage cools down to 78.8 K in ...

ELSEVIER2022

Two novel cogeneration charging stations for electric vehicles: Energy, exergy, economic, environment, and dynamic characterizations

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

This paper suggests two novel designs for the electric vehicle charging stations using LiMn2O4 Lithium-ion battery and based on a Solid Oxide Fuel Cell (SOFC) and absorption refrigeration cycle (ARC) technologies to provide electricity and cooling, respect ...

Elsevier2022

Flushing the Lake Littoral Region: The Interaction of Differential Cooling and Mild Winds

Damien Bouffard, Hugo Nicolás Ulloa Sánchez, Tomy Doda, Cintia Luz Ramon Casanas

The interaction of a uniform cooling rate at the lake surface with sloping bathymetry efficiently drives cross-shore water exchanges between the shallow littoral and deep interior regions. The faster cooling rate of the shallows results in the formation of ...

AMER GEOPHYSICAL UNION2022

Development of High-Strength Aluminum Alloys for Additive Manufacturing

Marvin Lennard Schuster

Metal additive manufacturing (AM) offers the possibility to rapidly produce complex geometries that are not achievable with conventional manufacturing methods. The two most common technologies, Laser Powder Bed Fusion (LPBF) and Direct Metal Deposition (DM ...

EPFL2022

Local heating and cooling effectiveness - an evaluation method based on calculated local and overall thermal state

Dolaana Khovalyg, Mohamad Rida

The application of Personal Comfort Systems (PCS) in the buildings demonstrated their potential to improve thermal comfort and reduce energy use by the space conditioning HVAC systems. With its personal controllability (on-demand) PCS is a practical soluti ...

TU Delft2022

Operational Map And Thermal Performance Of A Thermosyphon Cooling System For Compact Servers

John Richard Thome, Jackson Braz Marcinichen, Filippo Cataldo, Raffaele Luca Amalfi

This paper advances the state-of-the-art in novel passive two-phase systems for more efficient cooling of datacenters and telecom central offices compared to the traditional air-based cooling solutions (e.g. aisle-based containment systems). The proposed p ...

AMER SOC MECHANICAL ENGINEERS2021