Publications associées à Ceramic resonator

Ultrahigh-quality-factor micro- and nanomechanical resonators using dissipation dilution

Tobias Kippenberg, Alberto Beccari, Nils Johan Engelsen

Mechanical resonators are widely used in sensors, transducers and optomechanical systems, where mechanical dissipation sets the ultimate limit to performance. Over the past 15 years, the quality factors in strained mechanical resonators have increased by f ...

Nature Portfolio2024

Toward Band n78 Shear Bulk Acoustic Resonators Using Crystalline Y-Cut Lithium Niobate Films With Spurious Suppression

Luis Guillermo Villanueva Torrijo, Soumya Yandrapalli, Victor Plessky

This work presents the study of suspended Y-cut Lithium Niobate shear bulk acoustic resonators for wide band filter applications in the frequency range of 3.5-4.5GHz. The resonators consist of a Lithium Niobate film with Aluminum top interdigitated electro ...

Institute of Electrical and Electronics Engineers2023

Nanomechanical resonators with low dissipation for quantum optomechanics

Alberto Beccari

Fields of technology as diverse as microwave filter construction, characterization of material interfaces with atomic precision, and detection of gravitational waves from astronomical sources employ mechanical resonators at their core. The utility of mecha ...

EPFL2023

Development of Thin Film Lithium Niobate Shear Bulk Acoustic Wave Resonators

Soumya Yandrapalli

RF MEMS piezoelectric acoustic resonators are the essential building blocks for RF filters used in RF front-end modules for wireless mobile communication due to their compact size in the MHz-GHz frequency range, high Quality factors and large relative band ...

EPFL2022

Ultra low quantum decoherence nano-optomechanical systems

Mohammadjafar Bereyhi

Thermal motion of a room-temperature mechanical resonator typically dominates the quantum backaction of its position measurement. This is a longstanding barrier for exploring cavity optomechanics at room temperature. In order to enter the quantum regime of ...

EPFL2022

Development of Lamb wave resonators in thin film X-cut lithium niobate

Muhammad Faizan

Microelectromechanical systems (MEMS) is among the most revolutionary technologies of 21st century, with the applications ranging from industrial systems to consumer electronics. Using MEMS in battery-powered wireless devices has long been seen as the evol ...

EPFL2021

Subwavelength Metawaveguide Filters and Metaports

Romain Christophe Rémy Fleury, Maliheh Khatibi Moghaddam

This paper proposes an alternative technique for the design of miniaturized waveguide filters based on locally resonant metamaterials (LRMs). We implement ultrasmall metamaterial filters (metafilters) by exploiting a subwavelength (sub-λ) guiding mechanism ...

American Physical Society (APS)2021

Towards a N77 Electroacoustic Filter Using Thin Films of Crystalline Y-cut Lithium Niobate

Luis Guillermo Villanueva Torrijo, Soumya Yandrapalli, Victor Plessky

This paper presents the use of a novel type of resonators made of a thin membrane of Y-cut Lithium Niobate that has an array of interdigitated electrodes on the top, and a floating metal on the bottom. Each electrode gives rise to a quasi-independent reson ...

IEEE2021

Collective dynamics in nonlinear resonators coupled in spatial and synthetic dimensions

Tobias Kippenberg, Aleksandr Tusnin, Alexey Tikan

We theoretically investigate chaotic and stable structures in coupled-resonator chains and synthetic frequency dimension influenced by Kerr nonlinearity, thereby bringing insights in the emerging field of soliton generation in chains and lattices of high-Q ...

IEEE2021

Balancing of Coupled Piezoelectric NEMS Resonators

Luis Guillermo Villanueva Torrijo, Damien Maillard, Johannes Mathis Valentin Lemonde

Micro and Nano Electro Mechanical systems (M/NEMS) have a lot of potential to be used for sensing in different schemes and operation modes. We focus here on the use of coupled resonators for sensing and address the major limitation that these systems face, ...

FRONTIERS MEDIA SA2021

Evidence of Smaller 1/F Noise in AlScN-Based Oscillators Compared to AlN-Based Oscillators

Luis Guillermo Villanueva Torrijo, Marco Liffredo, Andrea Lozzi

In this paper we investigate the direct effect of resonator quality factor (Q) on the oscillator phase noise. We use 2-port contour mode resonators (CMRs), fabricated both with aluminum nitride (AlN) and aluminum scandium nitride (AlScN), as the frequency- ...

Institute of Electrical and Electronics Engineers2020

Mechanical resonators with high dissipation dilution in precision and quantum measurements

Sergey Fedorov

Position measurements of mechanical oscillators underpin experiments spanning from applied nanoscale sensing to endeavors aiming to resolve open fundamental problems of modern physics. Sufficiently precise position measurements are also used for engineerin ...

EPFL2021

AlN and AlScN contour mode resonators for MEMS-based RF front ends

Andrea Lozzi

Miniaturization is a simple yet very powerful concept. Applied to devices, it opens to plethora of new applications. Microelectromechanical systems (MEMS) are the result of scaling down the dimensions of devices to the micron range or the nano range (NEMS) ...

EPFL2019

Nonlinear piezoelectric vibration energy harvester with frequency-tuned impacting resonators for improving broadband performance at low frequencies

Nico de Rooij, Danick Briand, Andres Felipe Vasquez Quintero, Robert Andrew Lockhart

The paper reports on a nonlinear frequency up-converting vibration energy harvester with enhanced broadband performance below 50 Hz, which is attained by leveraging vibro-impact interaction between two high-frequency piezoelectric generators and two low-fr ...

IOP PUBLISHING LTD2019

Material Parameter Extraction for Complex AlScN Thin Film Using Dual Mode Resonators in Combination with Advanced Microstructural Analysis and Finite Element Modeling

Paul Muralt, Thomas La Grange, Silviu Cosmin Sandu, Mohammad Fazel Parsapour Kolour, Vladimir Pashchenko, Kaoru Yamashita

Accurate property determination of the piezoelectric thin film material Al(1-x)Sc(x)N is necessary for designing the next generation of radio frequency resonators in mobile communication, and for testing results of ab initio calculations. Sound velocity an ...

WILEY2019

Determination of elastic and piezoelectric properties of Al0.84Sc0.16N thin films

Paul Muralt, Mohammad Fazel Parsapour Kolour, Vladimir Pashchenko

In this work, bar- and disk-shaped resonators were fabricated using Al(0.8)4Sc(0.16)N thin film Sensitivity analysis of the resonators' resonance frequencies with respect to the piezoelectric material parameters revealed that resonance analysis can be used ...

IEEE2018

Micromechanical resonators with sub-micron gaps filled with high-k dielectrics

Mariazel de la Candelas Maqueda López

Scaled microelectromechanical (MEMS) resonating devices have generated a great interest for their use in RF front-end architectures for wireless communication, channel-select filters, on-chip signal processing and timing and extreme mas sensing application ...

EPFL2017

A concept of wireless and passive very-high temperature sensor

Paul Muralt, Ramin Matloub Aghdam, Andrea Mazzalai

There is a need for sensors capable operating at temperatures above 1000 degrees C. We describe an innovative sensor that might achieve this goal. The sensor comprises two main elements: a thermocouple and a surface acoustic wave (SAW) strain sensor. The c ...

Amer Inst Physics2017

Frequency fluctuations in silicon nanoresonators

Luis Guillermo Villanueva Torrijo, Eric Sage, Thomas Alava

Frequency stability is key to the performance of nanoresonators. This stability is thought to reach a limit with the resonator's ability to resolve thermally induced vibrations. Although measurements and predictions of resonator stability usually disregard ...

2016

Role of charged defects on the electrical and electromechanical properties of rhombohedral Pb(Zr,Ti)O3 with oxygen octahedra tilts

Dragan Damjanovic

Oxygen octahedra tilting is a common structural phenomenon in perovskites and has been subject of intensive studies, particularly in rhombohedral Pb(Zr,Ti)O3 (PZT). Early reports suggest that the tilted octahedra may strongly affect the domain switching be ...

Amer Physical Soc2016